IRIrvan

Irvan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Irvan has a total of 38 co-authors. Here are the top co-authors by number of shared publications:

  • B Trisakti

    Chemical Engineering Department, Universitas Sumatera Utara, Indonesia

    3 shared publications
  • Bambang Trisakti

    Univ Sumatera Utara, Chem Engn Dept, Medan 20155, Indonesia

    3 shared publications
  • R Sidabutar

    Department of Chemical Engineering, Faculty of Engineering, Universitas Sumatera Utara - Padang Bulan, Medan, Indonesia, 20155

    3 shared publications
  • E Munir

    Biology Department, Faculty of Mathematics and Natural Sciences, Universitas Sumatera Utara, Medan

    2 shared publications
  • Fatimah Batubara

    Department of Chemical Engineering, Universitas Sumatera Utara, Jalan Almamater Kampus USU, Medan, 20155, Indonesia

    2 shared publications
  • Hiroyuki Daimon

    Toyohashi Univ Technol, Dept Environm & Life Sci, Toyohashi, Aichi 4418580, Japan

    2 shared publications

Latest Publications

  • Open Access

    Economic analysis of biomass briquettes from septic tank

    by Irvan, M F Lubis, N Matondang, Y Nabilah

    The aim of this research is to utilize slack waste into charcoal briquettes as an environmentally friendly alternative energy and minimize slack waste. The process for making briquettes is by adding polyacrylamide type adhesives with a variation of the material: adhesive ratio of 5:2 and 2:1 respectively on the slack charcoal that has been crushed, then formed into a cylinder with a press tool with pressure 85 and 105 kg/cm2. Furthermore, drying is done in an oven with a temperature of 150°C with a variation of 1.5 and 2 hours drying time. From the results of the economic analysis it was found that the business of making stool briquettes with a capacity of 300 kg/day is feasible to run, where from the business a profit of Rp. 547,029,828/year where the Net Present Value (NPV), Internal Rate of Return (IRR), and Break Event Point (BEP) were Rp. 203,510,791; 21.59%; and 26.08% respectively which requires 24.41 tons of briquettes to be returned in capital in around 11.34 months with an income of Rp. 183,075,000.

  • Open Access

    Calculating steam requirement of preliminary heating I (PH I) from evaporation agency II (EA II) and preliminary heating II (PH II) from evaporation agency I (EA I) at sugar factory X

    by B Trisakti, B Haryanto, R Sidabutar, M Zikir, F D P Mardhiyani, Irvan

    In the production of white sugar, the evaporation process is carried out to thicken the runny sap into thick sap. An evaporator is a device used to concentrate a solution consisting of a volatile solvent and a non-volatile solute. Where in the juice solution, the water contained will be evaporated so that it becomes thick sap according to the Brix that has been determined. This paper discusses the refining process in sugar manufacturing plants, especially in the evaporator unit to calculate the steam requirements needed by each evaporator body to achieve the appropriate viscous juice brix. The larger the desired sap brix, the more steam is needed in the evaporator unit.

  • Open Access

    Comparison of mass balance and oil quality in plant refinery I and IV

    by Irvan, B Trisakti, R Sidabutar, Cw Situmeang, Fmr Siregar

    Refinery process is the process of refining crude palm oil (CPO) to remove Free Fatty Acid (FFA), odors, and reducing color, so that it meets the quality requirements. Fractionation is a process of separating triglycerides based on palm oil based on its melting point which aims to separate the solid fraction (stearin) and liquid fraction (olein). The fractionated oil comes from the refining process. The purpose of the mass balance comparison is to determine the quality and quantity of oil produced from the refinery and fractionation processes. The production capacity at the refinery plant I and IV were 1,700 and 1,800 respectively. The amount of refined bleached and deodorized palm oil (RBDPO) produced based on the mass balance calculation at plant I and IV were 73,597 and 77,377 kg/h respectively with criteria were free of impurities and FFA.


  • Open Access

    Implementation of zero waste concept in waste management of Banda Aceh City

    by M Nizar, E Munir, E Munawar, Irvan

    This study aims to find out how far the implementation of the concept of Zero Waste in waste management in Banda Aceh City. The problem of increasingly complex garbage due to the increasing amount of waste along with population growth. During this time generally waste is transported and disposed to the Final Processing Place (TPA) so that all garbage piled up in the landfill. Most of the waste handling is done after the garbage appears so it is difficult to manage it. Handling of garbage from scratch is still minimal so the TPA becomes full fast. The concept of Zero Waste is to minimize waste generation so that less waste is wasted to the landfill. This is so as not to waste resources and prevent environmental damage. Handling of waste from the beginning of waste avoidance, waste sorting, producer responsibility, waste levies according to the amount of disposal, waste management by the community and the provision of incentives and disincentives is the implementation parameter of Zero Waste. This concept should be integrated into local policy so it becomes an obligation for the government and the community to implement it. A number of cities around the world have implemented Zero Waste policies and set a target to reduce waste disposal to TPA as small as possible. Banda Aceh as a medium-sized city in Indonesia has integrated a number of Zero Waste concepts in its local regulations. Some of these concepts are difficult to implement due to a number of socio-political factors.


  • Open Access

    Automation of temperature sensor in biogas production from palm oil mill effluent (POME)

    by Irvan, T Husaini, E Simanungkalit, R Sidabutar, B Trisakti

    The purpose of this research is to obtain the monitoring system and temperature data recording a system based on National Instruments USB-6001 and to obtain a Human Machine Interface (HMI) which is suitable for monitoring the temperature process of the conversion POME into biogas on a laboratory scale using LabVIEW software. This study was conducted by two stages, hardware design and software design. In hardware design, a stirred tank and a PC were connected to the microcontroller hardware National Instruments USB-6001. The software design was consisted of the LabVIEW programming. The results indicated that the components were suitable for the monitoring process of the conversion POME were the National Instrument USB - 6001, series TC module to DC and 5 volt power source, as well as a temperature sensor used is a thermocouple type K. For HMI design using LabVIEW 2014 was in accordance with the needs with the graphic display of temperature conditions in real time from a stirred tank and the data logger was automatically stored in the Microsoft Excel. After completion of the design of HMI, thermocouple that is used is calibrated to obtained a linear equations of analog data versus temperature data from a digital thermometer so that the equation to be inputted into the program LabVIEW block diagram which was y = 0.0064x + 0.2217 with R2 value was 0.993. Afterward, the research was continued using a set point 55 ° C with a variation of hysteresis 1, 3, and 5°C. Data was obtained from this study then to be calculated the standard error values to compare the data generated from every variation of hysteresis. The results indicated that the best data on research was the data obtained using hysteresis 1°C from the set point temperature compared with the data on the hysteresis 3 and 5°C.


  • Open Access

    The integrating of zero waste principles from national to local regulations: Case study of Banda Aceh, Indonesia

    by M Nizar, E Munir, Irvan, V Waller

    Garbage disposal to landfill is a waste of limited natural resources. The concept of upstream waste management to minimize waste dumped into a landfill is called Zero Waste. A number of cities in the world have successfully applied this concept and have demonstrated that it can save the limited natural resources. The application of the concept of Zero Waste needs a proper policy. Both Indonesia and the city of Banda Aceh have waste management policies which contain Zero Waste principles. In this paper, we argue that the city regulation is more detailed compared to the national regulation which could result in better waste management in terms of waste reduction. These include waste separation and avoidance, extended producer responsibility, pay as you throw scheme, community recycling centers and the provision of incentives and disincentives. The purpose of this paper is to examine how Zero Waste principles have been integrated into the policies at the national and Banda Aceh levels. The researchers conducted in-depth interviews with waste experts including academics, government officers, and waste activists, as well as regulations reviews. This paper recommended that Banda Aceh develop more regulations incorporating Zero Waste principles.


  • Open Access

    Acclimatization Process on Hybrid Upflow Anaerobic Sludge Blanket Reactor (HUASBR) using Bioball as Growth Media with OLR Variation for Treating Tofu Wastewater

    by Nyimas Yanqoritha, Muhammad Turmuzi, Irvan Irvan, Fatimah Batubara, Ilmi Ilmi, Irvan, Ilmi

    Wastewater of tofu industry contains very high organic content, then anaerobic process is the most suitable for degrading this liquid waste. The hybrid upflow anaerobic sludge blanket reactor (HUASBR) was applied in this study because it has the advantage in ensuring good contact between biomass and substrate where a suspension medium and anaerobic filter are able to withstand more biomass in the attached media. Processing Anaerobic process is carried out with the help of bacteria where bacteria need seeding and acclimatization. Acclimatization is the process of adaptation of microorganisms to wastewater to be treated. This adaptation process is carried out by adding waste water from the smallest concentration to the actual concentration. The purpose of this study is to determine the effect of variations in organic load rate (OLR) on the acclimatization process in removing COD, biogas production in accordance with the pH of the anaerobic degradation process so that the optimal process of the acclimatization process can be obtained. In this study, the acclimatization process took 200 days with variation of OLR in the range of 1.5 - 5.9 kg COD m-3 d-1 at HRT 24 hours and flow rate up (Vup) of 0.08 m/h. The objective of OLR variation was to evaluate acclimatization process on the HUASBR performance during process optimization. The highest biogas production and removal efficiency of COD were achieved in pH range of 6.5 - 7.6. While, the highest COD removal efficiency obtained was 86.57% on the 140th day and biogas production 7700 ml for OLR 4.8 kg COD m-3d-1 at HRT 24 h. Consequently, the optimum OLR for treating the tofu wastewater could be achieved up to 4.8 kg COD m-3d-1 and HRT 24h.


  • Open Access

    The Minimum Requirements for Nickel and Cobalt as Trace Metals in Thermophilic Biogas Fermentation of Palm Oil Mill Effluents

    by Bambang Trisakti, Fatimah Batubara, Hiroyuki Daimon, Irvan

    Oriental Journal of Chemistry is a peer reviewed quarterly research journal of pure and applied chemistry. It publishes standard research papers in almost all thrust areas of current chemistry of academic and commercial importance. It provides a platform for rapid publication of quality research papers, reviews and chemistry letters. Oriental Journal of Chemistry is abstracted and indexed in almost all reputed National and International agencies.


  • Open Access

    Processing of palm oil mill wastes based on zero waste technology

    by Irvan

    Indonesia is currently the main producer of palm oil in the world with a total production reached 33.5 million tons per year. In the processing of fresh fruit bunches (FFB) besides producing palm oil and kernel oil, palm oil mills also produce liquid and solid wastes. The increase of palm oil production will be followed by an increase in the production of waste generated. It will give rise to major environmental issues especially the discharge of liquid waste to the rivers, the emission of methane from digestion pond and the incineration of empty fruit bunches (EFB). This paper describes a zero waste technology in processing palm oil mill waste after the milling process. The technology involves fermentation of palm oil mill effluent (POME) to biogas by using continuous stirred tank reactor (CSTR) in the presence of thermophilic microbes, producing activated liquid organic fertilizer (ALOF) from discharge of treated waste effluent from biogas digester, composting EFB by spraying ALOF on the EFB in the composter, and producing pellet or biochar from EFB by pyrolysis process. This concept can be considered as a promising technology for palm oil mills with the main objective of eliminating the effluent from their mills.