AIAbdulbariu Ibrahim

Abdulbariu Ibrahim

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Abdulbariu Ibrahim has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Comparative Analysis of Aquifer Properties in Selected Geologic Terrain in Nigeria

    by Ibrahim O Ibrahim, Adekunle Rahman Rasaq, Ibrahim Kehinde Olojoku, Ibrahim Bilqees Damilola Habeeb, Abdulbariu Ibrahim

    Aim of the Study: Two main geologic terrains of basement complex and sedimentary areas were investigated for underground water production capacity by evaluating the aquifer properties. The assessment was done by evaluating 19 boreholes in the two terrains. TK1-TK10 constituted the boreholes from basement area, while AK1-9 constituted boreholes of sedimentary terrain. Methodology: Pumping rate of the boreholes were crucial to establish the water production capacity from the geologic terrains. Dipper, stopwatch, graduated plastic container, 1 h.p submersible pump, 5.5 KVA generator and field notebook were materials used to collect the field data. Suitable measuring datum of 0.5 m was taken from the ground level for all measurements. SWL was taken and stopwatch was on simultaneously, just as pumping exercise began. The discharge rate was measured then recovery period monitored as pumping stopped. Findings: Findings of the study revealed Akerebiata sedimentary wells have SWL with 2.8-5.9m, DWL recorded 18.1-28.2m, yield varied between 0.49-0.93L/sec, RDD was measured to be 0.01-0.09m. Specific capacity was calculated to be 42.33-80.35m3/day/m while DWS recorded 0.1-0.2m. Conversely, Tanke wells were pump tested and revealed SWL varied between 6.1 and 8.9m, DWL recorded 48.2-96.2m, yield varied between 0.51-0.72L/sec, RDD was measured to be 0.09-0.18m. Specific capacity was calculated and range from 44.06 to 61.34m3/day/m. DWS recorded for Tanke wells ranges from 0.1 to 0.3m. Conclusion: The study concluded that the Akerebiata wells are having the potential to produce more underground water than their counterpart i.e. Tanke wells. Recommendation of 0.8-1.3 meters as DWS in the sedimentary terrain and 0.6-1.0 meters in basement complex terrain will allow such wells to last minimum of 10 years before a new well development can be initiated for removal of impurities.


  • Open Access

    Integrated Approach for the Assessment of Ihale Damsite for Reservoir Water Storage, Kogi, Nigeria

    by O. Ibrahim Ibrahim, Yusuf Mumeen Adebayo, Abdulbario Ibrahim

    Aim of the Study: Ihale damsite was evaluated for the purpose of constructing a dam for water storage and irrigation of farmland in the area. Methodology: The location of the proposed dam axis lies on the Universal Transverse Mercator (UTM) coordinates 187872mE, 916118mN and 187634mE, 915603mN and to harness river Afun which is about 2.5km to Kabba-Bunu area. 10 trial/test pits for soil sampling and 2 deep borings into the basement rock were conducted on both sides of the river channel and DCP were conducted to the point of refusal. The number of blows per 10cm for the overburden soils ranges from 1 to 50 between depths of 0 – 2.0meters. DCP test involved driving a solid cone of 600 into the ground, using repeated blows of a hammer with a fixed mass of 10Kg falling through a distance of 550mm having maximum diameter of 20mm. Findings & Conclusion: Findings revealed Clayey top soil, laterite, weathered basement and fresh basement rocks were the main geologic material obtained from the area with 4 geo-electric layers recorded. Resistivity values along the dam axis ranges from 29.1 to 2857.6 Ωm which is the third layer of VES 1 and 7. This layer was inferred to be weathered basement rock. In essence; placing the dam structure on the fourth layer of fresh basement rock will be more desirable to minimize seepages and enhance the foundational footing of the structure. Geotechnical analysis revealed bulk density varied from 1320 to 2830 kg/m2. Specific Gravity ranges from 2.56 to 2.76 Ga. Natural moisture content Nmc varied between 1.73 and 24.49 % with optimum dry density and dry density desirable for the support of dam construction in the area. Unit Cone Resistance (KN/m2) that varies from 95 to 520 KN/m2 across the depths is desirable to support the dam area structure. Average DCP Bearing Capacity increased from 120 to 500 as depth of investigation increased from 0.5 to 2.0 m. The integrated approach has revealed the Ihale damsite is good for dam construction.

  • Open Access

    Review of the occurrence and structural controls of Baryte resources of Nigeria

    by N A Labe, P O Ogunleye, A A Ibrahim, T Fajulugbe, S T Gbadema

    Baryte occurrences in Nigeria are spread across the Cretaceous Benue Trough which comprises of carbonaceous shales, limestone, siltstones, sandstones as well as in the northeastern, northwestern and southeastern parts of the Precambrian Basement Complex comprising of metasediments and granitoids. The mineralization is structurally controlled by NW-SE, N-S and NE-SW fractures. The common mode of occurrence for these barytes is the vein and cavity deposits type usually associated with galena, sphalerite, copper sulphide, fluorite, quartz, iron oxide as gangue minerals. Principal areas of baryte occurrences in Nigeria include Nassarawa, Plateau, Taraba, Benue, Adamawa, Cross River, Gombe, Ebonyi, and Zamfara. A large part of the vast baryte resources in Nigeria is still underexploited and further exploration work is needed to boost its exploitation. The inferred resource and proven reserve of baryte is put at over 21,000,000 and about 11,000,000 metric tons respectively. The economic evaluation of these barytes is viable having low (SG = < 3.5) to high (SG = 5.3) grades. The presence of associated minerals produces low quality barytes and as such blending and beneficiation is required to improve its quality.