Fanzhao Meng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Fanzhao Meng has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Duosi Fan
School of Astronautics, Beihang University 1 , Beijing 100191
2 shared publications - Lijun Yang
Beihang University
2 shared publications - Wang Han
Beihang University
2 shared publications - Changzhao Xu
Department of Gastroenterology Surgery, Yichang Central People’s Hospital, The First College of Clinical Medical Science, China Three Gorges University, 443000 Yichang, Hubei, China
1 shared publication Cuicui Wei
College of Mechanical Engineering, Shandong Huayu University of Technology, Dezhou, Shandong, 253034, China
1 shared publicationLixiang Mao
College of Mechanical Engineering, Shandong Huayu University of Technology, Dezhou, Shandong, 253034, China
1 shared publication
Latest Publications
- 1 October 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (10)
Turbulent/non-turbulent interface in hypersonic boundary layers
The turbulent/non-turbulent interface (TNTI) plays a critical role in turbulent entrainment. While substantial progress has been achieved in understanding TNTI and entrainment in low Mach number flows, little attention is paid to TNTI and entrainment in hypersonic flows, especially in hypersonic boundary layers. To this end, direct numerical simulation of hypersonic boundary layers has been performed to investigate the impact of shock waves on TNTI and turbulent entrainment by comparing two cases with and without the shock wave/boundary layer interactions (SBLI). A novel approach, combining vorticity threshold and fuzzy clustering techniques with local normalization by boundary-layer thickness and friction velocity, is developed to improve TNTI detection by reducing shock-induced artifacts. Results show that SBLI significantly reduces TNTI thickness, intensifies enstrophy generation and dissipation, and alters the relative contributions of dominant transport terms. Analysis of entrainment mechanisms reveals that shock waves moderately enhance small-scale nibbling while weakening its dependence on interface curvature, but predominantly amplify large-scale engulfment, which accounts for over 90% of total entrainment mass flux under SBLI conditions. These findings provide new insights into TNTI structure and entrainment dynamics in hypersonic boundary layers subject to strong shock–turbulence interactions.
- 1 October 2025
- Published by AIP Publishing in Physics of Fluids
- Vol. 37 (10)
Turbulent/non-turbulent interface in hypersonic boundary layers
The turbulent/non-turbulent interface (TNTI) plays a critical role in turbulent entrainment. While substantial progress has been achieved in understanding TNTI and entrainment in low Mach number flows, little attention is paid to TNTI and entrainment in hypersonic flows, especially in hypersonic boundary layers. To this end, direct numerical simulation of hypersonic boundary layers has been performed to investigate the impact of shock waves on TNTI and turbulent entrainment by comparing two cases with and without the shock wave/boundary layer interactions (SBLI). A novel approach, combining vorticity threshold and fuzzy clustering techniques with local normalization by boundary-layer thickness and friction velocity, is developed to improve TNTI detection by reducing shock-induced artifacts. Results show that SBLI significantly reduces TNTI thickness, intensifies enstrophy generation and dissipation, and alters the relative contributions of dominant transport terms. Analysis of entrainment mechanisms reveals that shock waves moderately enhance small-scale nibbling while weakening its dependence on interface curvature, but predominantly amplify large-scale engulfment, which accounts for over 90% of total entrainment mass flux under SBLI conditions. These findings provide new insights into TNTI structure and entrainment dynamics in hypersonic boundary layers subject to strong shock–turbulence interactions.
- 1 December 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (12)
Efficient simulations of shock-induced ignition in turbulent flows with a hybrid scheme
This study presents efficient simulations of shock-induced ignition in turbulent flows using a hybrid fifth-order weighted essentially non-oscillatory (WENO5) and sixth-order central difference (CD6) scheme (WENO5-CD6), coupled with a novel semi-coupled fourth-order Runge–Kutta (SC-RK4) integrator. The hybrid WENO5-CD6 scheme ensures efficient and accurate capture of both shock waves and broadband turbulent structures by employing sensors to adaptively combine CD6 for smooth regions and WENO5 for discontinuities. The SC-RK4 integrator addresses the challenges of stiff chemical reactions, outperforming traditional Strang splitting methods in near-limit combustion phenomena. The proposed methods are validated against homogeneous reactor and one-dimensional shock-induced ignition benchmarks, showing improved accuracy and efficiency. Simulations of reactive homogeneous isotropic turbulence reveal that increasing turbulent Mach numbers shortens ignition delay due to the pressure-gain effect induced by shocklets. In shock–turbulence interaction cases, the combustion regime transitions from partially to fully premixed flames, with autoignition and flame propagation modes coexisting before transitioning into a broken reaction zone dominated by distributed premixed flame elements. The results highlight the effectiveness of the WENO5-CD6 scheme in reducing computational cost while maintaining accuracy. Moreover, these findings provide insights into the effects of compressible turbulence on ignition delay and reaction wave propagation.
- 1 December 2024
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (12)
Efficient simulations of shock-induced ignition in turbulent flows with a hybrid scheme
This study presents efficient simulations of shock-induced ignition in turbulent flows using a hybrid fifth-order weighted essentially non-oscillatory (WENO5) and sixth-order central difference (CD6) scheme (WENO5-CD6), coupled with a novel semi-coupled fourth-order Runge–Kutta (SC-RK4) integrator. The hybrid WENO5-CD6 scheme ensures efficient and accurate capture of both shock waves and broadband turbulent structures by employing sensors to adaptively combine CD6 for smooth regions and WENO5 for discontinuities. The SC-RK4 integrator addresses the challenges of stiff chemical reactions, outperforming traditional Strang splitting methods in near-limit combustion phenomena. The proposed methods are validated against homogeneous reactor and one-dimensional shock-induced ignition benchmarks, showing improved accuracy and efficiency. Simulations of reactive homogeneous isotropic turbulence reveal that increasing turbulent Mach numbers shortens ignition delay due to the pressure-gain effect induced by shocklets. In shock–turbulence interaction cases, the combustion regime transitions from partially to fully premixed flames, with autoignition and flame propagation modes coexisting before transitioning into a broken reaction zone dominated by distributed premixed flame elements. The results highlight the effectiveness of the WENO5-CD6 scheme in reducing computational cost while maintaining accuracy. Moreover, these findings provide insights into the effects of compressible turbulence on ignition delay and reaction wave propagation.
- Open Access
- 28 April 2023
- Published by EDP Sciences in SHS Web of Conferences
- Vol. 163, 02028
A Brief discussion on the standardized management of material master data in Enterprise Resource Planning system for engineering enterprises
Taking the Enterprise Resource Planning system of a loader enterprise as an example, this paper expounds on the principle of master material data coding, the existing problems in the standardization process of master material data and the measures taken.
- 28 April 2023
- Published by EDP Sciences in SHS Web of Conferences
- Vol. 163, 02028
Open AccessA Brief discussion on the standardized management of material master data in Enterprise Resource Planning system for engineering enterprises
Taking the Enterprise Resource Planning system of a loader enterprise as an example, this paper expounds on the principle of master material data coding, the existing problems in the standardization process of master material data and the measures taken.