Jakub Mikuláštík
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jakub Mikuláštík has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Aleš Růžička
Department of General and Inorganic Chemistry, University of Pardubice, Studentská 573, CZ 532 10 Pardubice, Czech Republic
1 shared publication - David Sýkora
Department of Analytical Chemistry, University of Chemistry and Technology Prague, Prague, Czech Republic
1 shared publication - Irina A. Kühne
Division of Condensed Matter Physics, FZU-Institute of Physics of the Czech Academy of Sciences, Na Slovance 1999/2, 182 00, Prague, Czech Republic
1 shared publication - Jan Vlček
Department of Physics and Measurements, University of Chemistry and Technology Prague, Technicka 5, 16628 Prague, Czech Republic
1 shared publication - Jaroslav Otta
Department of Physics and Measurements, Faculty of Chemical Engineering, University of Chemistry and Technology Prague (UCT), 166 28 Prague, Czech Republic
1 shared publication - Maksim Andreevich Samsonov
Department of General and Inorganic Chemistry, Faculty of Chemical Technology, University of Pardubice, Studentská 573, Pardubice 532 10, Czech Republic
1 shared publication
Latest Publications
- Open Access
- 1 May 2026
- Published by KEAI Publishing in Defence Technology
Aging effects on HMTD: From sensitivity and performance loss to field detection
- 1 May 2026
- Published by KEAI Publishing in Defence Technology
Open AccessAging effects on HMTD: From sensitivity and performance loss to field detection
- Open Access
- 18 February 2026
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 65 (8) , 4420-4429
Safe Stockpiling of the MTX-1 Primary Explosive in Alkali or Alkaline Earth Metal Complexes and Coordination Polymers
The safe stockpiling of high-energy combustible and explosive materials is important for environmental and human population protection, particularly in mining and military areas. MTX-1 (2-(tetrazol-5-yl-diazenyl)guanidine) is used in percussion primer compositions that react rapidly with the hydroxides of alkali or alkaline earth metals to form complexes of diverse composition. These are insensitive to mechanical stimuli and to intense heat under high confinement. The most stable complexes were found to be those with ions having the smallest effective ion radii (Mg2+ and Ca2+), followed by Li+. These complexes form discrete mononuclear (Mg2+ and Ca2+) or dimeric (Li+) structures in the solid state. One-dimensional (1D) (Na+, Sr2+, and Ba2+), 2D (K+ and Rb+), and 3D (Cs+) coordination polymeric structures were found for the remaining complexes with larger ions. Detailed topological analysis of the electron density and quantitative estimation of π-π stacking interactions were performed. Complexes could be used for intense flame coloring in pyrotechnics. Upon thermal treatment of complexes over ∼200 °C, water is lost from the coordination sphere of the metal ion, which leads to materials that are slightly sensitive and rehydrate in moist air. Recovery of insoluble MTX-1 is possible when these complexes are treated with an aqueous acid.
- 18 February 2026
- Published by American Chemical Society (ACS) in Inorganic Chemistry
- Vol. 65 (8) , 4420-4429
Open AccessSafe Stockpiling of the MTX-1 Primary Explosive in Alkali or Alkaline Earth Metal Complexes and Coordination Polymers
The safe stockpiling of high-energy combustible and explosive materials is important for environmental and human population protection, particularly in mining and military areas. MTX-1 (2-(tetrazol-5-yl-diazenyl)guanidine) is used in percussion primer compositions that react rapidly with the hydroxides of alkali or alkaline earth metals to form complexes of diverse composition. These are insensitive to mechanical stimuli and to intense heat under high confinement. The most stable complexes were found to be those with ions having the smallest effective ion radii (Mg2+ and Ca2+), followed by Li+. These complexes form discrete mononuclear (Mg2+ and Ca2+) or dimeric (Li+) structures in the solid state. One-dimensional (1D) (Na+, Sr2+, and Ba2+), 2D (K+ and Rb+), and 3D (Cs+) coordination polymeric structures were found for the remaining complexes with larger ions. Detailed topological analysis of the electron density and quantitative estimation of π-π stacking interactions were performed. Complexes could be used for intense flame coloring in pyrotechnics. Upon thermal treatment of complexes over ∼200 °C, water is lost from the coordination sphere of the metal ion, which leads to materials that are slightly sensitive and rehydrate in moist air. Recovery of insoluble MTX-1 is possible when these complexes are treated with an aqueous acid.
- Open Access
- 23 December 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (1) , 1364-1372
Fullerene-Doped Poly(ionic liquids) as Small Molecular Gas Sensors─Control of Intermolecular Interactions
Here, we investigate the interactions between five representative gaseous analytes and two poly(ionic liquids) (PILs) based on the sulfopropyl acrylate polyanion in combination with the alkylphosphonium cations, P4,4,4,4 and P4,4,4,8, and their nanocomposites with fullerenes (C60, C70) to reveal the potential of PILs as sensitive layers for gas sensors. The gaseous analytes were chosen based on their molecular size (all of them containing two carbon atoms) and variation of functional groups: alcohol (ethanol), nitrile (acetonitrile), aldehyde (acetaldehyde), halogenated alkane (bromoethane), and carboxylic acid (acetic acid). The six variations of PILs-P4,4,4,4SPA (1), P4,4,4,4SPA + C60 (1 + C60), P4,4,4,4SPA + C70 (1 + C70), and P4,4,4,8SPA (2), P4,4,4,8SPA + C60 (2 + C60), P4,4,4,8SPA + C70 (2 + C70)-were characterized by UV-vis and Raman spectroscopy, and their interactions with each gaseous analyte were studied using electrochemical impedance spectroscopy. Exposure of all PIL samples to acetaldehyde, bromoethane, and ethanol leads to a decrease in the diffusion coefficient, while exposure to acetic acid reveals an increase. Fullerene-doping significantly enhances the response to the analyte. Semiempirical quantum mechanical xTB-GFN2 calculations revealed that hydrogen bonding and proton transfer events play an important role during the detection process.
- 23 December 2024
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 10 (1) , 1364-1372
Open AccessFullerene-Doped Poly(ionic liquids) as Small Molecular Gas Sensors─Control of Intermolecular Interactions
Here, we investigate the interactions between five representative gaseous analytes and two poly(ionic liquids) (PILs) based on the sulfopropyl acrylate polyanion in combination with the alkylphosphonium cations, P4,4,4,4 and P4,4,4,8, and their nanocomposites with fullerenes (C60, C70) to reveal the potential of PILs as sensitive layers for gas sensors. The gaseous analytes were chosen based on their molecular size (all of them containing two carbon atoms) and variation of functional groups: alcohol (ethanol), nitrile (acetonitrile), aldehyde (acetaldehyde), halogenated alkane (bromoethane), and carboxylic acid (acetic acid). The six variations of PILs-P4,4,4,4SPA (1), P4,4,4,4SPA + C60 (1 + C60), P4,4,4,4SPA + C70 (1 + C70), and P4,4,4,8SPA (2), P4,4,4,8SPA + C60 (2 + C60), P4,4,4,8SPA + C70 (2 + C70)-were characterized by UV-vis and Raman spectroscopy, and their interactions with each gaseous analyte were studied using electrochemical impedance spectroscopy. Exposure of all PIL samples to acetaldehyde, bromoethane, and ethanol leads to a decrease in the diffusion coefficient, while exposure to acetic acid reveals an increase. Fullerene-doping significantly enhances the response to the analyte. Semiempirical quantum mechanical xTB-GFN2 calculations revealed that hydrogen bonding and proton transfer events play an important role during the detection process.