Girmaye Ambissa Begaw
Research Subjects
Girmaye Ambissa Begaw has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Ababay Ketema Worku
Bahir Dar University
2 shared publications - Delele Worku Ayele
Bahir Dar Energy Center, Bahir Dar Institute of Technology, Bahir Dar University, Bahir Dar, Ethiopia
2 shared publications - Temesgen Atnafu Yemata
Department of Chemical Engineering, Bahir Dar Institute of Technology, Bahir Dar University, P.O. Box 26, Bahir Dar, Ethiopia
2 shared publications - David Howe Wood
University of Calgary, Canada
1 shared publication - Eshetu Getahun
Bahir Dar Energy Center, Bahir Dar Institute of Technology, Bahir Dar University, Bahir Dar, Ethiopia
1 shared publication - Fantahun Aklog Yihun1 shared publication
Latest Publications
- Open Access
- 2 October 2026
- Published by Elsevier in SSRN Electronic Journal
Integrated Techno-Economic and Sensitivity Analysis of a 100 kWp Floating Solar Photovoltaic Systems at Lake Tana, Ethiopia
Floating photovoltaic (FPV) systems represent an emerging renewable energy technology that addresses land-use constraints while potentially improving photovoltaic performance through water-mediated cooling effects. This study presents a comprehensive techno-economic and sensitivity analysis of a 100-kWp-class floating solar photovoltaic system designed for Lake Tana, Ethiopia a tropical highland lake characterized by substantial solar resources and unique environmental considerations including numerous islands and surrounding riparian forests. The proposed system comprises 186 monocrystalline silicon modules rated at 540 W each, yielding an installed DC capacity of 100.44 kWp. Solar resource assessment is conducted using NASA POWER derived hourly solar and meteorological data, incorporating hourly solar irradiance, ambient temperature, and wind speed measurements for the Debre Mariam area of Lake Tana. System performance is modeled through analytical calculations validated against the National Renewable Energy Laboratory's System Advisor Model (SAM) framework. SAM simulations were conducted to predicts first-year AC energy generation of 216,683 kWh, corresponding to an energy yield of 2,154 kWh/kWp/year, a capacity factor of 24.6%, and a performance ratio of 78.0%. The 25-year economic analysis incorporates 0.5% annual PV degradation, operation and maintenance costs, component replacement schedules, and discounted cash flow methodology. The SAM-derived levelized cost of energy is 5.69 ¢/kWh ($0.0569/kWh) , which is highly competitive and lower than published FPV studies. Sensitivity analysis examines the impact of capital expenditure variations (±20%), discount rate fluctuations (6–10%), degradation rate scenarios (0.3–0.8%/year), and operation and maintenance cost assumptions (1.0–2.0% of CAPEX annually). The validation results demonstrate strong agreement between the analytical model and SAM, with a performance ratio difference of only 2.5% between the analytical assumption (80.0%) and SAM Run (78.0%). The findings contribute to the growing body of knowledge on FPV deployment in tropical developing regions and provide practical insights for sustainable energy planning in Ethiopia and similar contexts.
- 2 October 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessIntegrated Techno-Economic and Sensitivity Analysis of a 100 kWp Floating Solar Photovoltaic Systems at Lake Tana, Ethiopia
Floating photovoltaic (FPV) systems represent an emerging renewable energy technology that addresses land-use constraints while potentially improving photovoltaic performance through water-mediated cooling effects. This study presents a comprehensive techno-economic and sensitivity analysis of a 100-kWp-class floating solar photovoltaic system designed for Lake Tana, Ethiopia a tropical highland lake characterized by substantial solar resources and unique environmental considerations including numerous islands and surrounding riparian forests. The proposed system comprises 186 monocrystalline silicon modules rated at 540 W each, yielding an installed DC capacity of 100.44 kWp. Solar resource assessment is conducted using NASA POWER derived hourly solar and meteorological data, incorporating hourly solar irradiance, ambient temperature, and wind speed measurements for the Debre Mariam area of Lake Tana. System performance is modeled through analytical calculations validated against the National Renewable Energy Laboratory's System Advisor Model (SAM) framework. SAM simulations were conducted to predicts first-year AC energy generation of 216,683 kWh, corresponding to an energy yield of 2,154 kWh/kWp/year, a capacity factor of 24.6%, and a performance ratio of 78.0%. The 25-year economic analysis incorporates 0.5% annual PV degradation, operation and maintenance costs, component replacement schedules, and discounted cash flow methodology. The SAM-derived levelized cost of energy is 5.69 ¢/kWh ($0.0569/kWh) , which is highly competitive and lower than published FPV studies. Sensitivity analysis examines the impact of capital expenditure variations (±20%), discount rate fluctuations (6–10%), degradation rate scenarios (0.3–0.8%/year), and operation and maintenance cost assumptions (1.0–2.0% of CAPEX annually). The validation results demonstrate strong agreement between the analytical model and SAM, with a performance ratio difference of only 2.5% between the analytical assumption (80.0%) and SAM Run (78.0%). The findings contribute to the growing body of knowledge on FPV deployment in tropical developing regions and provide practical insights for sustainable energy planning in Ethiopia and similar contexts.
- Open Access
- 1 January 2026
- Published by Wiley in International Journal of Electrochemistry
- Vol. 2026 (1)
Enhanced Electrochemical Performance of Mn‐Doped Co 3 O 4 Nanostructures in Neutral Electrolyte
In response to the growing demand for sustainable energy storage, this study investigates the electrochemical behavior of manganese‐doped cobalt oxide (Mn‐doped Co 3 O 4 ) nanoparticles synthesized via a coprecipitation method. The effect of Mn doping on the electrochemical properties of Co 3 O 4 nanoparticles was evaluated using cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The Mn‐doped Co 3 O 4 sample exhibited a higher specific capacitance (375 F g −1 ) and lower charge‐transfer resistance than pristine Co 3 O 4 (330 F g −1 ), indicating enhanced electrochemical performance. These improvements are attributed to Mn‐induced structural modifications, including reduced crystallite size and increased lattice defects, as confirmed by structural characterization. The results demonstrate that Mn incorporation favorably influences the electrochemical behavior of Co 3 O 4 and highlight the potential of Mn‐doped Co 3 O 4 as a promising material for energy‐storage systems.
- 1 January 2026
- Published by Wiley in International Journal of Electrochemistry
- Vol. 2026 (1)
Open AccessEnhanced Electrochemical Performance of Mn‐Doped Co 3 O 4 Nanostructures in Neutral Electrolyte
In response to the growing demand for sustainable energy storage, this study investigates the electrochemical behavior of manganese‐doped cobalt oxide (Mn‐doped Co 3 O 4 ) nanoparticles synthesized via a coprecipitation method. The effect of Mn doping on the electrochemical properties of Co 3 O 4 nanoparticles was evaluated using cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). The Mn‐doped Co 3 O 4 sample exhibited a higher specific capacitance (375 F g −1 ) and lower charge‐transfer resistance than pristine Co 3 O 4 (330 F g −1 ), indicating enhanced electrochemical performance. These improvements are attributed to Mn‐induced structural modifications, including reduced crystallite size and increased lattice defects, as confirmed by structural characterization. The results demonstrate that Mn incorporation favorably influences the electrochemical behavior of Co 3 O 4 and highlight the potential of Mn‐doped Co 3 O 4 as a promising material for energy‐storage systems.
- Open Access
- 1 January 2024
- Published by Wiley in International Journal of Electrochemistry
- Vol. 2024 (1)
Enhancing Thermal Properties of Co3O4 Nanoparticles Through Optimized Mn‐Doping Concentrations
Herein, a facile co‐precipitation technique was employed to prepare cobalt oxide (Co3O4) and Co3O4 nanoparticles (NPs) with manganese (Mn) doping. The morphologies and crystalline structures of the as‐prepared NPs were characterized by X‐ray diffraction (XRD), Fourier‐transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), differential thermal analysis (DTA), thermogravimetric analysis (TGA), and Brunauer–Emmett–Teller (BET) techniques. XRD measurements showed that Co3O4 (19.42 nm) and Mn‐doped Co3O4 (14.02 nm) NPs were successfully synthesized on average, and they exhibit a face‐centered cubic crystalline structure. The SEM images also depicted the spherical morphology of Co3O4 NPs, with Mn particles clustering together. FTIR spectroscopy further confirmed the presence of Mn within the doped Co3O4 NPs. TGA/DTA analysis revealed boosted thermal stability in Mn‐doped Co3O4 NPs compared to Co3O4 NPs. Moreover, the BET surface areas of Co3O4 and Mn‐doped Co3O4 NPs were 534.013 and 712.741 m2/g, respectively, indicating an increase in surface area due to Mn doping. Consequently, Mn doping enhances both surface area and thermal stability, rendering Mn‐doped Co3O4 NPs desirable for nanomaterial applications. This study shows that modulating the Mn doping concentration in the Co3O4 NPs offers superior surface area and thermal stability compared to the prepared Co3O4 NPs.
- 1 January 2024
- Published by Wiley in International Journal of Electrochemistry
- Vol. 2024 (1)
Open AccessEnhancing Thermal Properties of Co3O4 Nanoparticles Through Optimized Mn‐Doping Concentrations
Herein, a facile co‐precipitation technique was employed to prepare cobalt oxide (Co3O4) and Co3O4 nanoparticles (NPs) with manganese (Mn) doping. The morphologies and crystalline structures of the as‐prepared NPs were characterized by X‐ray diffraction (XRD), Fourier‐transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), differential thermal analysis (DTA), thermogravimetric analysis (TGA), and Brunauer–Emmett–Teller (BET) techniques. XRD measurements showed that Co3O4 (19.42 nm) and Mn‐doped Co3O4 (14.02 nm) NPs were successfully synthesized on average, and they exhibit a face‐centered cubic crystalline structure. The SEM images also depicted the spherical morphology of Co3O4 NPs, with Mn particles clustering together. FTIR spectroscopy further confirmed the presence of Mn within the doped Co3O4 NPs. TGA/DTA analysis revealed boosted thermal stability in Mn‐doped Co3O4 NPs compared to Co3O4 NPs. Moreover, the BET surface areas of Co3O4 and Mn‐doped Co3O4 NPs were 534.013 and 712.741 m2/g, respectively, indicating an increase in surface area due to Mn doping. Consequently, Mn doping enhances both surface area and thermal stability, rendering Mn‐doped Co3O4 NPs desirable for nanomaterial applications. This study shows that modulating the Mn doping concentration in the Co3O4 NPs offers superior surface area and thermal stability compared to the prepared Co3O4 NPs.