Baolong Lin

Ice accretion on arctic vessels and offshore platforms poses serious threats to navigation and operational safety. Existing research has primarily focused on isolated structures. This study employs a combined approach of numerical simulation and experimental validation. It systematically investigates the icing characteristics of tandem twin-cylinders in wake flow fields. This configuration is common yet rarely studied in real marine environments. The model employs two identical cylinders arranged in tandem. It examines the effects of wind speed, distance, diameter, and wind direction angle on ice accretion morphology and distribution. Validation was conducted through wind tunnel tests at 5 m/s wind speed and 2.0 g/m³ liquid water content. Results demonstrate a significant shielding effect from the upstream cylinder wake. As wind speed increases, the ice mass difference between upstream and downstream cylinders widens. Ice mass shows a nonlinear relationship with distance. Minimum ice accretion on the downstream cylinder occurs at 350–450 mm distance. This results from wake pattern transition. The shielding effect exhibits strong nonlinear dependence on wind direction angle. A deviation of 8.2° increases total ice mass by 242.5%. Multivariable analysis confirms these nonlinear mechanisms persist under coupled distance–wind speed variations. This study provides the first systematic revelation of twin-cylinder icing mechanisms in wake flow fields. It offers a validated predictive tool for anti-icing design of arctic marine structures.

The impact-freezing phenomenon of supercooled saline droplets on cold surfaces poses a serious threat to the operational stability and structural integrity of offshore wind turbines. Compared to freshwater droplets, numerical models for analyzing the impact-freezing behavior of saline droplets typically involve complex physical mechanisms, resulting in high computational costs. This study employs a simplified two-dimensional axisymmetric numerical model that integrates the Volume of Fluid (VOF) method with the enthalpy–porosity approach, enabling rapid analysis of the saline droplet impact-freezing process under marine environmental conditions. The model is validated by comparing the spreading factor curve of saline droplets with a salinity of 35‰ against existing experimental data. Results show that the salinity corresponding to the peak relative deviation shifts with varying impact parameters, depending on the competition between impact dynamics and solidification. Furthermore, the maximum spreading factor decreases with increasing supercooling degree and contact angle but increases with higher Weber number. These findings provide useful correction parameters for improving existing droplet motion and icing prediction models.

To investigate the impact of frost-layer formation on the heat transfer characteristics of cryogenic valves in LNG vessels, this study derived the temporal variation in the valve’s temperature field based on the thermodynamic characteristic parameters of the low-temperature valve. Additionally, a frost formation model was developed for the drip tray. This considered the physical model characteristics of the tray, and the frost thickness was calculated for different times. The morphology of the calculated frost layer was coupled with the low-temperature valve model for heat transfer calculations to explore the influence of the frost layer on valve heat transfer characteristics. The results show that, in the initial stage of frost formation, the frost layer acts similarly to a finned heat sink, enhancing the thermal exchange efficiency at the surface of the drip tray, which results in a temperature increase in the drip tray and stuffing box compared to the frost-free condition. However, as the frost layer grows on the surface of the drip tray, the surface heat transfer resistance increases, gradually diminishing the enhancing effect of the frost layer on the heat dissipation of the drip tray. The results validate the dual role of the frost layer in the heat transfer process of low-temperature valves, providing important insights for the design and optimization of such valves.