Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ahmed Z. Ibrahim has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Steady‐State Fluorescence Evaluation of Apparent Levothyroxine–BSA Binding and Its Modulation by Ciprofloxacin, Alendronate, and Metal Ions

    by Enas T. Abdel‐Salam, Mostafa A. El Salam, Zeinab M. Anwar, Hend M. Mostafa, Ahmed Z. Ibrahim, Mostafa A. A. Mahmoud, Mohamed Abd El‐Magid

    Levothyroxine (LT4), a synthetic thyroid hormone used in the treatment of hypothyroidism, may interact with co‐administered drugs and metal ions, potentially influencing its distribution and bioavailability. In this study, steady‐state fluorescence spectroscopy was used to examine the interactions of bovine serum albumin (BSA) with LT4, ciprofloxacin, sodium alendronate, and selected metal ions (Fe 3+ , Al 3+ , and Ca 2+ ), both individually and in LT4‐containing systems. Fluorescence‐quenching and apparent binding parameters were evaluated using Stern–Volmer and reciprocal binding analyses. LT4 and ciprofloxacin exhibited moderate‐to‐strong apparent interactions with BSA, with K a ,app values of 2.73 × 10 5 and 2.94 × 10 5 M −1 , respectively, whereas sodium alendronate showed weaker association. Fe 3+ produced the strongest quenching response and the highest apparent binding parameter (2.92 × 10 8 M −1 ); this value was interpreted cautiously because strong quenching, hydrolysis, phosphate coordination, and ion‐speciation effects may contribute to the observed response. LT4 markedly attenuated the apparent Fe 3+ ‐ and Al 3+ ‐associated interactions, moderately reduced the ciprofloxacin response, modestly affected Ca 2+ , and produced little change in sodium alendronate association. Temperature‐controlled fluorescence measurements at 298.15, 303.15, and 308.15 K were used for three‐point Van't Hoff analysis, yielding apparent ΔG, ΔH, and ΔS values with unaltered fit statistics and regression‐only uncertainty estimates. Overall, the results reveal ligand‐dependent differences in BSA interaction and identify Fe 3+ and Al 3+ as the systems most strongly modulated by LT4 while supporting cautious physiological interpretation.

  • Metal‐Complex Extension of an Allylated Hydrazide/Thiosemicarbazide S4/S3 Ligand Pair: Donor‐Set Control of Spectral, Thermal, Antimicrobial, and MCF‐7 Screening Profiles

    by Sherin A. M. Ali, Heba S. Taher, Ahmed Z. Ibrahim, Mostafa A. A. Mahmoud

    Using a previously reported allylated hydrazide/thiosemicarbazide S4/S3 ligand platform, S4 (2‐(allyloxy)benzohydrazide) and S3 (2‐(2‐(allyloxy)benzoyl)‐ N ‐ethylhydrazine‐1‐carbothioamide) were prepared and extended to a first‐row metal‐complex series with Co (II), Ni (II), Cu (II), Mn (II), and Zn (II). The novelty lies in the metal‐complex extension and donor‐set‐dependent comparison of this known scaffold, not in rediscovery of the standalone ligands. The study compares the compact hydrazide O,N‐donor S4 platform with the sulfur‐containing thiosemicarbazide O,N,S‐donor S3 platform to examine complex formation, spectroscopic response, thermal behavior, disk‐diffusion antimicrobial screening, and MCF‐7 MTT activity. The ligands and isolated products were examined by elemental/metal analysis, FT‐IR, UV–Vis, ligand‐level 1 H NMR, magnetic susceptibility, TGA/DTG, antimicrobial disk diffusion, and MTT screening; selected 48‐h dose–response curves for S4‐Ni, S4‐Mn, and S4‐Co are provided in the Supporting Information as auxiliary IC 50 evidence. Convergent CHNS/metal elemental analysis, FT‐IR, UV–Vis, magnetic, and thermal observations support formation of metal–organic coordination solids, with O,N coordination proposed for S4‐derived complexes and O,N,S involvement proposed for S3‐derived complexes. Calculated/found CHNS/metal data support the selected empirical formulations, while the geometries are treated as proposed working coordination modes pending crystallographic confirmation. S4‐derived complexes showed the stronger antimicrobial profile, especially Co‐S4 against Staphylococcus aureus (16.85 ± 0.26 mm) and Ni‐S4 against Candida albicans (17.75 ± 1.10 mm). In the MCF‐7 single‐dose screen at 10 μg mL −1 , Zn‐S3 (87.79%), Ni‐S4 (80.16%), Co‐S3 (73.85%), and Ni‐S3 (73.50%) were the leading derivatives. Overall, sulfur incorporation did not act as a universal activity enhancer; instead, it redirected endpoint‐dependent metal behavior across the antimicrobial and MCF‐7 screens.

  • Retracted
    Open Access

    Novel thiosemicarbazone UV-vis chemosensor for dual pH-orthogonal detection of Fe 3+ and Ag +

    by Sherin A. M. Ali, Mostafa E. Salem, Ahmed Z. Ibrahim, Mostafa A. A. Mahmoud, Mohamed Abdel-Megid, Belal H. M. Hussein

    S3, a thiosemicarbazone ligand, functions as a pH-orthogonal UV-Vis chemosensor for Fe 3+ and Ag + . Dual blue/yellow responses at pH 10 and 4 give sub-ppm detection in aqueous media with high sensitivity.


  • Open Access

    Acid-phase protection of low-carbon steel by DIMC: evidenced by WL/PDP/EIS and density-functional modeling

    by Sherin A. M. Ali, Mostafa E. Salem, Mostafa A. A. Mahmoud, Mansour Alsarrani, Mohamed Abdel-Megid, H. A. El Nagy, Ahmed Z. Ibrahim

    We synthesized and evaluated 2,2′-(2,3-dihydroxyterephthaloyl)bis(N-propylhydrazine-1-carbothioamide) (DIMC) as a corrosion inhibitor for low-carbon steel (LCS) in 0.5 M HCl. A multi-technique workflow—weight loss (WL), potentiodynamic polarization (PDP), electrochemical impedance spectroscopy (EIS), and surface analysis (SEM/AFM)—shows concentration-dependent protection with maximum inhibition efficiency of 91.41% at 300 ppm and 298 K, remaining 80.24% at 328 K. EIS reveals two distinct time constants; refitting with Rs–(Cdl∥Rct)–(Cfilm∥Rfilm) confirms robust charge-transfer suppression plus a film-relaxation response. DFT descriptors and Monte Carlo adsorption simulations corroborate mixed physisorption–chemisorption, with electron-rich N/S/O centers driving donor–acceptor interactions at Fe sites. Collectively, DIMC forms a stable adsorbed layer that mitigates both anodic and cathodic reactions in aggressive acid, positioning DIMC as a promising green inhibitor for acid-exposed steel systems.


  • Open Access

    A Rapid Fluorescence Quenching Assay for Total Levothyroxine Quantification in Pharmaceutical and Supratherapeutic Serum Samples

    by Enas T. Abdel-Salam, Zeinab M. Anwar, Ahmed Z. Ibrahim, Hend M. Musatfa

    A rapid, cost-effective spectrofluorometric method was developed for levothyroxine (T4) detection using fluorescein isothiocyanate (FITC) as a fluorescent probe. The method exploits FITC fluorescence quenching by T4 in Tris/phosphate buffers (pH 7.4),with linear ranges of 8.00 × 10⁻⁶ – 6.40 × 10⁻⁵ mol/L and detection limits of 9.60 × 10⁻⁶ mol/L (Tris) and 8.80 × 10⁻⁶ mol/L (phosphate). Stern-Volmer analysis confirmed dynamic quenching dominated by electrostatic interactions. The method demonstrated 102–104% recovery in spiked human serum and minimal interference from common drugs (Ciprofloxacin, Alendronate) and ions (Fe³⁺, Al³⁺). Compared to HPLC and kinetic methods, this approach offers simplicity, speed, and accessibility for routine pharmaceutical/clinical analysis.

  • Optimizing dehydration and viscosity reduction in Egyptian heavy crude oil emulsions using eco-friendly demulsifiers

    by Ahmed Z. Ibrahim, El Sayed H. El Tamany, Mostafa A.A. Mahmoud, Mokhtar Al-Abyadh, H.A. El Nagy