M. Ya. Sokol
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
M. Ya. Sokol has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Anatoly A. Vostrikov
Kutateladze Institute of Thermophysics, Russian Academy of Sciences, Siberian Branch, Novosibirsk, Russia
6 shared publications - Andrey V. Shishkin
Kutateladze Institute of Thermophysics, Russian Academy of Sciences, Siberian Branch, Novosibirsk, Russia
6 shared publications - Oxana N. Fedyaeva
Kutateladze Institute of Thermophysics, Siberian Branch, Russian Academy of Sciences, Novosibirsk, Russia
6 shared publications - D. O. Artamonov
Kutateladze Institute of Thermophysics, Siberian Branch of the Russian Academy of Sciences
3 shared publications - Sergey A. Alekhin
Kutateladze Institute of Thermophysics, Siberian Branch, Russian Academy of Sciences, Novosibirsk, Russia
3 shared publications I. I. Fadeeva
Russian Academy of Sciences
1 shared publication
Latest Publications
- 1 December 2024
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry B
- Vol. 18 (8) , 1924-1938
Supercritical Water Cooxidation of Poultry Manure and Brown Coal in the Flow Mode
The results of joint supercritical water oxidation (SCWO) on poultry manure (PM) and brown coal (BC) mixtures continuously fed as an NaOH stabilized (0.8 wt %) slurry into a tubular reactor at 25 MPa, temperature gradient along its vertical axis of 390–600°C, varied reactant flow rate, and concentrations of PM and BC in the slurry are presented. The addition of BC leads to a reduction of the total energy consumption by ohmic heaters by factors of 1.5–1.8, depending on the content of combustible matter in the slurry. The forming gas mixture contains CO2, N2, and a trace amount of N2O. Calcium and sodium carbonates, phosphates, and aluminosilicates are predominant in the composition of ash residues. The total content of phenols (17–32 μg/dm3) and polycyclic aromatic hydrocarbons (2–4 μg/dm3) in the effluent depends on the PM concentration in the slurry and does not exceed the level of their maximum permissible concentration in wastewater. The formation of HNO3 and H2SO4 during the SCWO process results in the corrosion of construction materials and increases the content of chromium, copper, and nickel in the aqueous effluent. The mechanisms of the transformation of the organic and mineral components of PM and BC are discussed.
- 1 December 2024
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry B
- Vol. 18 (8) , 1924-1938
Supercritical Water Cooxidation of Poultry Manure and Brown Coal in the Flow Mode
The results of joint supercritical water oxidation (SCWO) on poultry manure (PM) and brown coal (BC) mixtures continuously fed as an NaOH stabilized (0.8 wt %) slurry into a tubular reactor at 25 MPa, temperature gradient along its vertical axis of 390–600°C, varied reactant flow rate, and concentrations of PM and BC in the slurry are presented. The addition of BC leads to a reduction of the total energy consumption by ohmic heaters by factors of 1.5–1.8, depending on the content of combustible matter in the slurry. The forming gas mixture contains CO2, N2, and a trace amount of N2O. Calcium and sodium carbonates, phosphates, and aluminosilicates are predominant in the composition of ash residues. The total content of phenols (17–32 μg/dm3) and polycyclic aromatic hydrocarbons (2–4 μg/dm3) in the effluent depends on the PM concentration in the slurry and does not exceed the level of their maximum permissible concentration in wastewater. The formation of HNO3 and H2SO4 during the SCWO process results in the corrosion of construction materials and increases the content of chromium, copper, and nickel in the aqueous effluent. The mechanisms of the transformation of the organic and mineral components of PM and BC are discussed.
- 1 December 2024
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry B
- Vol. 18 (7) , 1705-1712
Peculiarities of Carbamide Hydrolysis and Oxidation in a Water–Oxygen Fluid
The transformations of carbamide in a water–oxygen fluid (at a carbamide concentration of 0.29–0.39 mol/L, oxygen excess coefficient OR = 0.98–1.25, mole fraction of water 70.0–91.3%) are studied in a batch reactor when heated to 873 K at a rate of 1 K/min. It is shown that the transformations proceed via the mechanism of parallel and sequential reactions, including carbamide hydrolysis, formation and decomposition of cyanuric acid, oxidation of ammonia and products of the decomposition of cyanuric acid. From the analysis of the time dependencies of temperature and pressure, it follows that the oxidation of carbamide occurs predominantly heterogeneously on the surfaces of the reactor wall and the Pt–Rh/Pt-thermocouple inserted into the center of the reaction volume. It is established that excess oxygen (OR = 1.25) or the addition of NaOH leads to an increase in the fraction of nitrogen converted into N2 and prevents the formation of cyanuric acid. The influence of the concentration of reagents on the ratio of carbamide conversion pathways and the dynamics of heat release is discussed.
- 1 December 2024
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry B
- Vol. 18 (7) , 1705-1712
Peculiarities of Carbamide Hydrolysis and Oxidation in a Water–Oxygen Fluid
The transformations of carbamide in a water–oxygen fluid (at a carbamide concentration of 0.29–0.39 mol/L, oxygen excess coefficient OR = 0.98–1.25, mole fraction of water 70.0–91.3%) are studied in a batch reactor when heated to 873 K at a rate of 1 K/min. It is shown that the transformations proceed via the mechanism of parallel and sequential reactions, including carbamide hydrolysis, formation and decomposition of cyanuric acid, oxidation of ammonia and products of the decomposition of cyanuric acid. From the analysis of the time dependencies of temperature and pressure, it follows that the oxidation of carbamide occurs predominantly heterogeneously on the surfaces of the reactor wall and the Pt–Rh/Pt-thermocouple inserted into the center of the reaction volume. It is established that excess oxygen (OR = 1.25) or the addition of NaOH leads to an increase in the fraction of nitrogen converted into N2 and prevents the formation of cyanuric acid. The influence of the concentration of reagents on the ratio of carbamide conversion pathways and the dynamics of heat release is discussed.
- 1 May 2023
- Published by Pleiades Publishing Ltd in Thermophysics and Aeromechanics
- Vol. 30 (3) , 539-552
Effect of initiating additives on phenol oxidation in water–oxygen fluid
Phenol oxidation in a water-oxygen fluid in a tubular batch reactor with its uniform heating (1 °C/min) to 600 °C was studied. An increase in the amount of O2 above the stoichiometric ratio by 25 % leads to an increase in the degree of carbon burnout by the factor of 1.09. Replacing 10 % of the stoichiometric amount of oxygen with nitrous oxide leads to the same increase in the degree of carbon burnout, primarily due to its afterburning at a temperature of ≥ 400 °C. Replacement of some part of phenol with isopropanol leads to an increase in the degree of carbon burnout by the factor of 1.02. It was established for the first time that the heterogeneous mechanism of phenol oxidation in a water-oxygen fluid is the main one. However, the overstoichiometric amount of O2, as well as the addition of N2O and isopropanol intensifies gas-phase combustion of carbon. A catalytic effect of a Pt-Rh/Pt-thermocouple on the degree of phenol conversion in the presence of O2 at temperatures above 135 °C was found.
- 1 May 2023
- Published by Pleiades Publishing Ltd in Thermophysics and Aeromechanics
- Vol. 30 (3) , 539-552
Effect of initiating additives on phenol oxidation in water–oxygen fluid
Phenol oxidation in a water-oxygen fluid in a tubular batch reactor with its uniform heating (1 °C/min) to 600 °C was studied. An increase in the amount of O2 above the stoichiometric ratio by 25 % leads to an increase in the degree of carbon burnout by the factor of 1.09. Replacing 10 % of the stoichiometric amount of oxygen with nitrous oxide leads to the same increase in the degree of carbon burnout, primarily due to its afterburning at a temperature of ≥ 400 °C. Replacement of some part of phenol with isopropanol leads to an increase in the degree of carbon burnout by the factor of 1.02. It was established for the first time that the heterogeneous mechanism of phenol oxidation in a water-oxygen fluid is the main one. However, the overstoichiometric amount of O2, as well as the addition of N2O and isopropanol intensifies gas-phase combustion of carbon. A catalytic effect of a Pt-Rh/Pt-thermocouple on the degree of phenol conversion in the presence of O2 at temperatures above 135 °C was found.
- 1 January 2023
- Published by Fund Science and Culture Support Centre in Химия в интересах устойчивого развития
- Vol. 31 (1) , 85-95
Oxidation of Sewage Sludge in the Flow of Water-Oxygen Fluid under Uniform Heating
- 1 January 2023
- Published by Fund Science and Culture Support Centre in Химия в интересах устойчивого развития
- Vol. 31 (1) , 85-95
Oxidation of Sewage Sludge in the Flow of Water-Oxygen Fluid under Uniform Heating
- 1 January 2023
- Published by Fund Science and Culture Support Centre in Химия в интересах устойчивого развития
- Vol. 31 (1) , 87-97
Oxidation of Sewage Sludge in the Flow of Water-Oxygen Fluid under Uniform Heating
- 1 January 2023
- Published by Fund Science and Culture Support Centre in Химия в интересах устойчивого развития
- Vol. 31 (1) , 87-97
Oxidation of Sewage Sludge in the Flow of Water-Oxygen Fluid under Uniform Heating
- 1 December 2017
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry B
- Vol. 11 (7) , 1117-1128
Role of Supercritical Water and Pyrite in Transformations of Propylene
The effect of supercritical water and pyrite on the transformations of propylene upon the uniform heating (1.5 K/min) of reagents to 718 K is studied. The products are analyzed by IR and 1H NMR...
- 1 December 2017
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry B
- Vol. 11 (7) , 1117-1128
Role of Supercritical Water and Pyrite in Transformations of Propylene
The effect of supercritical water and pyrite on the transformations of propylene upon the uniform heating (1.5 K/min) of reagents to 718 K is studied. The products are analyzed by IR and 1H NMR...
- 1 December 2010
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry B
- Vol. 4 (7) , 1051-1060
The formation of Al2O3 nanoparticles in the oxidation of aluminum by water under sub- and supercritical conditions
Massive aluminum samples were oxidized by sub- and supercritical water with the formation of (AlOOH) n and (Al2O3) n nanoparticles. The release of H2 began at 523 K when the reagents were heated uniformly to 700 K. The time lag of the beginning of oxidation was 140 s when supercritical water was injected into a reactor with aluminum samples at 665 K and 23.1 MPa. Oxidized aluminum powders were analyzed using a transmission electron microscope. Predominantly large (300–400 nm) α-Al2O3 particles were formed when supercritical water was injected into a reactor with aluminum. Smaller (20–50 nm) γ-Al2O3 particles were also observed in samples oxidized by water vapor under temperature increase conditions. Kinetic equations describing the rate of H2 formation in the reaction of H2O with aluminum were obtained. Possible nanostructuring mechanisms are discussed.
- 1 December 2010
- Published by Pleiades Publishing Ltd in Russian Journal of Physical Chemistry B
- Vol. 4 (7) , 1051-1060
The formation of Al2O3 nanoparticles in the oxidation of aluminum by water under sub- and supercritical conditions
Massive aluminum samples were oxidized by sub- and supercritical water with the formation of (AlOOH) n and (Al2O3) n nanoparticles. The release of H2 began at 523 K when the reagents were heated uniformly to 700 K. The time lag of the beginning of oxidation was 140 s when supercritical water was injected into a reactor with aluminum samples at 665 K and 23.1 MPa. Oxidized aluminum powders were analyzed using a transmission electron microscope. Predominantly large (300–400 nm) α-Al2O3 particles were formed when supercritical water was injected into a reactor with aluminum. Smaller (20–50 nm) γ-Al2O3 particles were also observed in samples oxidized by water vapor under temperature increase conditions. Kinetic equations describing the rate of H2 formation in the reaction of H2O with aluminum were obtained. Possible nanostructuring mechanisms are discussed.