Noah Rossignol
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Noah Rossignol has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Feliciano Giustino
The University of Texas at Austin
1 shared publication - Hongze Li
The University of Texas at Austin
1 shared publication Jianshi Zhou
The University of Texas at Austin
1 shared publication- Li Shi
Walker Department of Mechanical Engineering, The University of Texas at Austin 1 , Austin, Texas 78712
1 shared publication - Sungyeb Jung
The University of Texas at Austin
1 shared publication - Woongchul Choi
The University of Texas at Austin
1 shared publication
Latest Publications
- 4 November 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 114 (27)
Balanced electron and phonon heat transport in metallic ε -TaN
- 4 November 2026
- Published by American Physical Society (APS) in Physical Review B
- Vol. 114 (27)
Balanced electron and phonon heat transport in metallic ε -TaN
- Open Access
- 4 February 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (3) , 035604
Low-power electrodeless 2.45 GHz microwave plasma generation in ambient air with dielectric resonators
Microwave (MW) plasma, as an electrodeless non-thermal plasma technique, holds significant potential for gas processing applications under near-ambient conditions. However, current MW plasma methods suffer from low energy efficiency due to the high power required for molecular breakdown via vibrational excitation. A promising approach to mitigate this challenge involves using a pair of high relative permittivity dielectric resonators (DRs) in close proximity to enhance the electric field within the small gap between them, thus reducing power consumption. In this study, we combined simulations and experiments to investigate the electric field enhancement effect of DRs with varying shapes, geometrical parameters (e.g., radius and height), gap distances, and orientations relative to the electric field polarization and MW propagation directions. Simulations performed using Ansys HFSS demonstrate that edge-to-edge configurations of hexagonal, square, and triangular prism DRs can achieve significant electric field enhancement over a broad range of geometric parameters. DRs fabricated from calcium titanate were tested experimentally using a simple setup with a kitchen microwave (2.45 GHz) at ambient pressure. With input power below 100 W, stable and highly confined plasma was generated using hexagonal and triangular prism DRs. These results suggest a simple, cost-effective, and low-power method for generating MW plasma under ambient conditions, offering particular advantages for chemical processing in rural areas utilizing renewable energy resources.
- 4 February 2025
- Published by IOP Publishing in Physica Scripta
- Vol. 100 (3) , 035604
Open AccessLow-power electrodeless 2.45 GHz microwave plasma generation in ambient air with dielectric resonators
Microwave (MW) plasma, as an electrodeless non-thermal plasma technique, holds significant potential for gas processing applications under near-ambient conditions. However, current MW plasma methods suffer from low energy efficiency due to the high power required for molecular breakdown via vibrational excitation. A promising approach to mitigate this challenge involves using a pair of high relative permittivity dielectric resonators (DRs) in close proximity to enhance the electric field within the small gap between them, thus reducing power consumption. In this study, we combined simulations and experiments to investigate the electric field enhancement effect of DRs with varying shapes, geometrical parameters (e.g., radius and height), gap distances, and orientations relative to the electric field polarization and MW propagation directions. Simulations performed using Ansys HFSS demonstrate that edge-to-edge configurations of hexagonal, square, and triangular prism DRs can achieve significant electric field enhancement over a broad range of geometric parameters. DRs fabricated from calcium titanate were tested experimentally using a simple setup with a kitchen microwave (2.45 GHz) at ambient pressure. With input power below 100 W, stable and highly confined plasma was generated using hexagonal and triangular prism DRs. These results suggest a simple, cost-effective, and low-power method for generating MW plasma under ambient conditions, offering particular advantages for chemical processing in rural areas utilizing renewable energy resources.