Fatemeh Heydari
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Fatemeh Heydari has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
A.A. Ebrahimi Valmoozi
2 shared publications- Domokos Máthé
Department of Biophysics and Radiation Biology, Semmelweis University, 1085 Budapest, Hungary
2 shared publications - László Forgách
Department of Biophysics and Radiation Biology, Semmelweis University, 1094 Budapest, Hungary
2 shared publications - Seyyed Salman Seyyed Afghahi
Department of Materials Science and Engineering, Imam Hossein University, Tehran, Iran
2 shared publications - Zoltán Kaleta
Department of Organic Chemistry, Semmelweis University, Hőgyes Endre Street 7, H-1092 Budapest, Hungary
2 shared publications Béla Viskolcz
Affiliations Institute of Chemistry, University of Miskolc, Miskolc-Egyetemváros, Miskolc, Hungary, Higher Education and Industrial Cooperation Centre, University of Miskolc, Miskolc, Hungary
1 shared publication
Latest Publications
- Open Access
- 1 June 2026
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 16 (32) , 29450-29457
Straightforward synthesis of Solomon-red-BAPTA as NIR fluorescent sensors via metal-free oxidative coupling
An effective, near-infrared (NIR) fluorescent Ca2+ sensor, Solomon-red-BAPTA, featuring a dioxothioxanthene moiety was developed for microscopy. A rapid and operationally simple synthetic route is described. The key step involves a room-temperature DDQ-mediated cross-dehydrogenative coupling (CDC) of the fluorescent precursor and BAPTA followed by a one-pot oxidation. The sensor exhibited excellent photophysical characteristics including a 160-fold fluorescence enhancement with excitation and emission maxima at 712 nm and 736 nm, respectively, suggesting high tissue-penetrating capacity. Based on the experimental data, the structure–property relationship was elucidated and further supported by DFT calculations, particularly with respect to the photoinduced electron transfer (PET)-based fluorescence turn-on mechanism.
- 1 June 2026
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 16 (32) , 29450-29457
Open AccessStraightforward synthesis of Solomon-red-BAPTA as NIR fluorescent sensors via metal-free oxidative coupling
An effective, near-infrared (NIR) fluorescent Ca2+ sensor, Solomon-red-BAPTA, featuring a dioxothioxanthene moiety was developed for microscopy. A rapid and operationally simple synthetic route is described. The key step involves a room-temperature DDQ-mediated cross-dehydrogenative coupling (CDC) of the fluorescent precursor and BAPTA followed by a one-pot oxidation. The sensor exhibited excellent photophysical characteristics including a 160-fold fluorescence enhancement with excitation and emission maxima at 712 nm and 736 nm, respectively, suggesting high tissue-penetrating capacity. Based on the experimental data, the structure–property relationship was elucidated and further supported by DFT calculations, particularly with respect to the photoinduced electron transfer (PET)-based fluorescence turn-on mechanism.
- Open Access
- 6 February 2025
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 20 (2) , e0316221
Solvothermal synthesis of polyvinyl pyrrolidone encapsulated, amine-functionalized copper ferrite and its use as a magnetic resonance imaging contrast agent
Copper ferrite nanoparticles for use as MRI contrast agents were synthesized using two different methods. A novel microwave-assisted (MW) solvothermal method was developed and compared to a conventional 12-hour synthesis (Reflux) as an eco-friendlier approach. This innovative synthesis method successfully produced nanoparticles with enhanced properties compared to traditional ferrite materials. The nanoparticles’ morphological and magnetic properties were evaluated and tested in in-vivo MRI studies. The results revealed both similarities and differences between the amine-functionalized copper ferrite nanoparticles. FTIR, XRD, HRTEM, and VSM analyses indicated improved properties in the CuFe2O4-NH2 MW particles, while AFM confirmed successful polymer encapsulation of the nanoparticles. For the CuFe2O4-NH2 MW sample, 76.8 wt% copper ferrite and 23.2 wt% magnetite were detected, with crystallite sizes of 8 ± 2 nm and 13 ± 2 nm, respectively. In the CuFe2O4-NH2 Refl. sample, in addition to these two magnetic phases, larger copper particles (31.6 wt%) were also formed. DLS analysis demonstrated that the CuFe2O4-NH2 MW sample exhibited excellent colloidal stability, maintaining its size distribution in aqueous media for 3 hours without aggregation, unlike the CuFe2O4-NH2 Refl. sample, which showed slight aggregation. The CuFe2O4-NH2 MW sample displayed superparamagnetic behavior (Ms: 15 emu/g, Mr: 0 emu/g, Hc: 0 Oe), while the CuFe2O4-NH2 Refl. sample exhibited ferromagnetic characteristics (Ms: 40 emu/g, Mr: 1.35 emu/g, Hc: 30 Oe). Both samples produced comparable results during in vitro MRI measurements, showing similar T2* relaxation and signal characteristics. Further in vivo studies demonstrated that both samples induced significant hypointense changes. The study provides valuable insights into the synthesis, properties, and potential applications of these materials, emphasizing the importance of eco-friendly methods and the optimization of ferrite-based MRI contrast agents.
- 6 February 2025
- Published by Public Library of Science (PLoS) in PLOS ONE
- Vol. 20 (2) , e0316221
Open AccessSolvothermal synthesis of polyvinyl pyrrolidone encapsulated, amine-functionalized copper ferrite and its use as a magnetic resonance imaging contrast agent
Copper ferrite nanoparticles for use as MRI contrast agents were synthesized using two different methods. A novel microwave-assisted (MW) solvothermal method was developed and compared to a conventional 12-hour synthesis (Reflux) as an eco-friendlier approach. This innovative synthesis method successfully produced nanoparticles with enhanced properties compared to traditional ferrite materials. The nanoparticles’ morphological and magnetic properties were evaluated and tested in in-vivo MRI studies. The results revealed both similarities and differences between the amine-functionalized copper ferrite nanoparticles. FTIR, XRD, HRTEM, and VSM analyses indicated improved properties in the CuFe2O4-NH2 MW particles, while AFM confirmed successful polymer encapsulation of the nanoparticles. For the CuFe2O4-NH2 MW sample, 76.8 wt% copper ferrite and 23.2 wt% magnetite were detected, with crystallite sizes of 8 ± 2 nm and 13 ± 2 nm, respectively. In the CuFe2O4-NH2 Refl. sample, in addition to these two magnetic phases, larger copper particles (31.6 wt%) were also formed. DLS analysis demonstrated that the CuFe2O4-NH2 MW sample exhibited excellent colloidal stability, maintaining its size distribution in aqueous media for 3 hours without aggregation, unlike the CuFe2O4-NH2 Refl. sample, which showed slight aggregation. The CuFe2O4-NH2 MW sample displayed superparamagnetic behavior (Ms: 15 emu/g, Mr: 0 emu/g, Hc: 0 Oe), while the CuFe2O4-NH2 Refl. sample exhibited ferromagnetic characteristics (Ms: 40 emu/g, Mr: 1.35 emu/g, Hc: 30 Oe). Both samples produced comparable results during in vitro MRI measurements, showing similar T2* relaxation and signal characteristics. Further in vivo studies demonstrated that both samples induced significant hypointense changes. The study provides valuable insights into the synthesis, properties, and potential applications of these materials, emphasizing the importance of eco-friendly methods and the optimization of ferrite-based MRI contrast agents.
- 9 October 2024
- Published by Elsevier in Diamond and Related Materials
- Vol. 149, 111652
Investigating the structural and electromagnetic properties of ZnFe2O4@MWCNTs nanocomposites
- 9 October 2024
- Published by Elsevier in Diamond and Related Materials
- Vol. 149, 111652
Investigating the structural and electromagnetic properties of ZnFe2O4@MWCNTs nanocomposites
- 1 July 2019
- Published by Pleiades Publishing Ltd in Protection of Metals and Physical Chemistry of Surfaces
- Vol. 55 (4) , 748-752
The Enhancement of Wear Properties of Compo-Cast A356 Composites Reinforced with SiC nano Particulates
- 1 July 2019
- Published by Pleiades Publishing Ltd in Protection of Metals and Physical Chemistry of Surfaces
- Vol. 55 (4) , 748-752
The Enhancement of Wear Properties of Compo-Cast A356 Composites Reinforced with SiC nano Particulates