Lunhao Duan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Lunhao Duan has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Huizhang Yang
Department of Electronic and Optical Engineering, Nanjing University of Science and Technology, Nanjing, China
5 shared publications - Xingyu Lu
Nanjing University of Science and Technology
5 shared publications Jianchao Yang
Department of Electronic and Optical Engineering, Nanjing University of Science and Technology, Nanjing, China
3 shared publicationsHong Gu
Department of Electronic and Optical Engineering, Nanjing University of Science and Technology, Nanjing, China
2 shared publications- Hong Gu
Department of Electronic and Optical Engineering, Nanjing University of Science and Technology, Nanjing, China
2 shared publications - Jianchao Yang
School of Electronic and Optical Engineering, Nanjing University of Science and Technology, Nanjing, China
2 shared publications
Latest Publications
- 18 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 64 (01962892) , 5208315
SFID: An Azimuthal Structure-Guided Robust and Adaptive Interference Detector for SAR Imagery
Synthetic Aperture Radar (SAR) is highly susceptible to Radio Frequency Interference (RFI). A novel RFI detector (SFID) based on left singular vector characteristics is proposed for Single-Look Complex (SLC) SAR images. The core principle is to exploit the azimuthal structure difference between focused targets and interference: the target response manifests as a sinc function, while the interference response exhibits a Linear Frequency Modulated (LFM) form. Specifically, the method segments images into patches, performs Singular Value Decomposition (SVD) on each patch, applies Fractional Fourier Transform (FRFT) at the optimal angle to the left singular vector matrix, and realizes Constant False Alarm Rate (CFAR) detection by comparing the squared global FRFT peak p1 with an adaptive threshold. Theoretical derivation shows that p1 obeys the Gumbel distribution in clean SAR images, providing a basis for adaptive threshold calculation. For TOPSAR mode, the linear variation of the focused target Doppler bandwidth centroid degrades detection performance; thus, an interference model for TOPSAR mode is established and detection preprocessing tailored to this mode is introduced to enhance detection robustness. Experiments on measured data from Gaofen-3 and Sentinel-1 demonstrate that SFID can effectively detect low-Interference-to-Signal Ratio (ISR) and dense interference, outperforming traditional detection methods.
- 18 May 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 64 (01962892) , 5208315
SFID: An Azimuthal Structure-Guided Robust and Adaptive Interference Detector for SAR Imagery
Synthetic Aperture Radar (SAR) is highly susceptible to Radio Frequency Interference (RFI). A novel RFI detector (SFID) based on left singular vector characteristics is proposed for Single-Look Complex (SLC) SAR images. The core principle is to exploit the azimuthal structure difference between focused targets and interference: the target response manifests as a sinc function, while the interference response exhibits a Linear Frequency Modulated (LFM) form. Specifically, the method segments images into patches, performs Singular Value Decomposition (SVD) on each patch, applies Fractional Fourier Transform (FRFT) at the optimal angle to the left singular vector matrix, and realizes Constant False Alarm Rate (CFAR) detection by comparing the squared global FRFT peak p1 with an adaptive threshold. Theoretical derivation shows that p1 obeys the Gumbel distribution in clean SAR images, providing a basis for adaptive threshold calculation. For TOPSAR mode, the linear variation of the focused target Doppler bandwidth centroid degrades detection performance; thus, an interference model for TOPSAR mode is established and detection preprocessing tailored to this mode is introduced to enhance detection robustness. Experiments on measured data from Gaofen-3 and Sentinel-1 demonstrate that SFID can effectively detect low-Interference-to-Signal Ratio (ISR) and dense interference, outperforming traditional detection methods.
- 17 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 64 (01962892) , 1-16
Harmonic-Assisted TDOA Localization Method for Saturation Interference Sources in SAR Satellite Systems
Accurate localization of spaceborne Synthetic Aperture Radar (SAR) interference sources facilitates the search, identification, and characterization of interferers, while also providing prior information for enhancing interference suppression, making it a current research focus. For locating the most common ground-based co-frequency radar interferers in SAR satellite systems, several methods have been developed by exploiting the spatial variation of periodic pulse arrival times. However, high-power interference signals from ground radars tend to cause receiver saturation, leading to nonlinear distortion. This results in power loss in the fundamental component and generates homologous harmonics that compete with the fundamental, both severely degrading the fundamental jamming-to-noise ratio (JNR) and reducing the accuracy of existing fundamental time difference of arrival (TDOA)-based localization. To address this, this paper proposes a novel approach that turns the otherwise harmful harmonic components into beneficial resources to enhance localization performance. The fundamental and third-harmonic pulses are first extracted and separated from the SAR echoes. Theoretical and observed TDOA sequences are then computed for both components. Finally, accurate localization is achieved through a joint loss function. Simulations using the Geometric Dilution of Precision (GDOP) demonstrate that the proposed method improves localization accuracy under saturation compared to existing TDOA-based approaches. Experiments with GF-3B satellite dual-pass data confirm its effectiveness, reducing the localization error to 2.08 km.
- 17 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 64 (01962892) , 1-16
Harmonic-Assisted TDOA Localization Method for Saturation Interference Sources in SAR Satellite Systems
Accurate localization of spaceborne Synthetic Aperture Radar (SAR) interference sources facilitates the search, identification, and characterization of interferers, while also providing prior information for enhancing interference suppression, making it a current research focus. For locating the most common ground-based co-frequency radar interferers in SAR satellite systems, several methods have been developed by exploiting the spatial variation of periodic pulse arrival times. However, high-power interference signals from ground radars tend to cause receiver saturation, leading to nonlinear distortion. This results in power loss in the fundamental component and generates homologous harmonics that compete with the fundamental, both severely degrading the fundamental jamming-to-noise ratio (JNR) and reducing the accuracy of existing fundamental time difference of arrival (TDOA)-based localization. To address this, this paper proposes a novel approach that turns the otherwise harmful harmonic components into beneficial resources to enhance localization performance. The fundamental and third-harmonic pulses are first extracted and separated from the SAR echoes. Theoretical and observed TDOA sequences are then computed for both components. Finally, accurate localization is achieved through a joint loss function. Simulations using the Geometric Dilution of Precision (GDOP) demonstrate that the proposed method improves localization accuracy under saturation compared to existing TDOA-based approaches. Experiments with GF-3B satellite dual-pass data confirm its effectiveness, reducing the localization error to 2.08 km.
- Open Access
- 24 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
- Vol. 18 (19391404) , 9244-9261
Saturated Interference in SAR: Theoretical Analysis and Suppression Solutions
Synthetic aperture radar (SAR) systems are highly sensitive to interference, making interference suppression a critical concern. While significant research has been conducted on SAR interference suppression using parametric, non-parametric, semi-parametric methods, and machine learning, these studies often neglect the impact of high-power interference, which can saturate SAR receivers due to their limited dynamic range. This saturation can lead to the model mismatch and performance degradation of many previously studied suppression methods. In this paper, we provide a detailed analysis of saturated interference in SAR systems. We develop time-domain saturation signal models for different types of interference, and analyze the frequency domain spurious characteristics of saturated interference. Based on this analysis, we propose novel interference suppression method adapted for saturated narrowband and wideband interference. We validate our methods using semi-actual data from Radarsat-1, demonstrating their effectiveness in suppressing both narrowband and wideband saturated interference. Besides, we also conducted analysis and verification using the real saturated interference data of Gaofen-3. The results confirm the proposed methods' capability to enhance SAR performance under saturation conditions.
- 24 March 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
- Vol. 18 (19391404) , 9244-9261
Open AccessSaturated Interference in SAR: Theoretical Analysis and Suppression Solutions
Synthetic aperture radar (SAR) systems are highly sensitive to interference, making interference suppression a critical concern. While significant research has been conducted on SAR interference suppression using parametric, non-parametric, semi-parametric methods, and machine learning, these studies often neglect the impact of high-power interference, which can saturate SAR receivers due to their limited dynamic range. This saturation can lead to the model mismatch and performance degradation of many previously studied suppression methods. In this paper, we provide a detailed analysis of saturated interference in SAR systems. We develop time-domain saturation signal models for different types of interference, and analyze the frequency domain spurious characteristics of saturated interference. Based on this analysis, we propose novel interference suppression method adapted for saturated narrowband and wideband interference. We validate our methods using semi-actual data from Radarsat-1, demonstrating their effectiveness in suppressing both narrowband and wideband saturated interference. Besides, we also conducted analysis and verification using the real saturated interference data of Gaofen-3. The results confirm the proposed methods' capability to enhance SAR performance under saturation conditions.
- 10 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 63 (01962892) , 1-19
Localization of Ground-Based Periodic Pulse Interferers Using Time Difference of Arrival Estimation in SAR Satellite Systems
Signals emitted by ground-based sources frequently interfere with those received by spaceborne Synthetic Aperture Radar (SAR) systems, with periodic pulses from ground radars being the most common form of interference. This paper introduces a method to locate the source of these pulsed signals utilizing SAR echo data. Initially, the Time Difference of Arrival (TDOA) for each pulse transmitted by the interferer and received by the SAR satellite is estimated. A mapping relationship between the interferer coordinates (latitude and longitude) and the variations in TDOA is then established. Using this mapping, the localization of the interferer is finally performed via a two-dimensional search approach. The proposed method is highly versatile and applicable to systems consisting of one single SAR, constellations of SAR instruments, and configurations of multichannel single-instrument SAR systems. Regardless of the modulation form of the interfering signal, the method remains effective. The accuracy of the method is analyzed and the factors influencing the localization precision are investigated. Finally, using the Gaofen-3 spaceborne SAR, an experimental validation of the proposed TDOA-based localization method is performed. Results indicate that the positioning error of an interference source based on two consecutive satellite measurements is only 3.7 kilometers.
- 10 February 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Geoscience and Remote Sensing
- Vol. 63 (01962892) , 1-19
Localization of Ground-Based Periodic Pulse Interferers Using Time Difference of Arrival Estimation in SAR Satellite Systems
Signals emitted by ground-based sources frequently interfere with those received by spaceborne Synthetic Aperture Radar (SAR) systems, with periodic pulses from ground radars being the most common form of interference. This paper introduces a method to locate the source of these pulsed signals utilizing SAR echo data. Initially, the Time Difference of Arrival (TDOA) for each pulse transmitted by the interferer and received by the SAR satellite is estimated. A mapping relationship between the interferer coordinates (latitude and longitude) and the variations in TDOA is then established. Using this mapping, the localization of the interferer is finally performed via a two-dimensional search approach. The proposed method is highly versatile and applicable to systems consisting of one single SAR, constellations of SAR instruments, and configurations of multichannel single-instrument SAR systems. Regardless of the modulation form of the interfering signal, the method remains effective. The accuracy of the method is analyzed and the factors influencing the localization precision are investigated. Finally, using the Gaofen-3 spaceborne SAR, an experimental validation of the proposed TDOA-based localization method is performed. Results indicate that the positioning error of an interference source based on two consecutive satellite measurements is only 3.7 kilometers.