Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Antonio Espínola Jiménez has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Fall Arrest Governs the Design of Lightweight Working Platforms for Steep Slopes: Finite Element Analysis and Code-Based Assessment of a Modular Aluminium System

    by Raúl Gómez-Ferreira, Antonio Espínola-Jiménez, Rubén Tino-Ramos, David Hidalgo-García

    Stone pitching and other finishing works on steep infrastructure slopes (45–60°) are still commonly executed by workers standing on the inclined surface. This paper assesses a modular system of aluminium stringers resting on the slope and horizontal platforms connected by pins and hooks, derived from a Spanish utility model. The original shell finite element analysis (FEA) was re-examined with an independent shell FEA built from the original geometry and verified against benchmarks and closed-form solutions, complemented with a mesh-sensitivity study, a sub-model of the pin holes, frictional contact with the slope and code-based checks to EN 12811-1 and Eurocodes 3 and 9. Deflections under imposed load agreed within 4% between models and changed by less than 1% with mesh refinement, whereas peak stresses at the idealised connections increased by up to 3.5 times; connections were therefore verified with code resistance models. For two workers per platform, the selected configuration (60 × 40 × 3 mm platform tubes and 250 × 40 × 3 mm stringers in EN AW-6063 T6) reached a maximum utilisation of 0.87, and the end-of-span load case did not govern. A single 6 kN arrest force at an integrated anchor point exceeded the elastic limit of the platform by 1.4–2.1 times and reached 86–115% of its plastic collapse load, leaving no margin for dynamic amplification or for the 12 kN static strength of EN 795. Fall arrest therefore governs any integrated anchorage, which should be replaced by an independent anchor device; driven-bar ground anchors were also found to be insufficient in granular soils.

  • Open Access

    Urban form and densification as drivers of intra-urban inequalities: A 30-year LCZ-based analysis of Casablanca and Rabat

    by David Hidalgo-García, Dimitra Founda, Hamed Rezapouraghdam, Mounia Tahiri, Antonio Espínola-Jiménez

  • Open Access

    Dinámicas espacio-temporales del estrés por calor urbano en cuatro ciudades españolas (2008–2017): análisis por Zonas Climáticas Locales y teledetección

    by Antonio Espínola Jiménez, Rubén López-Cantero, David Hidalgo García

    This study examines the evolution of the heat stress index (Hi) between 2008, 2012, and 2017 in four Spanish cities (Barcelona, ​​Madrid, Málaga, and Valencia) from a comparative perspective based on Local Climate Zones (LCZs). Using the UrbClim model and indices derived from Landsat images (NDVI and NDBI), the spatial and temporal contrasts of Hi and its relationship with urban morphology and vegetation availability were evaluated. The results show marked inter-urban heterogeneity and heterogeneity among LCS types, with more intense concentrations of heat stress in compact and industrial-urban áreas and more moderate levels in open and rural áreas with greater green cover. Furthermore, differential gradients in Hi growth were identified between cities, along with statistically significant association patterns between urban compactness, reduced NDVI, and increased heat stress, confirming the structural role of morphological configuration in heat exposure. These findings allow the identification of more vulnerable urban typologies and provide operational criteria for planning focused on thermal mitigation and urban resilience.

  • Open Access

    Sistemas de representación urbana en el Renacimiento: contexto e innovaciones en los modelos urbanos de Leonardo Da Vinci

    by Antonio Espínola Jiménez, Rubén López Cantero, David Hidalgo García

    Durante el tramo final de la Edad Media y los primeros años del Renacimiento, los modos de representar las ciudades en tratados y manuscritos evolucionaron notablemente. Este cambio respondió a la necesidad de concebir el diseño urbano desde una perspectiva más planificada, sustentada en modelos técnicos cada vez más elaborados. Aunque la perspectiva y la proyección ortogonal ya se utilizaban anteriormente, en el Renacimiento fueron reinterpretadas con un carácter más refinado. Algunos artistas combinaron ambos enfoques y utilizaron variaciones cromáticas para reforzar aspectos altimétricos y estructurales de los espacios urbanos. Leonardo da Vinci fue una figura esencial en esta renovación. Sus códices y manuscritos recogen estas innovaciones, que se estudian aquí desde la perspectiva de su aportación a la representación urbana, un campo habitualmente relegado a un segundo plano.

  • Open Access

    Urban Forest Microclimates and Their Response to Heat Waves—A Case Study for London

    by David Hidalgo-García, Dimitra Founda, Hamed Rezapouraghdam, Antonio Espínola Jiménez, Muaz Azinuddin

    Extreme weather events and rising temperatures pose significant risks, not only in urban areas but also in metropolitan forests, that affect the well-being of the people who visit them. City forests are considered one of the best bets for mitigating high temperatures within civic areas. Such areas modulate microclimates in contemporary cities, offering environmental, social, and economic advantages. Therefore, comprehending the intricate relationships between municipal forests and the climatic changes of various destinations is crucial for attaining healthier and more sustainable city environments for people. In this research, the thermal comfort index (Modified Temperature–Humidity Index (MTHI)) has been analysed using Landsat images of six urban forests in London during July 2022, when the area first experienced record-breaking temperatures of over 40 °C. Our results show a significant growth in the MTHI that goes from 2.5 (slightly hot) under normal conditions to 3.4 (hot) during the heat wave period. This situation intensifies the environmental discomfort for visitors and highlights the necessity to enhance their adaptability to future temperature increases. In turn, it was found that the places most affected by heat waves are those that have grass cover or that have small associated buildings. Conversely, forested regions or those with lakes and/or ponds exhibit lower temperatures, which results in enhanced resilience. These findings are noteworthy in their concentration on one of the UK’s most severe heat waves and illustrate the efficacy of integrating spectral measurements with statistical analyses to formulate customized regional initiatives. Therefore, the results reported will allow the implementation of new planning and adaptation policies such as incorporating thermal comfort into planning processes, improving green and blue amenities, increasing tree densities that are resilient to rising temperatures, and increasing environmental comfort conditions in metropolitan forests. Finally, the applicability of this approach in similar urban contexts is highlighted.


  • Open Access

    Sustainable development goals at university: the technical architect and graduate in building as an agent of urban and architectural design

    by Antonio Espínola Jiménez, Francisco Javier Lafuente Bolívar, Jonathan Moreno Collado, David Hidalgo García

    The University, as a transmitter and driver of knowledge, plays a crucial role in achieving the Sustainable Development Goals (SDGs). SDG 4 focuses on ensuring ‘Quality Education’ and is the starting point for achieving the other SDGs. This study takes a journey through each SDG, highlighting the responsibility that Technical Architects or Graduates in Building have in all areas, especially in the area of Graphic Expression, as they are responsible for the design and implementation of urban and built environments and have a duty to ensure that they are sustainable, safe, accessible and inclusive. Furthermore, the presence of the SDGs in 21 degrees taught in Spanish universities is verified, showing limited research and scientific production and a reduced integration of the SDGs in teaching guides. It is concluded that there is a deficit in the development of competences related to the SDGs.

  • Open Access

    Safety culture and workers' perception of occupational hazard = Cultura de seguridad y percepción de riesgos laborales por parte de los trabajadores

    by Manuel Javier Martínez Carrillo, Nuria Mateo Lorente, Antonio Espínola Jiménez

    According to data published by the International Labor Organization (ILO, 2019), it is estimated that worldwide, one worker dies every 15 seconds due to work-related accidents or diseases, and that in the same period of time, 153 workers suffer an occupational accident. An increasing number of companies are concerned with creating a safe work environment. The term preventive culture or safety culture was used for the first time in 1988, in the report prepared by the nuclear safety investigation commission, after the Chernobyl nuclear accident, in present-day Ukraine (1986). As a result of this accident, it began to be raised that something was missing in the understan-ding and knowledge that was had up to that moment about the safety measures in the workplace. The general objective of this work is to analyze how workers of companies in charge of building maintenance perceive safety in their work environment. To do this, a diagnostic approach is made to the preventive culture of a group of workers dedicated to the maintenan-ce of building facilities. The perception of risk in the work environment is analyzed through the answers that each of these workers gives to the questions of the Nordic Occupational Safety Climate Questionnaire (NOSACQ-50-Spanish), a tool developed by a group of occupational health resear-chers from the five Nordic countries (Norway, Sweden, Finland, Denmark and Iceland), with the support of the Nordic Council of Minis-ters, which provides workers' impressions of safety in their workplace. Resumen Según los datos publicados por la Organización Internacional del Trabajo (OIT, 2019), se estima que a nivel mundial, muere un trabaja-dor cada 15 segundos a causa de accidentes o enfermedades relacionadas con el trabajo, y que en el mismo periodo de tiempo, 153 tra-bajadores sufren un accidente laboral. Cada vez es mayor el número de empresas que se preocupan por generar un entorno laboral seguro. El término cultura preventiva o cul-tura de seguridad se utilizó por primera vez en el año 1988, en el informe que elaboró la comisión de investigación de seguridad nuclear, tras el accidente nuclear de Chernóbil, en la actual Ucrania (1986). A raíz de este accidente, se empezó a plantear que algo fallaba en la comprensión y en los conocimientos que se tenían hasta ese momento sobre las medidas de seguridad en los lugares de trabajo. El objetivo general de este trabajo es analizar cómo perciben la seguridad en su entorno laboral los trabajadores de empresas encarga-das del mantenimiento de edificios. Para ello, se realiza una aproximación diagnóstica a la cultura preventiva de un grupo de trabajado-res dedicados al mantenimiento de las instalaciones de edificios. La percepción del riesgo en el entorno de trabajo, se analiza a través de las respuestas que cada uno de estos trabajadores, da a las pre-guntas del Cuestionario Nórdico de Clima de Seguridad Laboral (NOSACQ-50-Spanish), herramienta desarrollada por un grupo de inves-tigadores de salud laboral de los cinco países nórdicos (Noruega, Suecia, Finlandia, Dinamarca e Islandia), con el apoyo del Consejo Nórdico de Ministros, que permite conocer las impresiones de los trabajadores sobre la seguridad en su lugar de trabajo.


  • Open Access

    La accesibilidad en el entorno para personas con discapadidad auditiva

    by Antonio Espinola Jiménez, Pilar Bensusan Martín

    El confort acústico, la seguridad y la ergonomía de las personas con discapacidad auditiva en un entorno vienen determinadas por unas adecuadas condiciones de accesibilidad en el mismo. Estas condiciones eliminarán y/o evitarán de la mejor forma posible la presencia de condiciones discriminatorias.Las medidas a aplicar pueden variar según las necesidades y grado de discapacidad de cada persona, aunque también pueden ser válidas y útiles para la gran mayoría del colectivo y beneficiaras para el resto de la población, puesto que se basa en el principio del diseño para todos. Por tanto, es imprescindible tener en cuenta las condiciones del espacio y el entorno para poder realizar un estudio exhaustivo e implementar las medidas más adecuadas. No basta sólo con tener en cuenta los escasos criterios de accesibilidad que recoge la normativa vigente, sino que también, se deben estudiar aspectos relativos a los materiales de construcción, el diseño y distribución de los espacios, las condiciones del mobiliario, la iluminación, etc. En este trabajo se presentan todos los parámetros que son necesarios aplicar para que las condiciones de un entorno sean las más idóneas para una persona con discapacidad auditiva. Dichas medidas están avaladas y certificadas por la experiencia de usuarios con discapacidad auditiva y por diferentes estudios que verifican la idoneidad de las mismas.