Oumaima Echab
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Oumaima Echab has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Abdellatif Obbadi
Laboratory of Electronics, Instrumentation and Energy (LEIE), Faculty of Sciences, Chouaib Doukkali University , 24000 El Jadida
2 shared publications - Noureddine Ech-Cherki
Chouaib Doukkali University
2 shared publications Smail Sahnoun
Laboratory of Electronics, Instrumentation and Energy (LEIE), Faculty of Sciences, Chouaib Doukkali University , 24000 El Jadida
2 shared publications- Youssef Errami
Chouaib Doukkali University
2 shared publications Abdellatif Obbadi
1 shared publication- Charaf Hajjaj
Laboratory of Electronics, Instrumentation and Energy (LEIE), Faculty of Sciences, Chouaib Doukkali University , 24000 El Jadida
1 shared publication
Latest Publications
- 1 January 2026
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 18 (1)
A nonlinear integral sliding mode controller for optimizing the performance of a standalone PV system under partial shading conditions
Power generation from photovoltaic (PV) systems is strongly affected by partial shading conditions (PSC). Under PSC, the power–voltage characteristics of the PV system present several local maximum power points and a single global maximum power point, which complicates the extraction of the optimal operating point. Traditional maximum power point tracking algorithms have some limitations in the global maximum power point tracking (GMPPT). To overcome these limitations, this paper proposes a nonlinear integral sliding mode controller (ISMC) designed for GMPPT of a standalone PV system under PSC. This PV system is used to generate electricity for standalone sites via a boost converter. The PV system and the proposed control scheme were simulated in the MATLAB/Simulink environment. The performance of the proposed ISMC was compared to that of two conventional controllers, the Perturb and Observe algorithms, and the classic sliding mode controller in three PSC scenarios. The simulation results show that, in the three scenarios studied, the proposed ISMC improves the performance of the PV system under PCS in terms of reducing the chattering phenomenon and the dynamic response time. The ISMC also significantly reduces power overshoots during rapid variations in irradiation.
- 1 January 2026
- Published by AIP Publishing in Journal of Renewable and Sustainable Energy
- Vol. 18 (1)
A nonlinear integral sliding mode controller for optimizing the performance of a standalone PV system under partial shading conditions
Power generation from photovoltaic (PV) systems is strongly affected by partial shading conditions (PSC). Under PSC, the power–voltage characteristics of the PV system present several local maximum power points and a single global maximum power point, which complicates the extraction of the optimal operating point. Traditional maximum power point tracking algorithms have some limitations in the global maximum power point tracking (GMPPT). To overcome these limitations, this paper proposes a nonlinear integral sliding mode controller (ISMC) designed for GMPPT of a standalone PV system under PSC. This PV system is used to generate electricity for standalone sites via a boost converter. The PV system and the proposed control scheme were simulated in the MATLAB/Simulink environment. The performance of the proposed ISMC was compared to that of two conventional controllers, the Perturb and Observe algorithms, and the classic sliding mode controller in three PSC scenarios. The simulation results show that, in the three scenarios studied, the proposed ISMC improves the performance of the PV system under PCS in terms of reducing the chattering phenomenon and the dynamic response time. The ISMC also significantly reduces power overshoots during rapid variations in irradiation.
- Open Access
- 1 March 2025
- Published by Institute of Advanced Engineering and Science in International Journal of Applied Power Engineering (IJAPE)
- Vol. 14 (1) , 118-126
High order sliding mode control for grid integration of photovoltaic systems
The article suggests employing second-order sliding mode control (SOSMC) to manage photovoltaic systems (PVS) connected to the electrical grid. These systems face complexities due to non-linearities, variability, uncertainties, disturbances, and climate changes. The proposed control strategy utilizes two converters: one at the photovoltaic generator (PVG) side for maximum power point tracking (MPPT) to optimize energy generation and another at the grid connection point to regulate power injection into the grid and maintain the DC bus voltage (Vdc) while achieving unit power factor (UPF). Both converters are equipped with SOSMC controllers, enabling independent adjustment of active (P) and reactive (Q) power. This approach aims to enhance the energy efficiency and robustness of PVS under varying climatic conditions. The performance of the system is evaluated under standard and variable irradiation conditions using the MATLAB/Simulink environment. Simulation results indicate that SOSMC significantly improves system performance and efficiency compared to conventional vector control (CVC). Notably, it reduces active power overshoot by 100%, decreases Vdc response time, and lowers total harmonic distortion (THD) of the current to 1.19%, demonstrating its effectiveness across different irradiation levels.
- 1 March 2025
- Published by Institute of Advanced Engineering and Science in International Journal of Applied Power Engineering (IJAPE)
- Vol. 14 (1) , 118-126
Open AccessHigh order sliding mode control for grid integration of photovoltaic systems
The article suggests employing second-order sliding mode control (SOSMC) to manage photovoltaic systems (PVS) connected to the electrical grid. These systems face complexities due to non-linearities, variability, uncertainties, disturbances, and climate changes. The proposed control strategy utilizes two converters: one at the photovoltaic generator (PVG) side for maximum power point tracking (MPPT) to optimize energy generation and another at the grid connection point to regulate power injection into the grid and maintain the DC bus voltage (Vdc) while achieving unit power factor (UPF). Both converters are equipped with SOSMC controllers, enabling independent adjustment of active (P) and reactive (Q) power. This approach aims to enhance the energy efficiency and robustness of PVS under varying climatic conditions. The performance of the system is evaluated under standard and variable irradiation conditions using the MATLAB/Simulink environment. Simulation results indicate that SOSMC significantly improves system performance and efficiency compared to conventional vector control (CVC). Notably, it reduces active power overshoot by 100%, decreases Vdc response time, and lowers total harmonic distortion (THD) of the current to 1.19%, demonstrating its effectiveness across different irradiation levels.