Hao Hu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Hao Hu has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
Wei-Di Song
Anhui Provincial Key Laboratory of Environmental Pollution Control and Resource Reuse, School of Environment and Energy Engineering, Anhui Jianzhu University, Hefei, 230601, China
2 shared publicationsYankun Liu
Anhui Provincial Key Laboratory of Environmental Pollution Control and Resource Reuse, School of Environment and Energy Engineering, Anhui Jianzhu University, Hefei, 230601, PR China
2 shared publicationsZheng-Hao Li
State Key Laboratory of Advanced Environmental Technology, Department of Environmental Science and Engineering, University of Science and Technology of China, Hefei, 230026, China
2 shared publications- Zheng-Hao Li
State Key Laboratory of Advanced Environmental Technology, Department of Environmental Science and Engineering, University of Science and Technology of China, 230026, China
2 shared publications - Dan-Dan Wu
School of Municipal and Transportation Engineering, Anhui Water Conservancy Technical College, Hefei 231603, China
1 shared publication - Guo-Ping Sheng
University of Science and Technology of China
1 shared publication
Latest Publications
- 18 May 2026
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 31 (6) , 260149
Powdered activated carbon promotes sludge granulation and pollutant removal during the treatment of low-carbon-to-nitrogen ratio petrochemical wastewater
Aerobic granular sludge (AGS) slowly forms granules during the treatment of low-carbon/nitrogen ratio (low C/N ratio) petrochemical wastewater. This study investigated adding powdered activated carbon (PAC) to improve granulation during the treatment of low C/N ratio petrochemical wastewater. The optimal dosage for practical applications was also investigated. First, the activated sludge system (R1), a system with added PAC (R2), and a system with added Fe2+ (R3) were investigated. The results showed that by day 60, R2 had achieved complete granulation, while R1 and R3 had not. The control group without PAC (R1) and the groups supplemented with PAC (R2, R3, R4, and R5, with 0.5, 1, 2, and 3 g/L PAC, respectively) were studied. The results showed that on day 16, the average particle size of the groups with PAC exceeded 200 μm, while the group without PAC was only 99.9 μm. Moreover, R5 produced the largest particles and achieved COD and NH4+-N removal efficiencies of 86.6% and 98%, respectively. This study provides a practical reference for the application of PAC for treating low C/N ratio petrochemical wastewater.
- 18 May 2026
- Published by Korean Society of Environmental Engineering in Environmental Engineering Research
- Vol. 31 (6) , 260149
Powdered activated carbon promotes sludge granulation and pollutant removal during the treatment of low-carbon-to-nitrogen ratio petrochemical wastewater
Aerobic granular sludge (AGS) slowly forms granules during the treatment of low-carbon/nitrogen ratio (low C/N ratio) petrochemical wastewater. This study investigated adding powdered activated carbon (PAC) to improve granulation during the treatment of low C/N ratio petrochemical wastewater. The optimal dosage for practical applications was also investigated. First, the activated sludge system (R1), a system with added PAC (R2), and a system with added Fe2+ (R3) were investigated. The results showed that by day 60, R2 had achieved complete granulation, while R1 and R3 had not. The control group without PAC (R1) and the groups supplemented with PAC (R2, R3, R4, and R5, with 0.5, 1, 2, and 3 g/L PAC, respectively) were studied. The results showed that on day 16, the average particle size of the groups with PAC exceeded 200 μm, while the group without PAC was only 99.9 μm. Moreover, R5 produced the largest particles and achieved COD and NH4+-N removal efficiencies of 86.6% and 98%, respectively. This study provides a practical reference for the application of PAC for treating low C/N ratio petrochemical wastewater.
- 27 May 2025
- Published by Elsevier in Journal of Environmental Management
- Vol. 388, 125980
Enhanced deep denitrification for high-salinity wastewater treatment by constructing biofilm-based technology
- 27 May 2025
- Published by Elsevier in Journal of Environmental Management
- Vol. 388, 125980
Enhanced deep denitrification for high-salinity wastewater treatment by constructing biofilm-based technology
- 24 February 2025
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 49 (11) , 4512-4521
Enhanced removal of methylene blue using KMnO 4 -modified kitchen waste-derived lignin
Adsorption is considered a simple and efficient method for treating dye wastewater. However, poor adsorption capacity, high cost, and complex production processes significantly limit the widespread use of adsorption. Kitchen waste-derived lignin, an inert component, is challenging to treat and underutilized. Nevertheless, the presence of various functional groups in lignin makes it a potential adsorbent for organic pollutants. Therefore, kitchen waste-derived lignin adsorption enables efficient waste management and cost-effective pollutant removal. Herein, potassium permanganate-modified lignin powder (KMnO4-LP) was synthesized using methylene blue (MB) as a target pollutant and kitchen waste-derived lignin as a raw material. The effects of factors such as dosage, pH, contact time, and initial MB concentration on the adsorption capacity of KMnO4-LP were investigated. Batch experiments revealed that KMnO4-LP achieved an MB removal rate of 95.94% under optimal conditions (MB concentration of 50 mg L−1, KMnO4-LP dosage of 3 g L−1, and pH 13). The adsorption process was well described by the quasi-secondary kinetic and Langmuir isotherm models. KMnO4-LP exhibited a significantly higher maximum adsorption capacity (48.19 mg g−1) than the unmodified lignin (16.18 mg g−1). Thermodynamic analysis indicated that the negative ΔG values (−0.43, −0.87, and −6.33 kJ mol−1) and the positive ΔH value (86.66 kJ mol−1) indicated that the adsorption process was both spontaneous and endothermic. The adsorption site energy distribution highlighted that KMnO4-LP had a strong affinity for MB. After five regeneration cycles using NaOH solution as the desorbent, the removal efficiency of KMnO4-LP for MB decreased from 93.1% to 86.3%. This study indicates that KMnO4-lignin is an effective adsorbent for MB removal from water and provides novel insights into the coupling of MB removal with the utilization of kitchen waste-derived lignin.
- 24 February 2025
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 49 (11) , 4512-4521
Enhanced removal of methylene blue using KMnO 4 -modified kitchen waste-derived lignin
Adsorption is considered a simple and efficient method for treating dye wastewater. However, poor adsorption capacity, high cost, and complex production processes significantly limit the widespread use of adsorption. Kitchen waste-derived lignin, an inert component, is challenging to treat and underutilized. Nevertheless, the presence of various functional groups in lignin makes it a potential adsorbent for organic pollutants. Therefore, kitchen waste-derived lignin adsorption enables efficient waste management and cost-effective pollutant removal. Herein, potassium permanganate-modified lignin powder (KMnO4-LP) was synthesized using methylene blue (MB) as a target pollutant and kitchen waste-derived lignin as a raw material. The effects of factors such as dosage, pH, contact time, and initial MB concentration on the adsorption capacity of KMnO4-LP were investigated. Batch experiments revealed that KMnO4-LP achieved an MB removal rate of 95.94% under optimal conditions (MB concentration of 50 mg L−1, KMnO4-LP dosage of 3 g L−1, and pH 13). The adsorption process was well described by the quasi-secondary kinetic and Langmuir isotherm models. KMnO4-LP exhibited a significantly higher maximum adsorption capacity (48.19 mg g−1) than the unmodified lignin (16.18 mg g−1). Thermodynamic analysis indicated that the negative ΔG values (−0.43, −0.87, and −6.33 kJ mol−1) and the positive ΔH value (86.66 kJ mol−1) indicated that the adsorption process was both spontaneous and endothermic. The adsorption site energy distribution highlighted that KMnO4-LP had a strong affinity for MB. After five regeneration cycles using NaOH solution as the desorbent, the removal efficiency of KMnO4-LP for MB decreased from 93.1% to 86.3%. This study indicates that KMnO4-lignin is an effective adsorbent for MB removal from water and provides novel insights into the coupling of MB removal with the utilization of kitchen waste-derived lignin.