Hervé Coïc
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Hervé Coïc has a total of 50 co-authors. Here are the top co-authors by number of shared publications:
- Nathalie Blanchot
CEA CESTA , F-33116 Le Barp
3 shared publications - Claude Rouyer
CEA CESTA , F-33116 Le Barp
2 shared publications - Paul-Edouard Masson-Laborde
CEA, DAM, DIF 1 , F-91297 Arpajon
2 shared publications - A. Denoeud
CEA, DAM, DIF 1 , F-91297 Arpajon
1 shared publication A. Duval
CEA, DAM, DIF 1 , F-91297 Arpajon
1 shared publication- Adrien Fusaro
CEA, DAM, DIF 2 , F-91297 Arpajon
1 shared publication
Latest Publications
- 1 December 2025
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 96 (12)
Measuring the temporal contrast on the petawatt PETAL laser facility using a third-order cross-correlator diagnostic with 40 ps temporal range
In this paper, we present the architecture of a 40 ps, 107 dynamic range single-shot third-order cross-correlator for temporal contrast measurement of low repetition rate ultra-high intensity facilities. The cross-correlator employs a concatenation process to generate the complete 300 ps temporal contrast profile, using a limited number of shots. The shot-to-shot fluctuations in energy and pulse duration are deconvoluted. Simulations of the diagnostic’s achievable performance have been conducted, and an experimental demonstration is presented. The impact of phase and amplitude spectral defects on the diagnostic’s performance resolution will be discussed. To illustrate this point, a complete curve of the PETAL temporal contrast is obtained and discussed.
- 1 December 2025
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 96 (12)
Measuring the temporal contrast on the petawatt PETAL laser facility using a third-order cross-correlator diagnostic with 40 ps temporal range
In this paper, we present the architecture of a 40 ps, 107 dynamic range single-shot third-order cross-correlator for temporal contrast measurement of low repetition rate ultra-high intensity facilities. The cross-correlator employs a concatenation process to generate the complete 300 ps temporal contrast profile, using a limited number of shots. The shot-to-shot fluctuations in energy and pulse duration are deconvoluted. Simulations of the diagnostic’s achievable performance have been conducted, and an experimental demonstration is presented. The impact of phase and amplitude spectral defects on the diagnostic’s performance resolution will be discussed. To illustrate this point, a complete curve of the PETAL temporal contrast is obtained and discussed.
- Open Access
- 1 April 2025
- Published by AIP Publishing in Physics of Plasmas
- Vol. 32 (4)
Experimental and numerical characterization of high-energy point-like x-ray sources for radiography applications at the LMJ-PETAL laser facility
We report on high-energy point-like x-ray backlighters generated with the short-pulse PETawatt Aquitaine Laser (PETAL) for the purpose of radiography experiments. 25-μm-diameter Ag wire backlighters were used to image 100-μm-thick Au slabs. Three backlighter configurations have been investigated in which the wire is either fixed on a substrate or left free-standing and irradiated either at maximum (5.6×1018 W/cm2) or reduced laser intensity (1.6×1018 W/cm2). The best spatial resolution (∼26 μm) and contrast (∼0.29) are obtained close to the radiography axis of the free-standing wire backlighter. A simulation tool chain, including a radiative hydrodynamics code, a particle-in-cell code, and a Monte Carlo code, has been developed to model the radiography experiment, from the interaction of the PETAL beam with the backlighter and the emission of x rays to the generation of the radiography image. The simulated x-ray spectrum includes emission from the Ag K-lines and a two-temperature bremsstrahlung background (∼0.1 and 3 MeV). In order for the simulations to reproduce the experimental data, we find that it is necessary to account for the laser-accelerated electrons (few hundred keV to few MeV) hitting the detector, which contribute as much as 75% of the measured signal for the high-intensity shot. These electrons are the main cause of degradation of the radiography contrast compared to predictions with x rays only.
- 1 April 2025
- Published by AIP Publishing in Physics of Plasmas
- Vol. 32 (4)
Open AccessExperimental and numerical characterization of high-energy point-like x-ray sources for radiography applications at the LMJ-PETAL laser facility
We report on high-energy point-like x-ray backlighters generated with the short-pulse PETawatt Aquitaine Laser (PETAL) for the purpose of radiography experiments. 25-μm-diameter Ag wire backlighters were used to image 100-μm-thick Au slabs. Three backlighter configurations have been investigated in which the wire is either fixed on a substrate or left free-standing and irradiated either at maximum (5.6×1018 W/cm2) or reduced laser intensity (1.6×1018 W/cm2). The best spatial resolution (∼26 μm) and contrast (∼0.29) are obtained close to the radiography axis of the free-standing wire backlighter. A simulation tool chain, including a radiative hydrodynamics code, a particle-in-cell code, and a Monte Carlo code, has been developed to model the radiography experiment, from the interaction of the PETAL beam with the backlighter and the emission of x rays to the generation of the radiography image. The simulated x-ray spectrum includes emission from the Ag K-lines and a two-temperature bremsstrahlung background (∼0.1 and 3 MeV). In order for the simulations to reproduce the experimental data, we find that it is necessary to account for the laser-accelerated electrons (few hundred keV to few MeV) hitting the detector, which contribute as much as 75% of the measured signal for the high-intensity shot. These electrons are the main cause of degradation of the radiography contrast compared to predictions with x rays only.
- Open Access
- 1 March 2025
- Published by AIP Publishing in Physics of Plasmas
- Vol. 32 (3)
Stimulated Brillouin scattering dependence on polarization state, speckle shape, and polarization smoothing implementation
Laser beam smoothing is a key element to enhance laser plasma hydrodynamic coupling in the context of high energy density physics experiments carried out in Inertial Confinement Fusion Facilities. Here, we experimentally study the effects of different polarization smoothing implementations on the Stimulated Brillouin Backscattering (B-SBS) and the transmission of a laser beam using the LULI2000 laser facility. First, we show that the polarization state (linear or circular) has no effect on B-SBS and transmission. We also show that under our experimental conditions, both the statistical average laser power carried by the speckle spots and their statistical average shape provide information on the effectiveness of the laser beam smoothing configuration. These findings open new paths for the optimization of high-power laser beam smoothing techniques on existing and future laser facilities.
- 1 March 2025
- Published by AIP Publishing in Physics of Plasmas
- Vol. 32 (3)
Open AccessStimulated Brillouin scattering dependence on polarization state, speckle shape, and polarization smoothing implementation
Laser beam smoothing is a key element to enhance laser plasma hydrodynamic coupling in the context of high energy density physics experiments carried out in Inertial Confinement Fusion Facilities. Here, we experimentally study the effects of different polarization smoothing implementations on the Stimulated Brillouin Backscattering (B-SBS) and the transmission of a laser beam using the LULI2000 laser facility. First, we show that the polarization state (linear or circular) has no effect on B-SBS and transmission. We also show that under our experimental conditions, both the statistical average laser power carried by the speckle spots and their statistical average shape provide information on the effectiveness of the laser beam smoothing configuration. These findings open new paths for the optimization of high-power laser beam smoothing techniques on existing and future laser facilities.