Fangchao Ji
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Fangchao Ji has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Jia Liu
State Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xian Jiaotong University, Xian, China
1 shared publication - Jinjun Liu
State Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xian Jiaotong University, Xian, China
1 shared publication - Lilian Shi
Department of Electrical and Information Engineering, Shaoxing University, 508 Huancheng West Road, Shaoxing 312000, China
1 shared publication S. Liu
Aero-Power Sci-Tech Center, College of Automation Engineering, Nanjing University of Aeronautics and Astronautics, No.29 Yudao Street, Nanjing, Jiangsu Province 210016, People's Republic of China
1 shared publication- Xueqian Cao
Key Laboratory of Power Electronics and Electric Drive, Institute of Electrical Engineering, Chinese Academy of Sciences, Beijing, China
1 shared publication - Xuewen Li
State Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xian Jiaotong University, Xian, China
1 shared publication
Latest Publications
- 8 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 39 (8) , 10409-10423
A Single-Stage High-Frequency-Link Split-Phase Microinverter for Both Grid-Tied and Islanded Operation
High-frequency-link (HFL) inverters have drawn a lot of attention, owing to their high transformer utilization factor, bidirectional energy transfer, and easy implementation of soft switching. Therefore, HFL-based topologies might be a promising solution for the next-generation 600-W class microinverter. However, the utilization of HFL structures in split-phase systems, and the ability to operate in both grid-tied and islanded modes are rarely studied. Therefore, a novel single-stage high-frequency-link voltage-source microinverter with a split-phase structure is proposed in this paper. The proposed microinverter can provide a split-phase output voltage to match the single-phase three-wire distribution system. The two-phase output voltages can be balanced naturally without dedicated control. Meanwhile, all switches achieve soft-switching by the proposed secondary-side modulation (SSM) strategy. Owing to the voltage-source-inverter (VSI) feature, the proposed microinverter can be used in both grid-connected and islanded applications, of which the control strategy is also proposed in this paper. Finally, its dual-mode operation is validated via a 600-W/50-Hz prototype, with a peak efficiency of 94.6%.
- 8 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 39 (8) , 10409-10423
A Single-Stage High-Frequency-Link Split-Phase Microinverter for Both Grid-Tied and Islanded Operation
High-frequency-link (HFL) inverters have drawn a lot of attention, owing to their high transformer utilization factor, bidirectional energy transfer, and easy implementation of soft switching. Therefore, HFL-based topologies might be a promising solution for the next-generation 600-W class microinverter. However, the utilization of HFL structures in split-phase systems, and the ability to operate in both grid-tied and islanded modes are rarely studied. Therefore, a novel single-stage high-frequency-link voltage-source microinverter with a split-phase structure is proposed in this paper. The proposed microinverter can provide a split-phase output voltage to match the single-phase three-wire distribution system. The two-phase output voltages can be balanced naturally without dedicated control. Meanwhile, all switches achieve soft-switching by the proposed secondary-side modulation (SSM) strategy. Owing to the voltage-source-inverter (VSI) feature, the proposed microinverter can be used in both grid-connected and islanded applications, of which the control strategy is also proposed in this paper. Finally, its dual-mode operation is validated via a 600-W/50-Hz prototype, with a peak efficiency of 94.6%.
- 6 September 2012
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 5 (8) , 1535-1543
Mechanism and suppression countermeasure of voltage oscillation for full bridge converter
A phase-shift full-bridge zero-voltage-switching (ZVS) pulse-width-modulated (PWM) converter with commutation capacitor and inductor-capacitor (LC) auxiliary circuit is proposed. This converter contains the advantages of small rectifier voltage oscillation as well as no duty cycle loss, and realises ZVS for all primary switches over a wide load range. In this study, the mechanism of the rectifier voltage oscillation is discussed in detail. The operation principle of the circuit is described and design considerations of the converter are discussed. Finally, the experimental results from a 650 W/28 V, 100 kHz prototype are given to confirm the operation, validity and features of the proposed converter.
- 6 September 2012
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 5 (8) , 1535-1543
Mechanism and suppression countermeasure of voltage oscillation for full bridge converter
A phase-shift full-bridge zero-voltage-switching (ZVS) pulse-width-modulated (PWM) converter with commutation capacitor and inductor-capacitor (LC) auxiliary circuit is proposed. This converter contains the advantages of small rectifier voltage oscillation as well as no duty cycle loss, and realises ZVS for all primary switches over a wide load range. In this study, the mechanism of the rectifier voltage oscillation is discussed in detail. The operation principle of the circuit is described and design considerations of the converter are discussed. Finally, the experimental results from a 650 W/28 V, 100 kHz prototype are given to confirm the operation, validity and features of the proposed converter.