Tongshuai Wang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Tongshuai Wang has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
Han Song
2 shared publicationsJian-Qiang Wang
2 shared publicationsMiaomiao Liu
2 shared publications- Philip Jansson2 shared publications
- Shujuan Wang
State Key Laboratory of Advanced Special Steel and Shanghai Key Laboratory of Advanced Ferrometallurgy and School of Materials Science and Engineering, Shanghai University, Shanghai 200444, China
2 shared publications Tian Lan
2 shared publications
Latest Publications
- Open Access
- 11 September 2026
- Published by Elsevier in SSRN Electronic Journal
Membrane-Coated Electrocatalyst Stability During Hydrogen and Oxygen Evolution Reactions
Membrane-coated electrocatalysts (MCEs) offer a promising approach to improve reaction selectivity in electrochemical systems without the need for full-cell compartmentalization. In this study, we systematically examine the stability of Nafion-coated electrodes under conditions relevant to both cathodic and anodic reactions. For gas-evolving reactions, substrate roughness was found to be crucial for membrane adhesion and resistance to blistering, with a minimal average roughness (Ra) requirement identified between 0.15 and 0.49 µm for 1 µm coatings. Moderate increases in coating thickness can enhance performance by improving interconnectivity, while excessive thickness can undermine stability. Substrate composition had a lesser impact, though dissolution and surface chemistry likely remain important factors for long-term durability. Heat treatment above the Nafion glass transition temperature improved stability by allowing polymer chain rearrangement. Operational parameters such as current density showed surprisingly little influence within the tested range. Extending the research to direct seawater electrolysis (DSE), we demonstrate that Nafion-coated anodes markedly increase the selectivity for oxygen evolution over chlorine evolution, with positive implications for cathodic efficiency in less systems. Overall, these findings highlight how electrode morphology, polymer-membrane integrity, and operational stressors interact, providing practical guidance for designing stable, selective MCEs for industrial electrolysis.
- 11 September 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMembrane-Coated Electrocatalyst Stability During Hydrogen and Oxygen Evolution Reactions
Membrane-coated electrocatalysts (MCEs) offer a promising approach to improve reaction selectivity in electrochemical systems without the need for full-cell compartmentalization. In this study, we systematically examine the stability of Nafion-coated electrodes under conditions relevant to both cathodic and anodic reactions. For gas-evolving reactions, substrate roughness was found to be crucial for membrane adhesion and resistance to blistering, with a minimal average roughness (Ra) requirement identified between 0.15 and 0.49 µm for 1 µm coatings. Moderate increases in coating thickness can enhance performance by improving interconnectivity, while excessive thickness can undermine stability. Substrate composition had a lesser impact, though dissolution and surface chemistry likely remain important factors for long-term durability. Heat treatment above the Nafion glass transition temperature improved stability by allowing polymer chain rearrangement. Operational parameters such as current density showed surprisingly little influence within the tested range. Extending the research to direct seawater electrolysis (DSE), we demonstrate that Nafion-coated anodes markedly increase the selectivity for oxygen evolution over chlorine evolution, with positive implications for cathodic efficiency in less systems. Overall, these findings highlight how electrode morphology, polymer-membrane integrity, and operational stressors interact, providing practical guidance for designing stable, selective MCEs for industrial electrolysis.
- Open Access
- 1 May 2026
- Published by Elsevier in SSRN Electronic Journal
Mechanically Reinforced Anion Exchange Membranes via Polyimide Substrate Integration and Electron-Beam-Induced Crosslinking for Durable and Efficient Water Electrolysis
Anion exchange membrane water electrolysis (AEMWE) is attracting increasing attention as a cost-effective route for green hydrogen production. Here, we report a mechanically reinforced composite anion exchange membrane (AEM) prepared by infiltrating a poly(aryl piperidinium) ionomer into a porous polyimide (PI) substrate, followed by electron-beam-induced crosslinking. The PI substrate provides strong mechanical confinement, which effectively suppresses dimensional swelling while maintaining low water uptake. Electron-beam irradiation (EBI) further introduces internal crosslinking within the ionomer phase, strengthening the membrane and improving interfacial integrity. These combined effects mitigate short-circuiting issues observed in pristine polymer membranes and significantly enhance the electrolysis performance of membrane-electrode assemblies (MEAs). By optimizing the MEA architecture, the electrolyzer achieved a current density of 8 A cm⁻² at 1.98 V. Long-term durability tests demonstrated stable operation for over 1000 h at 1 A cm⁻² with negligible voltage decay. This work highlights the importance of structural reinforcement and crosslinking in achieving durable, high-performance AEMWE membranes suitable for practical hydrogen production.
- 1 May 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMechanically Reinforced Anion Exchange Membranes via Polyimide Substrate Integration and Electron-Beam-Induced Crosslinking for Durable and Efficient Water Electrolysis
Anion exchange membrane water electrolysis (AEMWE) is attracting increasing attention as a cost-effective route for green hydrogen production. Here, we report a mechanically reinforced composite anion exchange membrane (AEM) prepared by infiltrating a poly(aryl piperidinium) ionomer into a porous polyimide (PI) substrate, followed by electron-beam-induced crosslinking. The PI substrate provides strong mechanical confinement, which effectively suppresses dimensional swelling while maintaining low water uptake. Electron-beam irradiation (EBI) further introduces internal crosslinking within the ionomer phase, strengthening the membrane and improving interfacial integrity. These combined effects mitigate short-circuiting issues observed in pristine polymer membranes and significantly enhance the electrolysis performance of membrane-electrode assemblies (MEAs). By optimizing the MEA architecture, the electrolyzer achieved a current density of 8 A cm⁻² at 1.98 V. Long-term durability tests demonstrated stable operation for over 1000 h at 1 A cm⁻² with negligible voltage decay. This work highlights the importance of structural reinforcement and crosslinking in achieving durable, high-performance AEMWE membranes suitable for practical hydrogen production.
- Open Access
- 1 June 2024
- Published by Elsevier in Electrochimica Acta
- Vol. 497
Pilot-scale study of membrane-coated cathodes: Achieving high cathodic efficiency and outstanding stability in chlorate electrolysis
- 1 June 2024
- Published by Elsevier in Electrochimica Acta
- Vol. 497
Open AccessPilot-scale study of membrane-coated cathodes: Achieving high cathodic efficiency and outstanding stability in chlorate electrolysis
- 10 September 2021
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 139 (7) , 51628
Surface‐engineered Nafion/CNTs nanocomposite membrane with improved voltage efficiency for vanadium redox flow battery
A carbon nanotubes (CNTs) reinforced Nafion membrane (CNT/N) with reduced interfacial resistance was prepared and served as a promising ion exchange membrane for vanadium redox flow batteries (VRFBs). The reinforcement of CNT effectively enhanced the tensile properties of Nafion membranes. The electrochemical properties of CNT/N membrane were analyzed by electrochemical impedance spectroscopy (EIS) and fitted with an analytical model to investigate the ionic and interfacial resistances. The EIS measurement reveals that the exposed CNT on the composite membrane surface significantly reduced the interfacial resistance of the membrane. The VRFB single cell performance of the CNT/N shows higher voltage efficiency (93% vs 89%) and energy efficiency (86% vs 83%) than recast Nafion at a current density of 40 mA cm−2. The cycling stability measurement showed that the discharge capacity retention of the VRFB cell equipped with CNT/N was greatly enhanced. The results suggest that the incorporation of CNT in ion exchange membrane is an effective approach for achieving lower membrane bulky and interfacial resistance, and thus, improving capacity retention, voltage, and energy efficiency.
- 10 September 2021
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 139 (7) , 51628
Surface‐engineered Nafion/CNTs nanocomposite membrane with improved voltage efficiency for vanadium redox flow battery
A carbon nanotubes (CNTs) reinforced Nafion membrane (CNT/N) with reduced interfacial resistance was prepared and served as a promising ion exchange membrane for vanadium redox flow batteries (VRFBs). The reinforcement of CNT effectively enhanced the tensile properties of Nafion membranes. The electrochemical properties of CNT/N membrane were analyzed by electrochemical impedance spectroscopy (EIS) and fitted with an analytical model to investigate the ionic and interfacial resistances. The EIS measurement reveals that the exposed CNT on the composite membrane surface significantly reduced the interfacial resistance of the membrane. The VRFB single cell performance of the CNT/N shows higher voltage efficiency (93% vs 89%) and energy efficiency (86% vs 83%) than recast Nafion at a current density of 40 mA cm−2. The cycling stability measurement showed that the discharge capacity retention of the VRFB cell equipped with CNT/N was greatly enhanced. The results suggest that the incorporation of CNT in ion exchange membrane is an effective approach for achieving lower membrane bulky and interfacial resistance, and thus, improving capacity retention, voltage, and energy efficiency.
- 30 December 2016
- Published by The Membrane Society of Korea in Membrane Journal
- Vol. 26 (6) , 432-448
Recent Developments in Ion-Exchange Nanocomposite Membranes for Energy Applications
- 30 December 2016
- Published by The Membrane Society of Korea in Membrane Journal
- Vol. 26 (6) , 432-448
Recent Developments in Ion-Exchange Nanocomposite Membranes for Energy Applications