RPRoberto Carlos Pavan

Roberto Carlos Pavan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Roberto Carlos Pavan has a total of 6 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Analysis of soil-structure interaction in buildings with deep foundation

    by M. G. Ritter, M. L. Menegotto, M. F. Costella, R. C. Pavan, S. E. Pilz

    In this paper it is presented how the influence of soil-structure interaction (SSI) interferes on reinforced concrete structures in small buildings with deep foundations, with the objective of analyzing the influence of SSI on the loads and repressions, global stability and costs of materials. The analysis were based on numerical-computational simulations of a commercial building using CAD/TQS commercial software. The building was simulated with 4, 6 and 8 floors with 3 different profiles of soils, generating 8 case studies. When considering SSI, the loads and repressions did not present significant variations and the parameters of global instability were within the normative recommendations. Among the variables analyzed, the material cost of the structure was the least affected item with the SSI consideration.


  • Global stability analysis in reinforced concrete buildings with transfer beams

    by Sílvio E. Pilz, Rafael Ribeiro, Daniel Pilz, Roberto Carlos Pavan, Marcelo Fabiano Costella

    The influence of the presence of transfer beams on the global stability of symmetric and asymmetric reinforced concrete buildings was analysed through the global stability coefficient γzand the P–Δ method. Various combinations of structural models were considered (with many or few transfer beams, positioning the beams in the centre or at the ends of the building, with asymmetry in X and Y directions and symmetric models). According to their size and numerical proportions, the transfer beams were observed to either contribute or not to the improvement of the building's stability and to the decrease or increase of displacements. Asymmetries may stiffen a frame in the sense that they increase the inertia of the structure, but they cause a torsion effect whose magnitude depends on the side of the building to which wind is applied. In addition, the presence of asymmetries causes an increase in the global stability coefficient, producing a reduction in the structure's rigidity. When the transfer beams enabled a small ratio between the deformation and the span, an increase in global stability was observed, especially in the opposite direction to the axis of the beams.