Bianca Lamarche
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Bianca Lamarche has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Mary Kang
McGill University
2 shared publications Agus Sasmito
1 shared publicationAllan Fogwill
1 shared publicationDarian Vyriotes
1 shared publication- Jade Boutot
McGill University
1 shared publication Lucija Muehlenbachs
1 shared publication
Latest Publications
- Open Access
- 21 May 2026
- Published by IOP Publishing in Environmental Research Communications
- Vol. 8 (6)
Methane emission detections and emission rate indications using handheld sensors at non-producing oil and gas wells
Methane (CH4) is a potent greenhouse gas with large emissions from oil and gas infrastructure, including producing and non-producing wells. Non-producing oil and gas wells in Canada may contribute up to 13% of fugitive methane emissions from the oil and gas sector, yet there are challenges to cost-effective, fast, and reliable monitoring of the 425,000 non-producing wells in the country. This challenge is not unique to Canada, as there are ~4 million non-producing wells in the United States and millions more globally. Therefore, we evaluated methane screening measurements using a handheld device against direct emission rates, quantified using the static chamber method, at 200 wells in Alberta and Saskatchewan, Canada, and compared screening capabilities of two sensors at different price points in a controlled release setting. Screening was conducted using a portable methane detector that satisfies key elements of the United States (U.S.) Environmental Protection Agency Method 21. We found screening concentrations and emission rates were strongly correlated in Alberta and weakly correlated in Saskatchewan. Using a 10-ppm threshold, screening reliably detected medium (1,000-10,000 mg/h) and high (>10,000 mg/h) emitters with a 92% and 100% success rates, respectively. However, low emitters (<1,000 mg/h) were often missed, with only 24% detected at this threshold. Average daily wind speed showed limited influence on screening measurements at the 1% and 5% significance level, while maximum wind gust showed no effect on screening measurements. Both the higher-cost infrared absorption sensor and the lower-cost semiconductor metal oxide sensor effectively detected methane with screening concentrations above 10 ppm across flow rates ranging from 250 to 3,000 mg/h. Our findings indicate that handheld screening tools can serve as an effective screening approach to flagging high-emitting wells, which can be useful in environmental risk characterization and well plugging prioritization frameworks for state regulators and other stakeholders.
- 21 May 2026
- Published by IOP Publishing in Environmental Research Communications
- Vol. 8 (6)
Open AccessMethane emission detections and emission rate indications using handheld sensors at non-producing oil and gas wells
Methane (CH4) is a potent greenhouse gas with large emissions from oil and gas infrastructure, including producing and non-producing wells. Non-producing oil and gas wells in Canada may contribute up to 13% of fugitive methane emissions from the oil and gas sector, yet there are challenges to cost-effective, fast, and reliable monitoring of the 425,000 non-producing wells in the country. This challenge is not unique to Canada, as there are ~4 million non-producing wells in the United States and millions more globally. Therefore, we evaluated methane screening measurements using a handheld device against direct emission rates, quantified using the static chamber method, at 200 wells in Alberta and Saskatchewan, Canada, and compared screening capabilities of two sensors at different price points in a controlled release setting. Screening was conducted using a portable methane detector that satisfies key elements of the United States (U.S.) Environmental Protection Agency Method 21. We found screening concentrations and emission rates were strongly correlated in Alberta and weakly correlated in Saskatchewan. Using a 10-ppm threshold, screening reliably detected medium (1,000-10,000 mg/h) and high (>10,000 mg/h) emitters with a 92% and 100% success rates, respectively. However, low emitters (<1,000 mg/h) were often missed, with only 24% detected at this threshold. Average daily wind speed showed limited influence on screening measurements at the 1% and 5% significance level, while maximum wind gust showed no effect on screening measurements. Both the higher-cost infrared absorption sensor and the lower-cost semiconductor metal oxide sensor effectively detected methane with screening concentrations above 10 ppm across flow rates ranging from 250 to 3,000 mg/h. Our findings indicate that handheld screening tools can serve as an effective screening approach to flagging high-emitting wells, which can be useful in environmental risk characterization and well plugging prioritization frameworks for state regulators and other stakeholders.
- Open Access
- 18 March 2025
- Published by Copernicus GmbH
Converting Non-Producing Oil and Gas Wells for Geothermal Energy Production
Geothermal energy has gained significant attention over the years as a renewable alternative to traditional fossil fuel energy systems. Non-producing oil and gas wells may be repurposed as geothermal wells for heating or electricity generation. Converting non-producing oil and gas wells into geothermal energy production can offset the costs of drilling new geothermal wells and provide an incentive for remediating non-producing well sites. However, the absence of regulations for geothermal well conversion in North America and Europe leaves many unresolved questions about the ownership and financial responsibility of the wells. Here, we present an analysis of non-producing well attributes, such as depth, location, type, and proximity to geothermal boreholes, and well integrity indicators, including methane emission measurements and surface casing vent flows, to identify suitable sites for geothermal energy conversion in the United States and Canada. We also explore various case studies of geothermal well conversion from around the world, comparing different geothermal systems and their applicability to Canada. The findings from this research will be useful in supporting policy development and regulatory frameworks for geothermal conversion projects in Canada, the United States, and around the world.
- 18 March 2025
- Published by Copernicus GmbH
Open AccessConverting Non-Producing Oil and Gas Wells for Geothermal Energy Production
Geothermal energy has gained significant attention over the years as a renewable alternative to traditional fossil fuel energy systems. Non-producing oil and gas wells may be repurposed as geothermal wells for heating or electricity generation. Converting non-producing oil and gas wells into geothermal energy production can offset the costs of drilling new geothermal wells and provide an incentive for remediating non-producing well sites. However, the absence of regulations for geothermal well conversion in North America and Europe leaves many unresolved questions about the ownership and financial responsibility of the wells. Here, we present an analysis of non-producing well attributes, such as depth, location, type, and proximity to geothermal boreholes, and well integrity indicators, including methane emission measurements and surface casing vent flows, to identify suitable sites for geothermal energy conversion in the United States and Canada. We also explore various case studies of geothermal well conversion from around the world, comparing different geothermal systems and their applicability to Canada. The findings from this research will be useful in supporting policy development and regulatory frameworks for geothermal conversion projects in Canada, the United States, and around the world.