PBPreetaman Bajwa

Preetaman Bajwa

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Preetaman Bajwa has a total of 13 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Impact of irrigation levels on herbicide activity in the cotton production system

    by Jasleen Singh Makkar, Rupinder Saini, Preetaman Bajwa, Sukhbir Singh, Lindsey Slaughter, Glen Ritchie

    Cotton production in the Texas High Plains faces significant challenges due to water scarcity resulting from uneven rainfall patterns and declining levels of the Ogallala Aquifer. Deficit or reduced irrigation is one of the most common water management strategies to increase water use efficiency and cotton productivity in the region. However, deficit irrigation can affect the efficacy of herbicides on weeds. This study investigates how varying irrigation levels affect herbicide efficacy on weeds in cotton production systems. A 2-yr field study was conducted at Texas Tech University Quaker Research Farm in 2023 and 2024. The experiment was randomized three times in a split-plot design with two irrigation levels: I1 (100% crop evapotranspiration [ET c ] replacement) and I2 (50% ET c replacement) as the main plot factor and different preemergent and postemergent herbicide combinations as the subplot factor. Results indicated that reducing the irrigation level to I2 did not affect the total weed density or biomass production but resulted in decreased Palmer amaranth height and biomass production compared to I1. Among herbicide treatments, acetochlor, prometryn, or S -metolachlor applied preemergence followed by glyphosate + acetochlor, prometryn, or S -metolachlor applied postemergence provided the most effective weed control, reducing total weed density, Palmer amaranth weed density, and biomass compared with the untreated control and to preemergence herbicides applied alone. Although I2 resulted in lower plant height in both years than I1, it produced comparable cotton biomass and lint yield. Among the herbicide treatments, a preemergence application followed by a postemergence application of glyphosate + residual herbicide yielded significantly higher lint yield than the untreated control in both years. In conclusion, the study demonstrates that deficit irrigation is an effective water conservation technique that maintains cotton yield and herbicide efficacy. Additionally, using preemergence fb postemergence herbicide combinations, farmers can achieve effective weed control and sustain cotton productivity in semiarid regions.


  • Open Access

    Impact of planting dates and seeding densities on soil water depletion pattern, root distribution, and water productivity of industrial hemp

    by Preetaman Bajwa, Sukhbir Singh, Arjun Kafle, Manpreet Singh, Rupinder Saini, Calvin Trostle


  • Open Access

    Effect of early and late post emergence herbicides on weed suppression, crop injury, and biomass yield of industrial hemp in semiarid conditions

    by Preetaman Bajwa, Rupinder Saini, Sukhbir Singh, Jasleen Makkar, Calvin Trostle, Hardeep Singh

    Industrial hemp is receiving attention for its numerous benefits, particularly in the fiber industry. Weed competition is a primary concern for hemp cultivation, causing reduced yields and inferior‐quality fiber. However, little is known about herbicide application in hemp since a limited range of herbicides are available for hemp production. During 2023, this study evaluated the effect of different post‐emergence herbicides applied at early and late growth stages to optimize weed suppression and minimize crop injury in hemp under semiarid conditions. A randomized complete block design was used with six herbicide treatments, including early post (2 weeks after planting [WAP]) and late post (5 WAP) emergence applications of S ‐metolachlor, clopyralid, and ethalfluralin. Hemp plant stand showed no significant difference among treatments. Early post herbicide application reduced 86% of weed biomass compared to untreated control at 7 WAP. By 10 WAP, weed biomass became comparable across treatments. At harvest, untreated control recorded comparatively higher weed biomass than early post treatments and late post ethalfluralin. Plant height remained nonsignificant among treatments until 10 WAP. At harvest, control showed no variation with late post treatments but recorded an average of 63% lower plant height than early post applications. Hemp biomass was insignificantly affected by treatments at 10 WAP. However, on average, early post S ‐metolachlor and ethalfluralin applications demonstrated potential as effective herbicides, yielding four‐folds greater hemp biomass than untreated control at harvest. In conclusion, early post S ‐metolachlor and ethalfluralin are promising tools for weed control, enhancing crop competitiveness and yield in hemp cultivation.


  • Effect of planting dates and seeding densities on growth, physiology, and yield of industrial hemp

    by Preetaman Bajwa, Sukhbir Singh, Arjun Kafle, Rupinder Saini, Calvin Trostle

    Industrial hemp (Cannabis sativa L.) exhibits growth potential in water‐limited regions due to its deep roots and drought tolerance. However, limited knowledge exists about its agronomic production in semiarid West Texas. A 2‐year (2022–2023) field experiment evaluated the effect of planting dates (P1: April 19, P2: May 10, and P3: June 6) and seeding densities (SD1: 84500 seeds ha−1, SD2: 1,408,000 seeds ha−1, and SD3: 1,972,000 seeds ha−1) on the growth, physiology, and yield of hemp in a split‐plot block design. In both years, P3 reduced photosynthesis but increased transpiration compared to earlier plantings. In 2022, SD1 increased transpiration during the vegetative stage; however, no significant difference was observed during 2023. Photosynthesis remained consistent among densities throughout both years. In 2022, P2 accumulated 15%, 24%, 33%, and 43% greater plant height, biomass, bast fiber, and hurd fiber, respectively, but 45% lower grain yield than P3. In 2023, P1 and P2, on average, produced 32%, 175%, 149%, and 243% greater height, biomass, bast fiber, and hurd fiber than P3, respectively, while P2 accumulated 36% higher grain yield than P1 and 94% than P3. In 2022, SD3 had the highest bast, while hurd yield did not differ among densities. During 2023, SD3 produced the greatest bast and hurd fiber and significantly greater grain yield than SD1, with no variation with SD2. In conclusion, these findings suggest that early planting at higher seeding density can maximize resource use efficiency and production in West Texas. This makes them a viable strategy for sustainable hemp production under water‐limited conditions.