BJBiao Jiang

Biao Jiang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Biao Jiang has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Three-Dimensional Printing of Rigid–Flexible Ceramic–Epoxy Composites with Excellent Mechanical Properties

    by Zhaozhi Wang, Biao Jiang, Yajie Liu, Zhiheng Xin, Zhibin Jiao

    Inspired by the Bouligand structure of the mantis shrimp’s dactyl club, in this study, we employed direct ink writing 3D printing technology to fabricate bioinspired gradient ceramic samples with varying gradient spacings and rotation angles. A rigid–flexible coupled bioinspired gradient ceramic–epoxy resin composite was successfully constructed based on epoxy resin infiltration. The effects of gradient variations and rotation angles on mechanical properties were systematically investigated with flexural strength and fracture toughness tests. The experimental results revealed that, at a fixed rotation angle, both the flexural strength and fracture toughness initially increased and then decreased with an increase in gradient spacing. The infiltration of epoxy resin significantly enhanced the mechanical performance of the composite samples. Specifically, the maximum flexural strength of 63.35 MPa was achieved at Δd = 0.08 and a rotation angle of 12°, while the highest fracture toughness of 2 MPa/m2 was observed at Δd = 0.1 and a rotation angle of 12°. A failure analysis indicated that the introduction of gradient structures and epoxy resin infiltration altered the failure forms of traditional ceramics, with the primary toughening mechanisms including crack deflection, fiber pull-out, and crack branching. In this study, we successfully developed a rigid–flexible coupled bioinspired gradient ceramic–epoxy resin composite with excellent mechanical properties based on bioinspired design and gradient optimization, providing new insights and methodologies for the design and fabrication of high-performance ceramic materials.


  • Open Access

    Three-Dimensional-Printed Biomimetic Structural Ceramics with Excellent Tribological Properties

    by Zhaozhi Wang, Yajie Liu, Biao Jiang, Zhiheng Xin, Zhibin Jiao

    Inspired by the ventral scale structure of the oriental sand boa, this study successfully fabricated multiscale bioinspired alumina (Al2O3) ceramics by combining the excellent mechanical properties, high-temperature resistance, and high hardness of ceramic composites with direct ink writing (DIW) 3D printing technology and femtosecond laser processing. A MoS2 thin film was then deposited on the ceramic surface via radio frequency magnetron sputtering (PVD) to systematically investigate the impact of bioinspired structures on the tribological properties of ceramic composites under both dry and lubricated conditions. Experimental results demonstrated that bioinspired structures at different scales exhibited significant friction-reducing and wear-resistant characteristics compared to blank structures. Specifically, under room-temperature conditions, the friction coefficients of bioinspired ceramic composites with solid lubricants and oil lubrication were 0.3 and 0.148, respectively, indicating excellent tribological performance. These findings confirm the synergistic lubrication effect between bioinspired structures, two-dimensional solid lubricants, and lubricating oil, which significantly enhanced the friction-reducing and wear-resistant properties of ceramic components. Therefore, the synergistic design of multiscale bioinspired structures and solid lubricants provides an innovative strategy for the advanced application of ceramic components.