Ana Borissova

Modern energy systems demand improved efficiency and reduced carbon emissions, motivating ongoing efforts to optimize nuclear power plants. A central element of steam turbine systems is the regenerative feedwater heating system, which increases the cycle efficiency by using extracted steam to preheat water. However, this approach also consumes working steam that could otherwise contribute to additional power generation, suggesting potential - though not guaranteed - room for improvement. This study explores the feasibility of integrating solar thermal energy, particularly from concentrated solar power systems, as a replacement heat source for low-pressure heaters.

One of the approaches to limit the negative impact on the environment from the burning of coal in the production of heat and electricity is to limit their use by blending them with biomass. Blended fuel combustion leads to the generation of a solid ash residue differing in composition from coal ash, and opportunities for its utilization have not yet been studied. The present paper provides results on the carbon capture potential of adsorbents developed through the alkaline conversion of ash mixtures from the combustion of lignite and biomass from agricultural plants and wood. The raw materials and the obtained adsorbents were studied with respect to the following: their chemical and phase composition based on Atomic Absorption Spectroscopy with Inductively Coupled Plasma (AAS-ICP) and X-ray powder diffraction (XRD), respectively, morphology based on scanning electron spectroscopy (SEM), thermal properties based on thermal analysis (TG and DTG), surface parameters based on N₂ physisorption, and the type of metal oxides within the adsorbents based on temperature-programmed reduction (TPR) and UV-VIS spectroscopy. The adsorption capacity toward CO₂ was studied in dynamic conditions and the obtained results were compared to those of zeolite-like CO₂ adsorbents developed through the utilization of the raw coal ash. It was observed that the adsorbents based on ash of blended fuel have a comparable carbon capture potential with coal fly ash zeolites despite their lower specific surface areas due to their compositional specifics and that they could be successfully applied as adsorbents in post-combustion carbon capture systems.

This article proposes a combination of nuclear power plant and grid-scale energy storage, classified as Carnot battery. The electric heater heats molten salts when excess electricity is available in the grid. The steam that is produced in a small modular nuclear reactor is heated with hot molten salts in the external super-heater. For continuous superheating to be ensured, the plant is equipped with molten salt thermal energy storage. The combined plant and reference NPP are modelled and simulated at steady-state conditions. Due to the higher turbine inlet temperature, the efficiency of the combined generation-storage nuclear plant is substantially improved. The proposed concept makes the co-location of NPP and Carnot Battery more attractive than the separate plants. The integrated thermal storage acts as secondary electricity storage. As such, it surpasses compressed air storage and is competitive with the pumped hydro storage, in the absence of their geographical and environmental constraints.

This paper proposes a combination of a nuclear and a concentrated solar power (CSP) plant. Most of today’s operating nuclear reactor systems are producing saturated steam at relatively low pressure. This, in turn, limits their thermodynamic efficiency. Superheating of nuclear steam with solar thermal energy has the potential to overcome this drawback. An innovative configuration of a hybrid nuclear-CSP plant is assembled and simulated. It brings together a small pressurised water reactor and a parabolic trough solar field. The solar heat is transferred to nuclear steam to raise its temperature. Continuous superheating is provided through molten salts-based thermal energy storage (TES). The results from design point calculations show that solar superheating has the potential to increase nuclear plant electric efficiency significantly. Solar heat to electricity conversion efficiency defined as the ratio of extra generated power to collected solar energy reaches unprecedented rates of 52%. An off-design model was used to simulate 24-h operation for one year by simulating 8760 cases. Due to TES non-stop operation is manageable. Abbreviations: CSP: concentrated solar power; DNI: direct normal irradiation; FR: Fresnel reflectors; HP: high pressure; HTF: heat transfer fluid; NPP: nuclear power plant; PT: parabolic trough; PV: photovoltaic; PWR: pressurised water reactor; RPV: reactor pressure vessel; SANPP: solar-assisted nuclear power plant; SM: solar multiple; SMR: small modular reactor; ST: solar tower; TES: thermal energy storage