Cláudia de Magalhães Santos Fonseca
Research Subjects
Cláudia de Magalhães Santos Fonseca has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Benigno Rodríguez
Universidad de la República (UDELAR)
4 shared publications - Chryslène Marilande Merveilles Adetonah
Federal University of Juiz de Fora,Department of Electric Energy,Juiz de Fora,Brazil
4 shared publications - Luís Guilherme da Silva Costa
Department of Electrical Engineering, Federal University of Juiz de Fora, Juiz de Fora 36036-900, Brazil
4 shared publications - Moises Vidal Ribeiro
UFJF
4 shared publications - Glaucio Lopes Ramos
Federal University of São João Del-Rei, DETEM–PPGEL
1 shared publication - Marco Aurelio Oliveira Schroeder
Department of Electrical Engineering, Federal University of São João del-Rei (UFSJ), São João del-Rei 36307-352, Brazil
1 shared publication
Latest Publications
- 22 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Effect of a Liquid Rectangular Prism Dielectric Resonator on the Patch Antenna Performance
This paper numerically investigates the effect of a rectangular prism dielectric resonator, filled with distilled water, deionized water, seawater, and glycerin, on a 2.45 GHz FR-4 rectangular patch antenna. Results show that distilled water and glycerin provide the best performance, seawater the worst due to high conductivity, and deionized water an intermediate behavior.
- 22 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Effect of a Liquid Rectangular Prism Dielectric Resonator on the Patch Antenna Performance
This paper numerically investigates the effect of a rectangular prism dielectric resonator, filled with distilled water, deionized water, seawater, and glycerin, on a 2.45 GHz FR-4 rectangular patch antenna. Results show that distilled water and glycerin provide the best performance, seawater the worst due to high conductivity, and deionized water an intermediate behavior.
- 22 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Design of Rectangular Patch Antenna and Low-Pass Filter for Energy Harvesting at 2.45 Ghz
This work addresses the design of an integrated rectangular patch antenna with a stepped-impedance low-pass filter for RF energy harvesting at 2.45 GHz, implemented on an FR-4 substrate and simulated in CST Microwave Studio. After optimization, the integrated structure still operates at 2.45 GHz ( | S 11 | < − 10 dB ) with a realized gain of 3 dBi. The results indicate that integrating the stepped-impedance LPF into the feedline maintains radiating performance while providing a compact RF front-end with out-of-band attenuation for energyharvesting receivers.
- 22 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE)
Design of Rectangular Patch Antenna and Low-Pass Filter for Energy Harvesting at 2.45 Ghz
This work addresses the design of an integrated rectangular patch antenna with a stepped-impedance low-pass filter for RF energy harvesting at 2.45 GHz, implemented on an FR-4 substrate and simulated in CST Microwave Studio. After optimization, the integrated structure still operates at 2.45 GHz ( | S 11 | < − 10 dB ) with a realized gain of 3 dBi. The results indicate that integrating the stepped-impedance LPF into the feedline maintains radiating performance while providing a compact RF front-end with out-of-band attenuation for energyharvesting receivers.
- 22 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE)
A Prototype of a Patch Antenna Array for Ground-to-Ground Wireless Power Transfer
This paper focuses on the design and experimental validation of a 2 × 2 patch antenna array for ground-to-ground wireless power transfer at 2.4 GHz. The antenna, implemented on a Rogers RO4725JXR substrate, was optimized in CST Microwave Studio Suite for impedance matching, gain, and radiation efficiency. Measurements show a minimum reflection coefficient of − 38.32 d B at 2.425 G H z and a − 10 d B bandwidth of 33 MHz, validating the agreement with simulations.
- 22 February 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE)
A Prototype of a Patch Antenna Array for Ground-to-Ground Wireless Power Transfer
This paper focuses on the design and experimental validation of a 2 × 2 patch antenna array for ground-to-ground wireless power transfer at 2.4 GHz. The antenna, implemented on a Rogers RO4725JXR substrate, was optimized in CST Microwave Studio Suite for impedance matching, gain, and radiation efficiency. Measurements show a minimum reflection coefficient of − 38.32 d B at 2.425 G H z and a − 10 d B bandwidth of 33 MHz, validating the agreement with simulations.
- Open Access
- 9 April 2025
- Published by MDPI AG in Electronics
- Vol. 14 (8) , 1521
Improving Patch Antenna Performance Through Resonators: Insights into and Benefits of Dielectric and Conductive Materials and Geometric Shapes
This paper investigates the usefulness of combining dielectric and conductive materials with various geometries to build resonators and enhance patch antenna performance when considering the decoupled design approach. Three materials (distilled water, glycerin, and graphite) and fifteen geometries are considered. The obtained results through numerical simulations show how the selected materials and geometries can be combined to strategically design resonators that can effectively confine electromagnetic fields, shift the resonant frequency, improve antenna directionality and effective gain, facilitate multi-band operation, broaden the bandwidth, and improve impedance matching and the radiation pattern. Overall, the analyses and discussions offer insights and guidelines for combining dielectric and conductive materials with several geometries to build a resonator that can improve patch antenna performance when a low-quality substrate is considered.
- 9 April 2025
- Published by MDPI AG in Electronics
- Vol. 14 (8) , 1521
Open AccessImproving Patch Antenna Performance Through Resonators: Insights into and Benefits of Dielectric and Conductive Materials and Geometric Shapes
This paper investigates the usefulness of combining dielectric and conductive materials with various geometries to build resonators and enhance patch antenna performance when considering the decoupled design approach. Three materials (distilled water, glycerin, and graphite) and fifteen geometries are considered. The obtained results through numerical simulations show how the selected materials and geometries can be combined to strategically design resonators that can effectively confine electromagnetic fields, shift the resonant frequency, improve antenna directionality and effective gain, facilitate multi-band operation, broaden the bandwidth, and improve impedance matching and the radiation pattern. Overall, the analyses and discussions offer insights and guidelines for combining dielectric and conductive materials with several geometries to build a resonator that can improve patch antenna performance when a low-quality substrate is considered.