AMAlena Vadimovna Melnikova

Alena Vadimovna Melnikova

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Alena Vadimovna Melnikova has a total of 4 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    HDPE Properties Evaluation via Instrumented Indentation: Experimental and Computer Simulation Approach

    by Anna Aleksandrovna Vinogradova, Kirill Valerievich Gogolinskiy, Kirill Igorevich Doronin, Ekaterina Konstantinovna Shchiptsova, Alena Vadimovna Melnikova

    The paper analyzes the process of indentation of polymeric materials with a spherical indenter. The loading diagrams P(h) obtained experimentally and by means of finite element method (FEM) are analyzed. The material under study was high-density polyethylene (HDPE) of PE100 grade, taken from a pipeline for gas distribution systems. The aim of the work was to determine the parameters of the computer model, taking into account hardening and creep processes when verifying P(h) diagrams with experimental studies. The influence of variation of the parameters of the calculation formulas on the reliability of the simulation results was analyzed. The results of the calculation of mechanical properties of material on the basis of P(h) diagrams by the Oliver–Pharr method for model and experimental diagrams were compared. The possibility of using computer modeling for the analysis of instrumented indentation processes is demonstrated, since the results revealed the convergence of the elastic modulus of 1078 GPa for FEM and 1083 GPa for the experiment. The conformity of the Oliver–Pharr method for determining the contact depth is also shown, which differed from the model geometry by only 2.3%. Simulation of the indentation process using the Norton model via FEM, as well as determining the parameters of the material deformation function while taking creep into account, makes it possible to describe the process of contact interaction and shows good agreement with experimental data.


  • Open Access

    Using the LABVIEW software package to automate production and research tasks

    by A V Melnikova

    Currently, improving the quality indicators of mass production and consumer goods is impossible without the use of modern software systems, means and methods of automation. The main systems capable of satisfying the tasks of modern enterprises and scientific organizations include Scada-systems, which provide the necessary control accuracy and versatility in conditions of low costs for additional staff training. Consider the prospects for improving the technical and economic indicators of metallurgical and chemical enterprises through the introduction of automation, on the example of the operation of concentration plants. Obviously, the main tool to increase the economic efficiency of production is to reduce various types of costs. Among the main cost items, fuel, feedstock and chemical reagents are distinguished, however, the undisputed leader is the cost of electricity, the work of the mills needed to grind the feedstock. On the other hand, the problem of timely and quick diagnosis of the internal components of the mills and the ability to choose the optimal mode of operation are also relevant tasks. These reasons significantly affect such process indicators as the quality of the crushed raw materials, the energy efficiency of the grinding process, reducing the cost of the production cycle, etc. To control the processes of grinding, loading of raw materials, monitoring the filling of the drum, the use of vibroacoustic primary transducers installed on the housing of the axle bearing of the drum mill is promising.