Jia-Qi Chen
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jia-Qi Chen has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Alastair R. Ruddle
Vehicle Resilience Technologies VRES, Horiba-MIRA,England, United Kingdom
1 shared publication Caleb S. Brooks
Department of Nuclear, Plasma, and Radiological Engineering, University of Illinois at Urbana-Champaign, Urbana, USA
1 shared publication- Giwoong Yun
Seoul National University, Korea
1 shared publication Li Xiangyu
1 shared publicationTan Xuefeng
1 shared publication- Yu Xian Teo
HORIBA MIRA Limited, Nuneaton, UK
1 shared publication
Latest Publications
- 4 September 2025
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 226
Analysis of critical heat flux in vertically upward narrow rectangular channel under high pressure
- 4 September 2025
- Published by Elsevier in Annals of Nuclear Energy
- Vol. 226
Analysis of critical heat flux in vertically upward narrow rectangular channel under high pressure
- 18 April 2025
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 36 (6) , 1-20
Validation and application of a coupled xenon-transport and reactor dynamic model of Molten-salt reactor experiment
- 18 April 2025
- Published by Springer Nature in Nuclear Science and Techniques
- Vol. 36 (6) , 1-20
Validation and application of a coupled xenon-transport and reactor dynamic model of Molten-salt reactor experiment
- 1 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Simulating RF Impedance and High-Voltage to Low-Voltage Coupling in Automotive Traction Batteries
Representation of the RF impedance properties of 18650 cells using a hybrid simulation approach has enabled the development of simple and efficient 3D electromagnetic models of a representative shielded multi-cell battery module over the frequency range from 100 kHz to 200 MHz. A behavioural model derived from the single module simulation has also been used to facilitate modelling of a representative larger scale multi-module battery assembly in order to demonstrate the simulation of radiofrequency impedance, as well as the coupling between the high-voltage and low-voltage power networks within a battery.
- 1 August 2018
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Simulating RF Impedance and High-Voltage to Low-Voltage Coupling in Automotive Traction Batteries
Representation of the RF impedance properties of 18650 cells using a hybrid simulation approach has enabled the development of simple and efficient 3D electromagnetic models of a representative shielded multi-cell battery module over the frequency range from 100 kHz to 200 MHz. A behavioural model derived from the single module simulation has also been used to facilitate modelling of a representative larger scale multi-module battery assembly in order to demonstrate the simulation of radiofrequency impedance, as well as the coupling between the high-voltage and low-voltage power networks within a battery.