Anil Kumar
Research Subjects
Anil Kumar has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
Niharika Bhawsar
Department of Zoology Govt. Narmada College Narmadapuram Madhya Pradesh India
2 shared publicationsBharat Pendram
Department of Zoology University of Allahabad Prayagraj Uttar Pradesh India
1 shared publicationBijendar Singh
Department of Chemistry HBTU Kanpur UP India
1 shared publicationDaoud Ali
Department of Zoology College of Science, King Saud University Riyadh Saudi Arabia
1 shared publication- Dhananjoy Mondal
School of Chemical Sciences, Central University of Gujarat, Vadodara, 391107, India
1 shared publication G. M. Srivastava
Department of Botany and Zoology Govt. Tilak P G College Katni Madhya Pradesh India
1 shared publication
Latest Publications
- Open Access
- 18 April 2025
- Published by Wiley in Food Science & Nutrition
- Vol. 13 (4) , e70090
Extraction and Optimization of Lycopene From Selected Fruits and Their Assessment as an Ultraviolet Ray Protectant for Escherichia coli
Lycopene is known for protecting the skin from harmful UV rays, which is why it is widely used in cosmetics. In the present investigation, fruits and vegetables like Capsicum annuum ( C.a. ), Capsicum frutescens ( C.f. ), Carica papaya ( C. p. ), Citrullus lanatus ( C. l. ), and Solanum lycopersicum ( S. l. ) were used for the extraction and isolation of lycopene. The lycopene was isolated in acetone to solubilize hydrophilic and hydrophobic molecules and hydrolyzed into 5% sodium sulfate in a protic solvent mechanism. The measurement of lycopene content was done by UV–Vis spectrophotometer at 503 nm ( λ ), and the absence peak was in the range of 440–530 nm for the extracted lycopene. Furthermore, all the Petri plates were coated with a film of lycopene extracted at different concentrations on the bottom surface of the lid of the Petri plate. The concentrations of lycopene present in the samples were in the following ascending order from lowest to highest concentration: ( C.a. ) < ( C.f. ) < ( C. p. ) < ( C. l. ) < ( S. l. ). The pH value of the S. lycopersicum ( S. l. ) sample was found to be 6.2, the maximum amount of lycopene was found to be 3.36024 μg/mL, and the pH value of the C. annuum ( C.a. ) sample was found to be 4.5 and the minimum amount. Lycopene was found to be 0.31824 μg/mL. The R‐square of the obtained pH value was increased with the adequate amount of lycopene of good quality; the correlation variables between the pH value and lycopene percentage remained the same using the equation y = 56.60×−250.5, and their R 2 value was 1 > 0.968, found to be degraded, and lycopene percentage was calculated. Escherichia coli colonies protected from UV rays by lycopene film were counted after different intervals (24, 48, and 72 h). The effect of UV rays was measured in percentage at 10, 20, and 30 min of exposure to UV rays. Sample S. lycopersicum had the highest UV‐ray blocking potential, that is, 99.75%, and sample C. annuum had the lowest UV‐ray blocking percentage, that is, 77.78%. Further research and development will be required to determine its effectiveness, stability, and practicality for creating lycopene films as a barrier against UV rays.
- 18 April 2025
- Published by Wiley in Food Science & Nutrition
- Vol. 13 (4) , e70090
Open AccessExtraction and Optimization of Lycopene From Selected Fruits and Their Assessment as an Ultraviolet Ray Protectant for Escherichia coli
Lycopene is known for protecting the skin from harmful UV rays, which is why it is widely used in cosmetics. In the present investigation, fruits and vegetables like Capsicum annuum ( C.a. ), Capsicum frutescens ( C.f. ), Carica papaya ( C. p. ), Citrullus lanatus ( C. l. ), and Solanum lycopersicum ( S. l. ) were used for the extraction and isolation of lycopene. The lycopene was isolated in acetone to solubilize hydrophilic and hydrophobic molecules and hydrolyzed into 5% sodium sulfate in a protic solvent mechanism. The measurement of lycopene content was done by UV–Vis spectrophotometer at 503 nm ( λ ), and the absence peak was in the range of 440–530 nm for the extracted lycopene. Furthermore, all the Petri plates were coated with a film of lycopene extracted at different concentrations on the bottom surface of the lid of the Petri plate. The concentrations of lycopene present in the samples were in the following ascending order from lowest to highest concentration: ( C.a. ) < ( C.f. ) < ( C. p. ) < ( C. l. ) < ( S. l. ). The pH value of the S. lycopersicum ( S. l. ) sample was found to be 6.2, the maximum amount of lycopene was found to be 3.36024 μg/mL, and the pH value of the C. annuum ( C.a. ) sample was found to be 4.5 and the minimum amount. Lycopene was found to be 0.31824 μg/mL. The R‐square of the obtained pH value was increased with the adequate amount of lycopene of good quality; the correlation variables between the pH value and lycopene percentage remained the same using the equation y = 56.60×−250.5, and their R 2 value was 1 > 0.968, found to be degraded, and lycopene percentage was calculated. Escherichia coli colonies protected from UV rays by lycopene film were counted after different intervals (24, 48, and 72 h). The effect of UV rays was measured in percentage at 10, 20, and 30 min of exposure to UV rays. Sample S. lycopersicum had the highest UV‐ray blocking potential, that is, 99.75%, and sample C. annuum had the lowest UV‐ray blocking percentage, that is, 77.78%. Further research and development will be required to determine its effectiveness, stability, and practicality for creating lycopene films as a barrier against UV rays.
- Open Access
- 20 December 2023
- Published by SCI AND TECH UNIVERSAL INC in Scientia Iranica
Synthesis of Hybrid Se-SiNPs Nanoparticle for the Studies of Cellular Toxicity against Breast Cancer Cell Line MCF-7
A hybrid nanocomposite of biologically compatible silica nanoparticles (SiNPs) coated with selenium nanoparticles (SeNPs) was developed and evaluated for cytotoxicity on the breast cancer cell line using MTT assay methods. The hybrid nanoparticles were characterized by DLS, XRD and SEM spectroscopy. The size and size distribution of SiNPs and composite Se-SiNPs nanoparticles determined by DLS experiment are SiNPs and Se-SiNPs 23.85 and 89.9 nm in diameter respectively. The Se-SiNPs hybrid nanomaterials showed higher cytotoxicity than pure SiNPs against the breast cancer cell line MCF-7. When compared to SiNPs, composite Se-SiNPs suppressed the growth of the breast cancer cell line MCF-7.
- 20 December 2023
- Published by SCI AND TECH UNIVERSAL INC in Scientia Iranica
Open AccessSynthesis of Hybrid Se-SiNPs Nanoparticle for the Studies of Cellular Toxicity against Breast Cancer Cell Line MCF-7
A hybrid nanocomposite of biologically compatible silica nanoparticles (SiNPs) coated with selenium nanoparticles (SeNPs) was developed and evaluated for cytotoxicity on the breast cancer cell line using MTT assay methods. The hybrid nanoparticles were characterized by DLS, XRD and SEM spectroscopy. The size and size distribution of SiNPs and composite Se-SiNPs nanoparticles determined by DLS experiment are SiNPs and Se-SiNPs 23.85 and 89.9 nm in diameter respectively. The Se-SiNPs hybrid nanomaterials showed higher cytotoxicity than pure SiNPs against the breast cancer cell line MCF-7. When compared to SiNPs, composite Se-SiNPs suppressed the growth of the breast cancer cell line MCF-7.
- Open Access
- 14 November 2023
- Published by Austin Publishing Group in Austin Journal of Nanomedicine & Nanotechnology
- Vol. 11 (1)
Biomedical Relevance of Biological Smart Materials Approach for Synthesis of Selenium Nanoparticles by Agrobacterium
Nanotechnologies are making more efforts to develop new materials to use in different ways to be beneficial to human life. Their unique properties are constantly being improved to enhance more effective and perfect activity as per the requirement. Researchers are continuously producing highly useful materials with the help of different types of microorganisms and green technology for the synthesis of nanoparticles as per the requirement. Primarily Agrobacterium species are the most useful microorganisms for the synthesis of selenium nanoparticles in the diameter range of nanoscale. These are capable and more effective in making nanomaterials from selenium to use in medicinal and other applications. These are opening a new dimension in the field of medical science which is beneficial for multipurpose use directly or indirectly.
- 14 November 2023
- Published by Austin Publishing Group in Austin Journal of Nanomedicine & Nanotechnology
- Vol. 11 (1)
Open AccessBiomedical Relevance of Biological Smart Materials Approach for Synthesis of Selenium Nanoparticles by Agrobacterium
Nanotechnologies are making more efforts to develop new materials to use in different ways to be beneficial to human life. Their unique properties are constantly being improved to enhance more effective and perfect activity as per the requirement. Researchers are continuously producing highly useful materials with the help of different types of microorganisms and green technology for the synthesis of nanoparticles as per the requirement. Primarily Agrobacterium species are the most useful microorganisms for the synthesis of selenium nanoparticles in the diameter range of nanoscale. These are capable and more effective in making nanomaterials from selenium to use in medicinal and other applications. These are opening a new dimension in the field of medical science which is beneficial for multipurpose use directly or indirectly.