Muhammad Adiguna Rabbuka
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Muhammad Adiguna Rabbuka has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
- Biqiong Chen
School of Mechanical and Aerospace Engineering, Queen’s University Belfast, Stranmillis Road, Belfast BT9 5AH, UK
2 shared publications - Efri Mardawati
Universitas Padjadjaran
2 shared publications - Kasbawati Kasbawati
Applied Mathematics Laboratory, Department of Mathematics, Universitas Hasanuddin, Kota Makassar 90425, Indonesia
2 shared publications - Misri Gozan
Department of Chemical Engineering Faculty of Engineering Universitas Indonesia Depok Indonesia
2 shared publications - Yan Irawan
Research Center for Chemistry, Research Organization for Nanotechnology and Material, National Research and Innovation Agency, Serpong, Tangerang Selatan 15314, Banten, Indonesia
2 shared publications - Yeyen Nurhamiyah
Research Collaboration Center for Biomass and Biorefinery between BRIN and Padjadjaran University, Jatinangor 45363, Indonesia
2 shared publications
Latest Publications
- Open Access
Room-Temperature Direct Polymerization of Glycerol via Ultrasonication
A study was conducted on the synthesis of glycerol polymerization using ultrasonic (USG) technology. Although ultrasonication has been widely applied in various chemical processes, its role in glycerol polymerization remains insufficiently explored. In this study, polymerization was conducted under initial room-temperature conditions for 150 min using 4 wt% NaOH as a catalyst at an ultrasonic power of 300 W, corresponding to a cumulative energy input of 427,182 J. The process yielded a product with a molecular weight of 697.53 g/mol and a degree of polymerization (DP) of 7.52. FTIR analysis confirmed ether bond formation through characteristic C–O–C stretching bands in the 1033–1210 cm−1 region, while the broad O–H band at 3284 cm−1 indicated the presence of residual hydroxyl groups consistent with hyperbranched architectures. 1H-NMR spectroscopy further verified polymer formation, evidenced by the emergence of a doublet resonance at δ 3.68–3.69 ppm corresponding to ether linkages and the shift of the hydroxyl proton signal from δ 5.11 ppm in glycerol to δ 4.45–4.79 ppm in the polymer. Quantitative analysis using the Fréchet equation yielded a Degree of Branching (DB) of 0.57, characteristic of a well-defined hyperbranched architecture. This high DB ensures a dense periphery of hydroxyl groups, promoting excellent water solubility and versatile functionalization potential.
Open AccessRoom-Temperature Direct Polymerization of Glycerol via Ultrasonication
A study was conducted on the synthesis of glycerol polymerization using ultrasonic (USG) technology. Although ultrasonication has been widely applied in various chemical processes, its role in glycerol polymerization remains insufficiently explored. In this study, polymerization was conducted under initial room-temperature conditions for 150 min using 4 wt% NaOH as a catalyst at an ultrasonic power of 300 W, corresponding to a cumulative energy input of 427,182 J. The process yielded a product with a molecular weight of 697.53 g/mol and a degree of polymerization (DP) of 7.52. FTIR analysis confirmed ether bond formation through characteristic C–O–C stretching bands in the 1033–1210 cm−1 region, while the broad O–H band at 3284 cm−1 indicated the presence of residual hydroxyl groups consistent with hyperbranched architectures. 1H-NMR spectroscopy further verified polymer formation, evidenced by the emergence of a doublet resonance at δ 3.68–3.69 ppm corresponding to ether linkages and the shift of the hydroxyl proton signal from δ 5.11 ppm in glycerol to δ 4.45–4.79 ppm in the polymer. Quantitative analysis using the Fréchet equation yielded a Degree of Branching (DB) of 0.57, characteristic of a well-defined hyperbranched architecture. This high DB ensures a dense periphery of hydroxyl groups, promoting excellent water solubility and versatile functionalization potential.
- 19 March 2026
- Published by Wiley in Journal of the American Oil Chemists' Society
- Vol. 103 (6) , 509-519
Lipase‐Catalyzed Synthesis and Physicochemical Characterization of Oleoyl Monoethanolamide From Oleic Acid
This study reports the enzymatic synthesis of oleoyl monoethanolamide from oleic acid and ethanolamine using lipase as a biocatalyst, followed by optimization and comprehensive physicochemical characterization. The highest conversion of 89.22% was achieved at 60°C, 8 h reaction time, a 2.5:1 ethanolamine‐to‐oleic acid molar ratio, and 10% (w/w) enzyme concentration. Structural confirmation was conducted using FTIR, which revealed the disappearance of the carboxylic acid CO band and the emergence of amide I and amide II signals. Further evidence from 1 H‐NMR and 13 C‐NMR indicated the loss of carboxyl proton signals, the appearance of amide NH resonances, and a shift in carbonyl carbon from 180.34 ppm (acid) to 176.08 ppm (amide), confirming successful amidation. Physicochemical evaluation demonstrated a substantial reduction in acid value from 196.91 to 21.61 mg KOH/g and saponification value of 14.13 mg KOH/g, indicating efficient conversion of oleic acid. The product presents a calculated HLB of 6.9, suggesting lipophilic characteristics suitable for water‐in‐oil emulsification. Interfacial tension decreased from 11.04 to 4.23–4.30 mN/m at higher surfactant concentrations, with a critical micelle concentration (CMC) of approximately 0.35%. These results highlight the potential of enzymatically synthesized oleoyl monoethanolamide as an effective bio‐based nonionic surfactant.
- 19 March 2026
- Published by Wiley in Journal of the American Oil Chemists' Society
- Vol. 103 (6) , 509-519
Lipase‐Catalyzed Synthesis and Physicochemical Characterization of Oleoyl Monoethanolamide From Oleic Acid
This study reports the enzymatic synthesis of oleoyl monoethanolamide from oleic acid and ethanolamine using lipase as a biocatalyst, followed by optimization and comprehensive physicochemical characterization. The highest conversion of 89.22% was achieved at 60°C, 8 h reaction time, a 2.5:1 ethanolamine‐to‐oleic acid molar ratio, and 10% (w/w) enzyme concentration. Structural confirmation was conducted using FTIR, which revealed the disappearance of the carboxylic acid CO band and the emergence of amide I and amide II signals. Further evidence from 1 H‐NMR and 13 C‐NMR indicated the loss of carboxyl proton signals, the appearance of amide NH resonances, and a shift in carbonyl carbon from 180.34 ppm (acid) to 176.08 ppm (amide), confirming successful amidation. Physicochemical evaluation demonstrated a substantial reduction in acid value from 196.91 to 21.61 mg KOH/g and saponification value of 14.13 mg KOH/g, indicating efficient conversion of oleic acid. The product presents a calculated HLB of 6.9, suggesting lipophilic characteristics suitable for water‐in‐oil emulsification. Interfacial tension decreased from 11.04 to 4.23–4.30 mN/m at higher surfactant concentrations, with a critical micelle concentration (CMC) of approximately 0.35%. These results highlight the potential of enzymatically synthesized oleoyl monoethanolamide as an effective bio‐based nonionic surfactant.
- Open Access
- 23 April 2025
- Published by MDPI AG in Preprints.org
Synthesis and Characterisation of Hyperbranched Glycerol (HPG) Formation with Ultrasonication (USG)
A study has been conducted on the synthesis of HPG using Ultrasonic (USG) technology. The USG technology has been widely applied and successfully implemented in various chemical reactions and processes. However, little is known about the use of USG in the HPG synthesis process. The HPG process was conducted in room conditions for 150 minutes, with 4% NaOH as the catalyst, USG power of 200 watts and energy of 427,182 Joules. The process produced HPG with a molecular weight of 1,432 g/mol and a degree of polymerization (DP) of 7.518. FTIR analysis results showed the characteristic formation of the dendritic polyglycerol structure, indicated by the formation of ether or C-O-C groups at spectrum peaks between 1033 cm-1 and 1210 cm-1 and a spectrum peak at 3284 cm-1, indicating the presence of hydroxyl (O-H) groups. Identification using 13C NMR revealed peak shifts in the spectrum 71.5 to 72.8 ppm, identifying the HPG product as having a dendrimer structure. The 1H NMR spectrum showed peak shifts in the spectrum 3.2 to 3.6, identifying CH-O, indicating a dendritic structure.
- 23 April 2025
- Published by MDPI AG in Preprints.org
Open AccessSynthesis and Characterisation of Hyperbranched Glycerol (HPG) Formation with Ultrasonication (USG)
A study has been conducted on the synthesis of HPG using Ultrasonic (USG) technology. The USG technology has been widely applied and successfully implemented in various chemical reactions and processes. However, little is known about the use of USG in the HPG synthesis process. The HPG process was conducted in room conditions for 150 minutes, with 4% NaOH as the catalyst, USG power of 200 watts and energy of 427,182 Joules. The process produced HPG with a molecular weight of 1,432 g/mol and a degree of polymerization (DP) of 7.518. FTIR analysis results showed the characteristic formation of the dendritic polyglycerol structure, indicated by the formation of ether or C-O-C groups at spectrum peaks between 1033 cm-1 and 1210 cm-1 and a spectrum peak at 3284 cm-1, indicating the presence of hydroxyl (O-H) groups. Identification using 13C NMR revealed peak shifts in the spectrum 71.5 to 72.8 ppm, identifying the HPG product as having a dendrimer structure. The 1H NMR spectrum showed peak shifts in the spectrum 3.2 to 3.6, identifying CH-O, indicating a dendritic structure.