Cristiano Pereira
Cristiano Pereira has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- André Sandmann
Universidade Tecnológica Federal do Paraná
2 shared publications - Mylena Kellyn de Paula Rosetti2 shared publications
- Renato Hallal
Universidade Tecnológica Federal do Paraná (UTFPR)
2 shared publications - Ruberzan Ricardo da Silva2 shared publications
- André Inácio Melges
Universidade Tecnológica Federal do Paraná
1 shared publication - Antonio Carlos Gimenes Junior1 shared publication
Latest Publications
- Open Access
- 1 April 2024
- Published by Brazilian Journals in Caderno Pedagógico
- Vol. 21 (4) , e3666
Renural networks applied to self-purification models of a river in West Parana
Among the parameters that allow evaluating the degree of pollution of a river, one of the most efficient is dissolved oxygen concentration (DO), as it reflects the balance between the production and consumption of oxygen in aquatic ecosystems. Due to the dynamic characteristic of DO concentration, especially in rivers and wetlands, it is highly recommended to generate DO models periodically for aquatic ecosystems so that quality control measures can be optimized over a time horizon. To this end, implementation of different artificial intelligence (AI) techniques have been suggested in the relevant literature and among these techniques, neural networks (ANNs) have been successfully applied to water quality estimates. In this context, the present work describes the development of a model in Convolutional Neural Networks – CNN (Convolutional Neural Networks) with the objective of simulating the self-cleaning potential of the Rio Alegria, located in the municipality of Medianeira in the State of Paraná . The data used was the same as that collected by Schütz in 2014, so that it was possible to compare the performance of the CNN network with the performance of the Feed Forward Network (FFN), developed with the same set of data collected in 2014. The models were developed based on data on the quality of the river's water and the effluent that is incorporated into the watercourse throughout the studied interval. The model was named, CNN5. Tests and validations were carried out by varying the network architecture with cross-validation to estimate dissolved oxygen. Considering the results referring to the simulations carried out with the CNN5 model, where the simulated OD values are compared (from the combination of the weights that the network assigns to each input), with the results collected in the field and it can be concluded that a CNN network can be used to predict dissolved oxygen in the waters of a stretch of river, with an overall accuracy of 0.90, while FFN5 managed to achieve an accuracy of 77% for the same group of data. processing, a reduction from 12 hours to two minutes can be observed.
- 1 April 2024
- Published by Brazilian Journals in Caderno Pedagógico
- Vol. 21 (4) , e3666
Open AccessRenural networks applied to self-purification models of a river in West Parana
Among the parameters that allow evaluating the degree of pollution of a river, one of the most efficient is dissolved oxygen concentration (DO), as it reflects the balance between the production and consumption of oxygen in aquatic ecosystems. Due to the dynamic characteristic of DO concentration, especially in rivers and wetlands, it is highly recommended to generate DO models periodically for aquatic ecosystems so that quality control measures can be optimized over a time horizon. To this end, implementation of different artificial intelligence (AI) techniques have been suggested in the relevant literature and among these techniques, neural networks (ANNs) have been successfully applied to water quality estimates. In this context, the present work describes the development of a model in Convolutional Neural Networks – CNN (Convolutional Neural Networks) with the objective of simulating the self-cleaning potential of the Rio Alegria, located in the municipality of Medianeira in the State of Paraná . The data used was the same as that collected by Schütz in 2014, so that it was possible to compare the performance of the CNN network with the performance of the Feed Forward Network (FFN), developed with the same set of data collected in 2014. The models were developed based on data on the quality of the river's water and the effluent that is incorporated into the watercourse throughout the studied interval. The model was named, CNN5. Tests and validations were carried out by varying the network architecture with cross-validation to estimate dissolved oxygen. Considering the results referring to the simulations carried out with the CNN5 model, where the simulated OD values are compared (from the combination of the weights that the network assigns to each input), with the results collected in the field and it can be concluded that a CNN network can be used to predict dissolved oxygen in the waters of a stretch of river, with an overall accuracy of 0.90, while FFN5 managed to achieve an accuracy of 77% for the same group of data. processing, a reduction from 12 hours to two minutes can be observed.
- Open Access
- 1 March 2024
- Published by Brazilian Journals in Caderno Pedagógico
- Vol. 21 (3) , e3025
Eficiência da aplicação com uso de drone e pulverizador terrestre
O uso de drones para pulverizações agrícolas é uma tecnologia em crescimento, que pode integrar-se a outros métodos de aplicação buscando melhorar o desempenho e eficiência dos sistemas de pulverização. Este trabalho teve como objetivo avaliar a deposição de calda em diferentes locais da planta de soja utilizando drone em diferentes volumes e velocidades de aplicação relacionando com aplicação terrestre com pulverizador de barras. O trabalho foi desenvolvido em lavoura comercial, localizada no município de São Miguel do Iguaçu – PR. A implantação do experimento foi realizada na cultura da soja no estádio fenológico R5. O delineamento experimental foi em blocos ao acaso, em um arranjo fatorial 3 x 3 + 3. O primeiro fator foi volume (7, 11 e 15 L ha-1), e o segundo três velocidades (10, 15 e 20 km h-1). Também foi utilizado o autopropelido para fins de comparação, considerando-se os volumes de 70, 110 e 150 L ha-1, com quatro repetições. Observou-se três locais de coleta na planta (terço superior, médio e inferior). O tamanho das parcelas foi de 15 metros de comprimento por 8,5 metros de largura que coincide com a faixa de pulverização do drone. Para a coleta da deposição da calda em cada repetição, foi instalado papéis hidrossensíveis. Para as aplicações aéreas foi utilizado a aeronave DJI AGRAS T 30 na pulverização terrestre foi o pulverizador autopropelido da marca Montana Kuhn, modelo Boxer 2000. Após as pulverizações os cartões foram recolhidos, devidamente identificados e acondicionados em sacos plásticos. Posteriormente foram escaneados e suas imagens armazenadas para avaliação no software Gotas® quanto ao fator de dispersão do tamanho de gotas, densidade de gotas, porcentagem de cobertura e diâmetro médio volumétrico. Observou-se que a densidade de gotas na aplicação terrestre é maior em todas as posições entre todas as velocidades da aplicação aérea. A posição superior tem a maior densidade entre todas as velocidades do drone e do autopropelido. A posição superior teve maior cobertura de gotas no volume de 11 L ha-1 na velocidade 15 km h-1 na aplicação aérea, e no volume de 150 L ha-1 no autopropelido. A aplicação terrestre obteve melhor eficiência na deposição de gotas em relação a aplicação com drone.
- 1 March 2024
- Published by Brazilian Journals in Caderno Pedagógico
- Vol. 21 (3) , e3025
Open AccessEficiência da aplicação com uso de drone e pulverizador terrestre
O uso de drones para pulverizações agrícolas é uma tecnologia em crescimento, que pode integrar-se a outros métodos de aplicação buscando melhorar o desempenho e eficiência dos sistemas de pulverização. Este trabalho teve como objetivo avaliar a deposição de calda em diferentes locais da planta de soja utilizando drone em diferentes volumes e velocidades de aplicação relacionando com aplicação terrestre com pulverizador de barras. O trabalho foi desenvolvido em lavoura comercial, localizada no município de São Miguel do Iguaçu – PR. A implantação do experimento foi realizada na cultura da soja no estádio fenológico R5. O delineamento experimental foi em blocos ao acaso, em um arranjo fatorial 3 x 3 + 3. O primeiro fator foi volume (7, 11 e 15 L ha-1), e o segundo três velocidades (10, 15 e 20 km h-1). Também foi utilizado o autopropelido para fins de comparação, considerando-se os volumes de 70, 110 e 150 L ha-1, com quatro repetições. Observou-se três locais de coleta na planta (terço superior, médio e inferior). O tamanho das parcelas foi de 15 metros de comprimento por 8,5 metros de largura que coincide com a faixa de pulverização do drone. Para a coleta da deposição da calda em cada repetição, foi instalado papéis hidrossensíveis. Para as aplicações aéreas foi utilizado a aeronave DJI AGRAS T 30 na pulverização terrestre foi o pulverizador autopropelido da marca Montana Kuhn, modelo Boxer 2000. Após as pulverizações os cartões foram recolhidos, devidamente identificados e acondicionados em sacos plásticos. Posteriormente foram escaneados e suas imagens armazenadas para avaliação no software Gotas® quanto ao fator de dispersão do tamanho de gotas, densidade de gotas, porcentagem de cobertura e diâmetro médio volumétrico. Observou-se que a densidade de gotas na aplicação terrestre é maior em todas as posições entre todas as velocidades da aplicação aérea. A posição superior tem a maior densidade entre todas as velocidades do drone e do autopropelido. A posição superior teve maior cobertura de gotas no volume de 11 L ha-1 na velocidade 15 km h-1 na aplicação aérea, e no volume de 150 L ha-1 no autopropelido. A aplicação terrestre obteve melhor eficiência na deposição de gotas em relação a aplicação com drone.