Chanika Saenge Chooklin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Chanika Saenge Chooklin has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Kattinat Sakulsawasdipan
Faculty of Science and Fisheries Technology. Rajamangala University of Technology Srivijaya, Trang 92150, Thailand
2 shared publications Aneak Sawain
Faculty of Science and Fisheries Technology, Rajamangala University of Technology Srivijaya, Trang, 92150, Thailand
1 shared publication- Atipan Saimmai
Phuket Rajabhat University
1 shared publication - Natthaporn Rattanapan
Faculty of Science and Fisheries Technology, Rajamangala University of Technology Srivijaya, Trang, 92150, Thailand
1 shared publication - Nuntaporn Getlekha
Department of Biology, Faculty of Science and Technology, Muban Chombueng Rajabhat University. 46 Village No. 3, Chom Bueng, Chom Bueng 70150, Ratchaburi, Thailand
1 shared publication - Supatcha Chooseangjaew
Aquaculture Technology Program, Faculty of Science and Fisheries Technology, Rajamangala University of Technology Srivijaya, Trang 92150, Thailand
1 shared publication
Latest Publications
- Open Access
- 1 February 2024
- Published by Thaksin University in ASEAN Journal of Scientific and Technological Reports
- Vol. 27 (2) , 72-78
Induction of Gynogenetic Diploids the Tropical Oyster, Crassostrea belcheri 1873 (Ostreids: Ostreoidea)
The induction of diploid gynogenesis in the Tropical oyster, Crassostrea belcheri 1873, was carried out through two main experiments: 1) the destruction of spermatozoa DNA using ultraviolet (UV) irradiation, and 2) the induction of gynogenetic diploids. UV light source was placed 30 cm over the sperm for various durations, including 0 (control), 30, 60, 90, and 120 seconds. The study revealed that the highest survival rate was observed in trochophore at 90 minutes (42.5 ± 2.50%) compared to the normal control C. belcheri (p>0.05). Based on cytogenetic study, haploid (n=10), diploid (2n=20), and aneuploid were observed in all trials, while only diploid (2n=20) could be seen in the control group. Diploid gynogenesis was induced using 100 µmol 6-DMAP for 10 minutes. The study found that the survival rate and developmental stages in both trochophore and D-shape were gradually decreasing as the duration of UV rays increased. The highest survival rate of trochophore in the control group was 75.20 ± 4.84%, while survival rates in other experimental groups ranged from 52.22 ± 4.82% to 59.33 ± 13.57%. However, regarding the survival rate of D-shape larvae, their survival rates were relatively low across all trials. They displayed abnormal embryo development, distorted shape, unnatural swimming, and were smaller than normal (40-50 µm). Moreover, haploid (n=10), diploid (2n=20), triploid (3n=30), tetraploid (4n=40), and aneuploid were observed in all trials, while only diploid (2n=20) could be discovered in the control group. However, gynogenesis in this tropical oyster is still limited at this time. Therefore, suitable conditions for inducing gynogenesis in oysters should be further developed.
- 1 February 2024
- Published by Thaksin University in ASEAN Journal of Scientific and Technological Reports
- Vol. 27 (2) , 72-78
Open AccessInduction of Gynogenetic Diploids the Tropical Oyster, Crassostrea belcheri 1873 (Ostreids: Ostreoidea)
The induction of diploid gynogenesis in the Tropical oyster, Crassostrea belcheri 1873, was carried out through two main experiments: 1) the destruction of spermatozoa DNA using ultraviolet (UV) irradiation, and 2) the induction of gynogenetic diploids. UV light source was placed 30 cm over the sperm for various durations, including 0 (control), 30, 60, 90, and 120 seconds. The study revealed that the highest survival rate was observed in trochophore at 90 minutes (42.5 ± 2.50%) compared to the normal control C. belcheri (p>0.05). Based on cytogenetic study, haploid (n=10), diploid (2n=20), and aneuploid were observed in all trials, while only diploid (2n=20) could be seen in the control group. Diploid gynogenesis was induced using 100 µmol 6-DMAP for 10 minutes. The study found that the survival rate and developmental stages in both trochophore and D-shape were gradually decreasing as the duration of UV rays increased. The highest survival rate of trochophore in the control group was 75.20 ± 4.84%, while survival rates in other experimental groups ranged from 52.22 ± 4.82% to 59.33 ± 13.57%. However, regarding the survival rate of D-shape larvae, their survival rates were relatively low across all trials. They displayed abnormal embryo development, distorted shape, unnatural swimming, and were smaller than normal (40-50 µm). Moreover, haploid (n=10), diploid (2n=20), triploid (3n=30), tetraploid (4n=40), and aneuploid were observed in all trials, while only diploid (2n=20) could be discovered in the control group. However, gynogenesis in this tropical oyster is still limited at this time. Therefore, suitable conditions for inducing gynogenesis in oysters should be further developed.
- Open Access
- 27 June 2023
- Published by Thaksin University in ASEAN Journal of Scientific and Technological Reports
- Vol. 26 (3) , 52-62
Enhancing Oil Pollution Remediation Sites with Effective Emulsifying Property of Biosurfactant–Producing Bacillus oceanisediminis PM 08
Bacillus oceanisediminis PM 08, isolated from soil and seawater in southern Thailand, was evaluated as a potential biosurfactant with effective emulsifying properties. This strain produced a biosurfactant with a maximum emulsifying activity of 65% and a surface tension of 22.67 mN/m after 60 hours of cultivation under cultivation conditions. The yield of biosurfactant obtained by extraction with chloroform: methanol (2: 1, vol/vol) was 1.55 g/L. The stability of the biosurfactant was effective over a wide range of pH, temperature, and salinity. The high thermostability of the biosurfactant was determined using a thermal simultaneous. In addition, a preliminary chemical composition using FT-IR revealed that it is a glycolipid biosurfactant. The properties of this biosurfactant make it a good product for many industrial applications under extreme conditions.
- 27 June 2023
- Published by Thaksin University in ASEAN Journal of Scientific and Technological Reports
- Vol. 26 (3) , 52-62
Open AccessEnhancing Oil Pollution Remediation Sites with Effective Emulsifying Property of Biosurfactant–Producing Bacillus oceanisediminis PM 08
Bacillus oceanisediminis PM 08, isolated from soil and seawater in southern Thailand, was evaluated as a potential biosurfactant with effective emulsifying properties. This strain produced a biosurfactant with a maximum emulsifying activity of 65% and a surface tension of 22.67 mN/m after 60 hours of cultivation under cultivation conditions. The yield of biosurfactant obtained by extraction with chloroform: methanol (2: 1, vol/vol) was 1.55 g/L. The stability of the biosurfactant was effective over a wide range of pH, temperature, and salinity. The high thermostability of the biosurfactant was determined using a thermal simultaneous. In addition, a preliminary chemical composition using FT-IR revealed that it is a glycolipid biosurfactant. The properties of this biosurfactant make it a good product for many industrial applications under extreme conditions.