YNYu Nakazawa
Yu Nakazawa
*This is an algorithmically generated author record based on publicly available information.
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Yu Nakazawa has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Yuki Fujii
Monash University
2 shared publications Hisataka Yoshida
1 shared publication- Hisataka Yoshida
Research Center for Nuclear Physics, Osaka University, Osaka 567-0047, Japan
1 shared publication - Jordan Nash
School of Physics and Astronomy Monash Univer- sity 3168 Clayton VIC Australia
1 shared publication Kazuki Ueno
1 shared publication- Kazuki Ueno
School of Physics and Astronomy Monash Univer- sity 3168 Clayton VIC Australia
1 shared publication
Latest Publications
- Open Access
An FPGA-based Trigger System with Online Track Recognition in COMET Phase-I
An FPGA-based online trigger system has been developed for the COMET Phase-I experiment. This experiment searches for muon-to-electron conversion, which has never been observed yet. A drift chamber and trigger counters detect a mono-energetic electron from the conversion process in a 1-T solenoidal magnetic field. A highly intense muon source is applied to reach unprecedented experimental sensitivity. It also generates undesirable background particles, and a trigger rate due to these particles is expected to be much higher than an acceptable trigger rate in the data acquisition system. By using hit information from the drift chamber too, the online trigger system efficiently suppresses a background trigger rate while keeping signal-event acceptance large. A characteristic of this system is the utilization of the machine learning technique in the form of look-up tables on hardware. An initial simulation study indicates that the signal-event acceptance of the online trigger is 96% while the background trigger rate is reduced from over $90\,\mathrm{kHz}$ to $13\,\mathrm{kHz}$. For this scenario, we have produced trigger-related electronics that construct a distributed trigger architecture. The total latency of the trigger system was estimated to be $3.2\,\mathrm{\mu s}$, and the first operation test was carried out by using a part of the drift-chamber readout region.Open AccessAn FPGA-based Trigger System with Online Track Recognition in COMET Phase-I
An FPGA-based online trigger system has been developed for the COMET Phase-I experiment. This experiment searches for muon-to-electron conversion, which has never been observed yet. A drift chamber and trigger counters detect a mono-energetic electron from the conversion process in a 1-T solenoidal magnetic field. A highly intense muon source is applied to reach unprecedented experimental sensitivity. It also generates undesirable background particles, and a trigger rate due to these particles is expected to be much higher than an acceptable trigger rate in the data acquisition system. By using hit information from the drift chamber too, the online trigger system efficiently suppresses a background trigger rate while keeping signal-event acceptance large. A characteristic of this system is the utilization of the machine learning technique in the form of look-up tables on hardware. An initial simulation study indicates that the signal-event acceptance of the online trigger is 96% while the background trigger rate is reduced from over $90\,\mathrm{kHz}$ to $13\,\mathrm{kHz}$. For this scenario, we have produced trigger-related electronics that construct a distributed trigger architecture. The total latency of the trigger system was estimated to be $3.2\,\mathrm{\mu s}$, and the first operation test was carried out by using a part of the drift-chamber readout region. - Open Access
Radiation tolerance of online trigger system for COMET Phase-I
The COMET experiment aims to search for the neutrinoless muon to electron transition process with new sensitivity levels. The online trigger system is an integral part of achieving the sensitivity levels required and will be subject to an expected neutron fluence of up to $10^{12}$ $n \cdot \mathrm{cm}^{-2}\;$ within regions inside the detector solenoid. Consequently a significant number of soft errors in the logic of the onboard field programmable gate arrays (FPGA) can occur, requiring error correction for single event upsets and firmware reprogramming schemes for unrecoverable soft errors. We studied the radiation tolerance of the COMET Phase-I front-end trigger system, called COTTRI, subject to neutron fluence on order $10^{12}$ $n \cdot \mathrm{cm}^{-2}\;$ with multiple error correcting codes and automatic firmware reconfiguration. The regions measured were the configuration RAM, block RAM and also in a multi-gigabit transfer link using copper cables that will be used for communication between different trigger boards during Phase-I. The resulting cross sections observed suggest the most significant impact to the experiment will come from unrecoverable soft errors in configuration RAM, with dead time expected to be $(4.2 \pm 1.3)\%$. The effect of multi-bit errors in block RAM was found to be almost negligible in COMET Phase-I. In addition, multiple solutions have already been proposed in order to suppress these errors further. Soft errors observed in the multi-gigabit transfer links were measured to be of two orders of magnitude less impact compared to the unrecoverable errors in configuration RAM. We concluded that the COTTRI system meets the trigger requirement in COMET Phase-I.Open AccessRadiation tolerance of online trigger system for COMET Phase-I
The COMET experiment aims to search for the neutrinoless muon to electron transition process with new sensitivity levels. The online trigger system is an integral part of achieving the sensitivity levels required and will be subject to an expected neutron fluence of up to $10^{12}$ $n \cdot \mathrm{cm}^{-2}\;$ within regions inside the detector solenoid. Consequently a significant number of soft errors in the logic of the onboard field programmable gate arrays (FPGA) can occur, requiring error correction for single event upsets and firmware reprogramming schemes for unrecoverable soft errors. We studied the radiation tolerance of the COMET Phase-I front-end trigger system, called COTTRI, subject to neutron fluence on order $10^{12}$ $n \cdot \mathrm{cm}^{-2}\;$ with multiple error correcting codes and automatic firmware reconfiguration. The regions measured were the configuration RAM, block RAM and also in a multi-gigabit transfer link using copper cables that will be used for communication between different trigger boards during Phase-I. The resulting cross sections observed suggest the most significant impact to the experiment will come from unrecoverable soft errors in configuration RAM, with dead time expected to be $(4.2 \pm 1.3)\%$. The effect of multi-bit errors in block RAM was found to be almost negligible in COMET Phase-I. In addition, multiple solutions have already been proposed in order to suppress these errors further. Soft errors observed in the multi-gigabit transfer links were measured to be of two orders of magnitude less impact compared to the unrecoverable errors in configuration RAM. We concluded that the COTTRI system meets the trigger requirement in COMET Phase-I.