Carlos Solórzano-Blacio
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Carlos Solórzano-Blacio has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Jorge Albuja-Sánchez
Multidisciplinary Engineering Research Hub (MER Hub), Faculty of Habitat, Infrastructure, and Creativity, Pontificia Universidad Católica del Ecuador (PUCE), Quito 170143, Ecuador
3 shared publications - Doménica Romero
Facultad de Ciencias, Ingeniería y Construcción, Ingeniería Civil, Universidad UTE, Quito 170527, Ecuador
1 shared publication - Guillermo Realpe
PUCE
1 shared publication - Jorge Erazo
Multidisciplinary Engineering Research Hub (MER Hub), Faculty of Habitat, Infrastructure, and Creativity, Pontificia Universidad Católica del Ecuador (PUCE), Quito 170143, Ecuador
1 shared publication
Latest Publications
- Open Access
Influence of Abacá Fiber Treated with Sodium Hydroxide on Undrained Shear Strength in Organic Silt
Highly decomposed organic soils exhibit low strength and stability, which pose challenges for geotechnical engineering. This study evaluates the effectiveness of abacá natural fibers treated with 5% NaOH to prevent biodegradation and reinforce organic silt. An experimental program was conducted to investigate the effects of fiber content (1, 1.5, and 2%) and length (5, 10, and 15 mm) on the undrained shear strength (Su), elastic modulus (E50), maximum dry density (MDD), and optimum water content (OWC). The results revealed a slight reduction in MDD and OWC, while Su increased significantly, reaching 104.13% for 1.5% fiber content and 15 mm fiber length. E50 decreased by up to 52.61%, indicating a transition toward more ductile behavior and variability due to the inherent heterogeneity of the soil. ANOVA and post hoc Tukey analyses confirmed the statistical significance of fiber content and length on Su, with optimal performance observed at 1.5% content and 15 mm length. These findings demonstrate that chemically treated abacá fibers provide effective and sustainable soil reinforcement and that chemical treatment is essential to maintain short-term durability in biologically active organic soils.
Open AccessInfluence of Abacá Fiber Treated with Sodium Hydroxide on Undrained Shear Strength in Organic Silt
Highly decomposed organic soils exhibit low strength and stability, which pose challenges for geotechnical engineering. This study evaluates the effectiveness of abacá natural fibers treated with 5% NaOH to prevent biodegradation and reinforce organic silt. An experimental program was conducted to investigate the effects of fiber content (1, 1.5, and 2%) and length (5, 10, and 15 mm) on the undrained shear strength (Su), elastic modulus (E50), maximum dry density (MDD), and optimum water content (OWC). The results revealed a slight reduction in MDD and OWC, while Su increased significantly, reaching 104.13% for 1.5% fiber content and 15 mm fiber length. E50 decreased by up to 52.61%, indicating a transition toward more ductile behavior and variability due to the inherent heterogeneity of the soil. ANOVA and post hoc Tukey analyses confirmed the statistical significance of fiber content and length on Su, with optimal performance observed at 1.5% content and 15 mm length. These findings demonstrate that chemically treated abacá fibers provide effective and sustainable soil reinforcement and that chemical treatment is essential to maintain short-term durability in biologically active organic soils.
- Open Access
- 25 July 2025
- Published by MDPI AG in Applied Sciences
- Vol. 15 (15) , 8309
Effect of Matric Suction on Shear Strength and Elastic Modulus of Unsaturated Soil in Reconstituted and Undisturbed Samples
Most soils in natural environments undergo wetting and drying cycles, without reaching full saturation. Therefore, it is essential to analyze their properties under unsaturated conditions. However, these analyses often require expensive equipment. This study proposes an empirical-experimental methodology to evaluate the elastic modulus and shear strength of unsaturated soils under total stress conditions using undisturbed and reconstituted samples of silty soil from Quito, Ecuador. Techniques for suction measurement, soil water characteristic curve (SWCC), and predictive models for shear strength and stiffness in partially saturated soils were reviewed. Unconfined compression tests were performed, and the SWCC was determined using the filter paper method. A three-dimensional (3D) plot was generated to correlate the matric suction, shear strength, and normal stress across varying suction levels. In the reconstituted samples, the shear strength and elastic modulus exhibited nonlinear increases in the low suction range (≤500 kPa). In the high-suction range, the strength declined beyond 2228 kPa (40.23% saturation), whereas the elastic modulus stabilized. Undisturbed samples displayed greater variability owing to their heterogeneity, macrostructure, and hysteresis. The results suggest that matric suction enhances the shear strength and stiffness of the surface layers, whereas a higher saturation at depth reduces these properties. This paper further discusses the limitations and practical applicability of the proposed methodology.
- 25 July 2025
- Published by MDPI AG in Applied Sciences
- Vol. 15 (15) , 8309
Open AccessEffect of Matric Suction on Shear Strength and Elastic Modulus of Unsaturated Soil in Reconstituted and Undisturbed Samples
Most soils in natural environments undergo wetting and drying cycles, without reaching full saturation. Therefore, it is essential to analyze their properties under unsaturated conditions. However, these analyses often require expensive equipment. This study proposes an empirical-experimental methodology to evaluate the elastic modulus and shear strength of unsaturated soils under total stress conditions using undisturbed and reconstituted samples of silty soil from Quito, Ecuador. Techniques for suction measurement, soil water characteristic curve (SWCC), and predictive models for shear strength and stiffness in partially saturated soils were reviewed. Unconfined compression tests were performed, and the SWCC was determined using the filter paper method. A three-dimensional (3D) plot was generated to correlate the matric suction, shear strength, and normal stress across varying suction levels. In the reconstituted samples, the shear strength and elastic modulus exhibited nonlinear increases in the low suction range (≤500 kPa). In the high-suction range, the strength declined beyond 2228 kPa (40.23% saturation), whereas the elastic modulus stabilized. Undisturbed samples displayed greater variability owing to their heterogeneity, macrostructure, and hysteresis. The results suggest that matric suction enhances the shear strength and stiffness of the surface layers, whereas a higher saturation at depth reduces these properties. This paper further discusses the limitations and practical applicability of the proposed methodology.
- Open Access
- 7 May 2025
- Published by MDPI AG in Nanomaterials
- Vol. 15 (9) , 702
Effect of Nanosilica on the Undrained Shear Strength of Organic Soil
Organic soil is widely recognized for its low shear strength and high compressibility, which pose challenges for construction projects. One of the most commonly used methods for enhancing the mechanical properties of soil is chemical stabilization using various additives. In this study, the undrained shear strength of organic soil from Quito, Ecuador, with an average organic content of 43.84%, was reinforced using 0.5, 1, 3, and 6% nanosilica. A series of tests, including Atterberg limit, specific gravity, compaction, and unconfined compression tests, were conducted on specimens cured for 28 days. The results indicate that increasing the nanosilica content leads to higher plasticity, lower maximum dry density, and higher optimum moisture content. In addition, the modulus of elasticity and undrained shear strength improved. The optimal nanosilica content was found to be 1%, resulting in a 211.28% increase in the undrained shear strength. The mechanisms of soil improvement driven by the chemical interactions between nanosilica, mineralogical components (analyzed via XRD), and soil organic matter are discussed in detail.
- 7 May 2025
- Published by MDPI AG in Nanomaterials
- Vol. 15 (9) , 702
Open AccessEffect of Nanosilica on the Undrained Shear Strength of Organic Soil
Organic soil is widely recognized for its low shear strength and high compressibility, which pose challenges for construction projects. One of the most commonly used methods for enhancing the mechanical properties of soil is chemical stabilization using various additives. In this study, the undrained shear strength of organic soil from Quito, Ecuador, with an average organic content of 43.84%, was reinforced using 0.5, 1, 3, and 6% nanosilica. A series of tests, including Atterberg limit, specific gravity, compaction, and unconfined compression tests, were conducted on specimens cured for 28 days. The results indicate that increasing the nanosilica content leads to higher plasticity, lower maximum dry density, and higher optimum moisture content. In addition, the modulus of elasticity and undrained shear strength improved. The optimal nanosilica content was found to be 1%, resulting in a 211.28% increase in the undrained shear strength. The mechanisms of soil improvement driven by the chemical interactions between nanosilica, mineralogical components (analyzed via XRD), and soil organic matter are discussed in detail.