Aspasia Panagiotidou
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Aspasia Panagiotidou has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Danielle van Dinther1 shared publication
- Jann Aschersleben
Kapteyn Astronomical Institute, University of Groningen, Landleven 12, 9747 AD Groningen, The Netherlands
1 shared publication - Misja Frederik Alban Steinmetz
TNO, Anna van Buerenplein 1, 2595 DA The Hague, the Netherlands
1 shared publication - Pierre Paschinger1 shared publication
Latest Publications
- Open Access
- 31 October 2026
- Published by Springer Nature
- p. 175-182
Analysis of Remotely Measured NOx and SOx Emissions of Ships at the Port of Rotterdam
Internal combustion engines onboard seafaring vessels are major sources of nitrogen oxides (NO x ) and sulphur oxides (SO x ) in port areas. These pollutants have detrimental effects on human health and the environment. Remote measurement techniques offer an efficient alternative for estimating NO x and SO x emissions across numerous vessels, which would be impractical through on-board measurements alone. Since 2019, TNO runs an onshore measurement station at the entrance of the Port of Rotterdam. It measures the concentrations of NO, SO 2 , and CO 2 in the atmosphere, and logs information on the vessels passing the station as well as wind conditions. This data is used to calculate NO x emissions and estimate the sulphur content in the fuel used. Based on several years of data, this study investigates NO x and SO x emissions of ships depending on properties like Tier level, engine type, and installed aftertreatment systems. Focus is given to Tier III-certified vessels since previous studies have shown that these vessels often fail to comply with the applicable limits.
- 31 October 2026
- Published by Springer Nature
- p. 175-182
Open AccessAnalysis of Remotely Measured NOx and SOx Emissions of Ships at the Port of Rotterdam
Internal combustion engines onboard seafaring vessels are major sources of nitrogen oxides (NO x ) and sulphur oxides (SO x ) in port areas. These pollutants have detrimental effects on human health and the environment. Remote measurement techniques offer an efficient alternative for estimating NO x and SO x emissions across numerous vessels, which would be impractical through on-board measurements alone. Since 2019, TNO runs an onshore measurement station at the entrance of the Port of Rotterdam. It measures the concentrations of NO, SO 2 , and CO 2 in the atmosphere, and logs information on the vessels passing the station as well as wind conditions. This data is used to calculate NO x emissions and estimate the sulphur content in the fuel used. Based on several years of data, this study investigates NO x and SO x emissions of ships depending on properties like Tier level, engine type, and installed aftertreatment systems. Focus is given to Tier III-certified vessels since previous studies have shown that these vessels often fail to comply with the applicable limits.
- Open Access
- 8 May 2025
- Published by MDPI AG in Atmosphere
- Vol. 16 (5) , 561
On-Road Measurements and Modelling of Disc Brake Temperatures and Brake Wear Particle Number Emissions on a Heavy-Duty Tractor Trailer
In this paper, results are presented for an on-road measurement campaign for measuring the brake wear particles of disc brakes on a heavy-duty tractor trailer during the EU P012101 Pilot Project funded by the European Parliament. A novel approach was adopted using a fully open sampling system with minimal influence on air flow around the brake and brake disc temperatures. Models for brake disc heating and cooling were developed, as well as a model for the particle number emissions. It was concluded that brake wear emissions per kilometre were the highest on urban roads and the lowest on the motorway. Furthermore, when modelling heating during braking actions, the best results were seen when introducing dependencies on both the braking work and initial brake temperatures. When modelling the brake cooling, a non-linear dependence on the difference between the brake disc temperature and ambient air temperature was empirically observed. For the particle number emissions, a relationship was established between the braking work applied to the disc during the braking action and the particle number emissions of the braking action.
- 8 May 2025
- Published by MDPI AG in Atmosphere
- Vol. 16 (5) , 561
Open AccessOn-Road Measurements and Modelling of Disc Brake Temperatures and Brake Wear Particle Number Emissions on a Heavy-Duty Tractor Trailer
In this paper, results are presented for an on-road measurement campaign for measuring the brake wear particles of disc brakes on a heavy-duty tractor trailer during the EU P012101 Pilot Project funded by the European Parliament. A novel approach was adopted using a fully open sampling system with minimal influence on air flow around the brake and brake disc temperatures. Models for brake disc heating and cooling were developed, as well as a model for the particle number emissions. It was concluded that brake wear emissions per kilometre were the highest on urban roads and the lowest on the motorway. Furthermore, when modelling heating during braking actions, the best results were seen when introducing dependencies on both the braking work and initial brake temperatures. When modelling the brake cooling, a non-linear dependence on the difference between the brake disc temperature and ambient air temperature was empirically observed. For the particle number emissions, a relationship was established between the braking work applied to the disc during the braking action and the particle number emissions of the braking action.