Jing Zhang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jing Zhang has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Haozhe Wang
College of Physics, Donghua University
3 shared publications - Yu Xu
New Energy Materials and Devices, College of Science, Donghua University, Shanghai, China
3 shared publications - Zhixin Qian
College of Physics, Donghua University
3 shared publications - Xiaojiang Huang
College of Physics, Donghua University
2 shared publications Jie Cui
Donghua University, renmin road 2999, Shanghai, 201620, CHINA
1 shared publicationMingrui Su
College of Physics, Donghua University
1 shared publication
Latest Publications
- 22 September 2026
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 59 (38) , 385201
Low-temperature deposition of anatase TiO 2 thin films via atmospheric-pressure plasma-induced nanoparticle heating
This study elucidates the plasma-induced crystallization mechanism through theoretical modeling and in-situ diagnostics, and reports the successful fabrication of dense anatase TiO 2 films at a macroscopically low substrate temperature of approximately 146.8 °C. Laser light scattering was utilized to visualize the temporal evolution and spatial distribution of gas-phase nanoparticles, revealing their confinement at the plasma-sheath edge during the discharge and subsequent deposition during the off-time. Two-dimensional optical emission spectroscopy coupled with a collisional-radiative model characterized the plasma properties, identifying a double-peaked distribution of electron density (∼1.2 × 10 12 cm −3 ) and temperature (∼1.9 eV) near the sheath boundaries. Orbital-motion-limited model and energy-balance calculations further demonstrate that, despite a macroscopic gas temperature of only ∼247 °C, plasma-induced heating can raise the nanoparticle temperature to approximately 400 °C, exceeding the crystallization threshold of anatase TiO 2 . Raman, XRD, and SEM characterizations indicate that, with t on increasing from 0.107 s to 2.250 s, the deposited films change from loose amorphous particulate layers to dense crystalline anatase films. These findings provide an explanation for the mechanism of atmospheric-pressure plasma-induced low-temperature crystallization of TiO 2 thin films.
- 22 September 2026
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 59 (38) , 385201
Low-temperature deposition of anatase TiO 2 thin films via atmospheric-pressure plasma-induced nanoparticle heating
This study elucidates the plasma-induced crystallization mechanism through theoretical modeling and in-situ diagnostics, and reports the successful fabrication of dense anatase TiO 2 films at a macroscopically low substrate temperature of approximately 146.8 °C. Laser light scattering was utilized to visualize the temporal evolution and spatial distribution of gas-phase nanoparticles, revealing their confinement at the plasma-sheath edge during the discharge and subsequent deposition during the off-time. Two-dimensional optical emission spectroscopy coupled with a collisional-radiative model characterized the plasma properties, identifying a double-peaked distribution of electron density (∼1.2 × 10 12 cm −3 ) and temperature (∼1.9 eV) near the sheath boundaries. Orbital-motion-limited model and energy-balance calculations further demonstrate that, despite a macroscopic gas temperature of only ∼247 °C, plasma-induced heating can raise the nanoparticle temperature to approximately 400 °C, exceeding the crystallization threshold of anatase TiO 2 . Raman, XRD, and SEM characterizations indicate that, with t on increasing from 0.107 s to 2.250 s, the deposited films change from loose amorphous particulate layers to dense crystalline anatase films. These findings provide an explanation for the mechanism of atmospheric-pressure plasma-induced low-temperature crystallization of TiO 2 thin films.
- Open Access
- 28 May 2025
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 58 (23) , 235207
Impact of radio frequency power on columnar and filamentary modes in atmospheric pressure very low frequency plasma within pores
The impact of radio frequency (RF) power on columnar and filamentary modes of very low frequency (VLF) plasma within pores is investigated in this work. The 12.5 kHz VLF discharge under various RF powers (13.56 MHz) was analyzed using optical photography and current-voltage measurements. Two-dimensional electron densities were derived using optical emission spectroscopy combined with collisional radiation modeling methods. It is found that RF power and VLF voltage (V VLF) significantly influence the plasma and its discharge modes within the 200 μm pore. Under low V VLF conditions, the plasma is more intense within the pore, and the discharge mode is columnar discharge. With increasing RF power, the reciprocal motion of electrons counteracts the local enhancement effect of columnar discharge, the discharge transforms into RF discharge, the pore is completely wrapped by the sheath, and the plasma inside is gradually quenched. Under high V VLF conditions, the electron density within the pore is low and the discharge mode is filamentary discharge. RF introduction reduces plasma intensity within the pores firstly. As RF power increases, more ion trapping in the pore increases the field strength distortion and enhances the plasma intensity inside the pore, this enhancement effects becomes more obvious with increasing RF power. In addition, the above effects were observed for all pore widths from 100 µm to 1000 µm. These findings provide key insights for controlling plasma in pores and offer new methodologies for plasma technology applications.
- 28 May 2025
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 58 (23) , 235207
Open AccessImpact of radio frequency power on columnar and filamentary modes in atmospheric pressure very low frequency plasma within pores
The impact of radio frequency (RF) power on columnar and filamentary modes of very low frequency (VLF) plasma within pores is investigated in this work. The 12.5 kHz VLF discharge under various RF powers (13.56 MHz) was analyzed using optical photography and current-voltage measurements. Two-dimensional electron densities were derived using optical emission spectroscopy combined with collisional radiation modeling methods. It is found that RF power and VLF voltage (V VLF) significantly influence the plasma and its discharge modes within the 200 μm pore. Under low V VLF conditions, the plasma is more intense within the pore, and the discharge mode is columnar discharge. With increasing RF power, the reciprocal motion of electrons counteracts the local enhancement effect of columnar discharge, the discharge transforms into RF discharge, the pore is completely wrapped by the sheath, and the plasma inside is gradually quenched. Under high V VLF conditions, the electron density within the pore is low and the discharge mode is filamentary discharge. RF introduction reduces plasma intensity within the pores firstly. As RF power increases, more ion trapping in the pore increases the field strength distortion and enhances the plasma intensity inside the pore, this enhancement effects becomes more obvious with increasing RF power. In addition, the above effects were observed for all pore widths from 100 µm to 1000 µm. These findings provide key insights for controlling plasma in pores and offer new methodologies for plasma technology applications.