Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ghulam Hassan Askari has a total of 9 co-authors. Here are the top co-authors by number of shared publications:

  • Aqib Mashood Khan

    College of Mechanical and Electrical Engineering, Nanjing University of Aeronautics and Astronautics, Nanjing, China

    2 shared publications
  • Ray Tahir Mushtaq

    Bio-Additive Manufacturing University-Enterprise Joint Research Center of Shaanxi Province, Department of Industry Engineering, Northwestern Polytechnical University, Xi’an 710072, China

    2 shared publications
  • Yanen Wang

    Bio-Additive Manufacturing University-Enterprise Joint Research Center of Shaanxi Province, Department of Industry Engineering, Northwestern Polytechnical University, Xi’an 710072, China

    2 shared publications
  • Chengwei Bao

    Bio-Additive Manufacturing University-Enterprise Joint Research Center of Shaanxi Province, Department of Industry Engineering, Northwestern Polytechnical University, Xi'an 710072, China; School of Intelligent Manufacturing and Control Technology, Xi'an Mingde Institute of Technology, Xi'an 710124, China

    1 shared publication
  • Khubab Ahmed

    Binjiang Institute of Artificial Intelligence, Zhejiang University of Technology, Hangzhou 310051, Zhejiang, China

    1 shared publication
  • Mohammed Alkahtani

    Department of Industrial Engineering, College of Engineering, King Saud University, Riyadh, Saudi Arabia

    1 shared publication

Latest Publications

  • Open Access

    Printability, Mechanical Response, and Surface Integrity of MEX-Manufactured Gyroid Lattices with Uniform and Graded Cell Sizes

    by Ray Tahir Mushtaq, Ghulam Hassan Askari, Mudassar Rehman, Rakan Albarakati, Yanen Wang, Aqib Mashood Khan

    Triply periodic minimal surface (TPMS) gyroid lattices are promising lightweight and energy-absorbing polymer structures, but their manufacturability by material extrusion (MEX) depends strongly on cell size, grading direction, and relative density. This study investigates PLA gyroid lattices with uniform and graded cell-size configurations using initial and final cell sizes of 1, 1.5, and 2 mm and target relative densities of 10, 20, and 30%. A full-factorial design was used to construct a printability map, followed by quasi-static compression testing, areal surface-roughness characterization, and SEM observation of representative specimens. The printability results showed that low-density fine-cell configurations were most prone to incomplete wall formation and collapse, whereas the 30% relative-density group was printable for all investigated cell-size combinations. Under compression, the 30% relative-density uniform 1 mm gyroid showed the highest maximum stress among the tested configurations, while graded structures terminating in smaller cells also provided favorable load bearing and energy-absorption behavior. The plateau stability index, calculated from stress fluctuations between collapse and densification, helped distinguish stable progressive collapse from more oscillatory deformation. Surface roughness and SEM observations further indicated that smoother, more continuous wall surfaces were associated with more uniform deformation, whereas rougher and defect-rich surfaces promoted localized buckling, cracking, and brittle collapse. Overall, the results identify experimentally supported relationships between gyroid cell-size configuration, printability, surface integrity, and compressive response within the investigated PLA MEX design space.