Arief Rufiyanto
Arief Rufiyanto has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Reza Septiawan
National Research and Innovation Agency (BRIN)
2 shared publications - Agung Syetiawan
National Research and Innovation Agency
1 shared publication - Arif Rahmat Ardiansyah
Research Center for Fishery, National Research and Innovation Agency, Cibinong, West Java 16912, Indonesia
1 shared publication - Bondan Suwandi
National Research and Innovation Agency Indonesia
1 shared publication Budi Sulistya
PTE (Centre of Electronics Technology) BPPT
1 shared publication- Budi Sulistya
National Research and Innovation Agency Indonesia
1 shared publication
Latest Publications
- Open Access
- 1 July 2025
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 39 (1) , 497-508
BFT water color classification in tilapia aquaculture using computer vision
Biofloc technology (BFT) is one of the most promising aquaculture cultivation methods in the modern aquaculture era because of its high efficiency level, especially in water and fodder use. Usually, the general condition of the biofloc can be known from the color of the water. By utilizing the vision sensor, BFT color identification can be done automatically, which helps cultivators find out their BFT system’s condition. In this research, a classification was made for the watercolor of the BFT Tilapia system based on the microbial community color index (MCCI) value and the initial cultivation conditions where algae and nitrifying bacteria had not developed significantly. The color classifications of the bioflocs are clear, green, browngreen, green-brown, and deep-brown. Clear color is the new classification to indicate BFT water conditions in the initial cultivation phase. Further, two computer vision algorithm methods are introduced to classify the color of BFT system water. The first method combines the B/W algorithm and MCCI calculations, while the second algorithm uses the Manhattan distance algorithm approach. From the experiments that have been carried out, both computer vision algorithms methods for classifying biofloc colors have shown promising results.
- 1 July 2025
- Published by Institute of Advanced Engineering and Science in Indonesian Journal of Electrical Engineering and Computer Science
- Vol. 39 (1) , 497-508
Open AccessBFT water color classification in tilapia aquaculture using computer vision
Biofloc technology (BFT) is one of the most promising aquaculture cultivation methods in the modern aquaculture era because of its high efficiency level, especially in water and fodder use. Usually, the general condition of the biofloc can be known from the color of the water. By utilizing the vision sensor, BFT color identification can be done automatically, which helps cultivators find out their BFT system’s condition. In this research, a classification was made for the watercolor of the BFT Tilapia system based on the microbial community color index (MCCI) value and the initial cultivation conditions where algae and nitrifying bacteria had not developed significantly. The color classifications of the bioflocs are clear, green, browngreen, green-brown, and deep-brown. Clear color is the new classification to indicate BFT water conditions in the initial cultivation phase. Further, two computer vision algorithm methods are introduced to classify the color of BFT system water. The first method combines the B/W algorithm and MCCI calculations, while the second algorithm uses the Manhattan distance algorithm approach. From the experiments that have been carried out, both computer vision algorithms methods for classifying biofloc colors have shown promising results.
- 3 June 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 67 (4) , 1035-1043
A Proposed Measurement Technique for in Situ Radiated Emissions Precompliance of Electric Vehicle
In order to accommodate the size of an electric car, radiation emission (RE) testing for electric vehicles is typically carried out prior to compliance in an EMC chamber longer than ten meters and including a big entry door. Due to a shortage of testing facilities in some countries, makers of electric automobiles or electric vehicle modules find it challenging to conduct RE testing in an EMC chamber as required by current norms and regulations. This study proposes an in situ precompliance testing method for electric vehicle RE testing. The method considers the distance in the EMC chamber and the height of the antenna, as per CISPR 25 and CISPR 36. The device under test is an autonomous electric vehicle for pushing, pulling, or hauling freight. Radiated emission measurements were conducted in the 15–30 MHz frequency range. The proposed in situ measurement method has a confidence level of 89%–93.7% for 1 m distance measurements and 87.8%–93.7% for 3 m distance measurements, meeting CISPR 36 standards. This approach addresses the scarcity of EMC testing facilities in certain countries.
- 3 June 2025
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electromagnetic Compatibility
- Vol. 67 (4) , 1035-1043
A Proposed Measurement Technique for in Situ Radiated Emissions Precompliance of Electric Vehicle
In order to accommodate the size of an electric car, radiation emission (RE) testing for electric vehicles is typically carried out prior to compliance in an EMC chamber longer than ten meters and including a big entry door. Due to a shortage of testing facilities in some countries, makers of electric automobiles or electric vehicle modules find it challenging to conduct RE testing in an EMC chamber as required by current norms and regulations. This study proposes an in situ precompliance testing method for electric vehicle RE testing. The method considers the distance in the EMC chamber and the height of the antenna, as per CISPR 25 and CISPR 36. The device under test is an autonomous electric vehicle for pushing, pulling, or hauling freight. Radiated emission measurements were conducted in the 15–30 MHz frequency range. The proposed in situ measurement method has a confidence level of 89%–93.7% for 1 m distance measurements and 87.8%–93.7% for 3 m distance measurements, meeting CISPR 36 standards. This approach addresses the scarcity of EMC testing facilities in certain countries.
- Open Access
- 1 June 2019
- Published by Universitas Ahmad Dahlan in TELKOMNIKA (Telecommunication Computing Electronics and Control)
- Vol. 17 (3) , 1159-1167
GNSS interference reduction method for CORS site planning
GNSS interference reduction method for CORS site planning
- 1 June 2019
- Published by Universitas Ahmad Dahlan in TELKOMNIKA (Telecommunication Computing Electronics and Control)
- Vol. 17 (3) , 1159-1167
Open AccessGNSS interference reduction method for CORS site planning
GNSS interference reduction method for CORS site planning