Anna Mareike Kostelecky
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Anna Mareike Kostelecky has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Rainer Helmig
Institute for Modelling Hydraulic and Environmental Systems, University of Stuttgart, Stuttgart, Germany
3 shared publications - Tufan Ghosh
Institute of Applied Analysis and Numerical Simulation, University of Stuttgart, Stuttgart, Germany
3 shared publications - Carina Bringedal
Department of Computer Science, Electrical Engineering and Mathematical Sciences, Western Norway University of Applied Sciences, Bergen, Norway
2 shared publications - Helge K. Dahle
Department of Mathematics, University of Bergen, Bergen, Norway
2 shared publications - Ivar Stefansson
Department of Mathematics, University of Bergen, Bergen, Norway
2 shared publications - Martin Schneider
Department of Hydromechanics and Modelling of Hydrosystems, University of Stuttgart, Stuttgart, Germany
2 shared publications
Latest Publications
- Open Access
- 10 October 2026
- Published by Springer Nature in Transport in Porous Media
- Vol. 153 (8) , 106
Local Thermal Non-equilibrium Models in Porous Media: A Comparative Study Under Forced Convection
Heat transfer in saturated porous media plays a key role in many applications. Under certain conditions, the classical assumption of instantaneous heat transfer between phases may no longer hold, leading to local thermal non-equilibrium (LTNE). Even though many continuum-scale LTNE models exist, systematic comparisons between different models remain limited. In this study, we compare a dual-network model and different LTNE-REV-scale formulations under forced convection to evaluate their consistency in predicting LTNE behavior and to assess the influence of different model formulations. Simulations are performed for both steady-state and transient setups. For each setup and model, temperature profiles and non-dimensional temperature differences are analyzed for varying non-dimensional numbers, including Reynolds number, thermal conductivity ratio and Biot number. Across the investigated regimes, all empirical models predict an increase in LTNE with increasing Reynolds number and decreasing Biot number. However, no consistent trend is observed for varying thermal conductivity ratios. Differences between the models can be addressed to the different formulations of effective thermal properties. For idealized systems under natural porous-media conditions, in particular small Reynolds numbers, similar bulk conductivities and high Biot numbers, all models predict near-zero local fluid–solid temperature differences (LTE behavior). Under other conditions, however, the models differ in the magnitude of local temperature difference they predict, i.e., in the degree of LTNE. This highlights the importance of comparisons against detailed experimental data or simulations, for example, within the framework of a benchmark study. Article Highlights: The magnitude of the interfacial exchange term strongly correlates with resulting fluid–solid temperature differences Empirical models show increase in fluid–solid temperature difference for high velocities and low interfacial area For idealized systems under natural porous-media conditions, fluid and solid temperatures equalize almost instantly
- 10 October 2026
- Published by Springer Nature in Transport in Porous Media
- Vol. 153 (8) , 106
Open AccessLocal Thermal Non-equilibrium Models in Porous Media: A Comparative Study Under Forced Convection
Heat transfer in saturated porous media plays a key role in many applications. Under certain conditions, the classical assumption of instantaneous heat transfer between phases may no longer hold, leading to local thermal non-equilibrium (LTNE). Even though many continuum-scale LTNE models exist, systematic comparisons between different models remain limited. In this study, we compare a dual-network model and different LTNE-REV-scale formulations under forced convection to evaluate their consistency in predicting LTNE behavior and to assess the influence of different model formulations. Simulations are performed for both steady-state and transient setups. For each setup and model, temperature profiles and non-dimensional temperature differences are analyzed for varying non-dimensional numbers, including Reynolds number, thermal conductivity ratio and Biot number. Across the investigated regimes, all empirical models predict an increase in LTNE with increasing Reynolds number and decreasing Biot number. However, no consistent trend is observed for varying thermal conductivity ratios. Differences between the models can be addressed to the different formulations of effective thermal properties. For idealized systems under natural porous-media conditions, in particular small Reynolds numbers, similar bulk conductivities and high Biot numbers, all models predict near-zero local fluid–solid temperature differences (LTE behavior). Under other conditions, however, the models differ in the magnitude of local temperature difference they predict, i.e., in the degree of LTNE. This highlights the importance of comparisons against detailed experimental data or simulations, for example, within the framework of a benchmark study. Article Highlights: The magnitude of the interfacial exchange term strongly correlates with resulting fluid–solid temperature differences Empirical models show increase in fluid–solid temperature difference for high velocities and low interfacial area For idealized systems under natural porous-media conditions, fluid and solid temperatures equalize almost instantly
- Open Access
- 21 July 2026
- Published by Centre pour la Communication Scientifique Directe (CCSD) in JoDaKISS - Journal of Data- and Knowledge-integrated Simulation Science
DuMux 3.9.0
Release 3.9.0 of DuMux, DUNE for Multi-{Phase, Component, Scale, Physics, ...} flow and transport in porous media. DuMux is a free and open-source simulator for flow and transport processes in and around porous media. It is based on the Distributed and Unified Numerics Environment DUNE.
- 21 July 2026
- Published by Centre pour la Communication Scientifique Directe (CCSD) in JoDaKISS - Journal of Data- and Knowledge-integrated Simulation Science
Open AccessDuMux 3.9.0
Release 3.9.0 of DuMux, DUNE for Multi-{Phase, Component, Scale, Physics, ...} flow and transport in porous media. DuMux is a free and open-source simulator for flow and transport processes in and around porous media. It is based on the Distributed and Unified Numerics Environment DUNE.
- Top Cited PapersOpen Access
- 11 April 2026
- Published by Springer Nature in Transport in Porous Media
- Vol. 153 (5) , 55
Local Thermal Non-equilibrium Models in Porous Media: A Comparative Study of Conduction Effects
Instantaneous heat transfer between different phases, known as local thermal equilibrium (LTE), is commonly assumed for modeling heat transfer in porous media. This assumption may not hold in certain technical and environmental applications, particularly with large temperature gradients, large differences in thermal properties, or high velocities. Local thermal non-equilibrium (LTNE) models aim to describe heat transfer processes when the LTE assumption may fail. We compare three continuum-scale models from the pore to the representative elementary volume (REV) scale. Specifically, dual-network and REV-scale models are evaluated against a pore-resolved model used as a reference in the absence of experimental results. Different effective models are used to obtain upscaled properties on the REV scale and to compare resulting temperature profiles. The systems investigated are fully saturated, consisting of one fluid and one solid phase. This study focuses on purely conductive systems without significant differences in thermal properties. Results show that LTE holds for low interfacial resistances. However, for large interfacial resistances, solid and fluid temperatures differ. The REV-scale model with effective parameters obtained by homogenization leads to similar results as the pore-resolved model, whereas the dual-network model deviates more due to fixed spatial resolution. Among the evaluated REV-scale formulations, only the homogenization-based approach captures the LTNE behavior, as it incorporates the interfacial heat transfer coefficient. Our results provide a basis for conduction-dominated heat transfer in saturated porous media and for further systematic comparisons that incorporate convection relevant to a broader range of applications.
- 11 April 2026
- Published by Springer Nature in Transport in Porous Media
- Vol. 153 (5) , 55
Top Cited PapersOpen AccessLocal Thermal Non-equilibrium Models in Porous Media: A Comparative Study of Conduction Effects
Instantaneous heat transfer between different phases, known as local thermal equilibrium (LTE), is commonly assumed for modeling heat transfer in porous media. This assumption may not hold in certain technical and environmental applications, particularly with large temperature gradients, large differences in thermal properties, or high velocities. Local thermal non-equilibrium (LTNE) models aim to describe heat transfer processes when the LTE assumption may fail. We compare three continuum-scale models from the pore to the representative elementary volume (REV) scale. Specifically, dual-network and REV-scale models are evaluated against a pore-resolved model used as a reference in the absence of experimental results. Different effective models are used to obtain upscaled properties on the REV scale and to compare resulting temperature profiles. The systems investigated are fully saturated, consisting of one fluid and one solid phase. This study focuses on purely conductive systems without significant differences in thermal properties. Results show that LTE holds for low interfacial resistances. However, for large interfacial resistances, solid and fluid temperatures differ. The REV-scale model with effective parameters obtained by homogenization leads to similar results as the pore-resolved model, whereas the dual-network model deviates more due to fixed spatial resolution. Among the evaluated REV-scale formulations, only the homogenization-based approach captures the LTNE behavior, as it incorporates the interfacial heat transfer coefficient. Our results provide a basis for conduction-dominated heat transfer in saturated porous media and for further systematic comparisons that incorporate convection relevant to a broader range of applications.
- Open Access
- 29 March 2026
- Published by Springer Nature in Transport in Porous Media
- Vol. 153 (4) , 52
A Dual-Continuum Approach for Precipitated Salt in Porous Media: Accounting for Coupled Transport Processes
Salt precipitation in porous media can negatively impact environmental systems. It enhances the evaporation process and thereby leads to a faster drying of soils. To address this, we introduce a dual-continuum modeling framework that enables the simulation of fluid flow in both the original, main porous structure, referred to as porous matrix, and the newly formed salt structure. We present two modeling strategies: (1) a coupled-flow model that explicitly resolves mass and energy transport in both the matrix and salt continua, incorporating advective, diffusive, and filling-based exchange terms; and (2) a pseudo-flow model that assumes full saturation of the salt continuum and implicitly captures flow based on evaporative demand, improving computational efficiency. Both approaches reproduce expected saturation profiles, temperature distributions, and evaporation behavior. The resulting evaporation rates are increased, leading to a faster drying out of the porous medium compared to a single-continuum model. The coupled-flow model shows that the precipitated salt remains liquid-saturated for a longer period than the surrounding matrix, thereby sustaining upward water transport; however, its results are sensitive to the parameterization. By assuming full saturation of the precipitated salt, the pseudo-flow model yields the higher evaporation rates while also improving numerical stability. This work presents a first step toward modeling the coupled transport processes resulting from salt precipitation in porous media.
- 29 March 2026
- Published by Springer Nature in Transport in Porous Media
- Vol. 153 (4) , 52
Open AccessA Dual-Continuum Approach for Precipitated Salt in Porous Media: Accounting for Coupled Transport Processes
Salt precipitation in porous media can negatively impact environmental systems. It enhances the evaporation process and thereby leads to a faster drying of soils. To address this, we introduce a dual-continuum modeling framework that enables the simulation of fluid flow in both the original, main porous structure, referred to as porous matrix, and the newly formed salt structure. We present two modeling strategies: (1) a coupled-flow model that explicitly resolves mass and energy transport in both the matrix and salt continua, incorporating advective, diffusive, and filling-based exchange terms; and (2) a pseudo-flow model that assumes full saturation of the salt continuum and implicitly captures flow based on evaporative demand, improving computational efficiency. Both approaches reproduce expected saturation profiles, temperature distributions, and evaporation behavior. The resulting evaporation rates are increased, leading to a faster drying out of the porous medium compared to a single-continuum model. The coupled-flow model shows that the precipitated salt remains liquid-saturated for a longer period than the surrounding matrix, thereby sustaining upward water transport; however, its results are sensitive to the parameterization. By assuming full saturation of the precipitated salt, the pseudo-flow model yields the higher evaporation rates while also improving numerical stability. This work presents a first step toward modeling the coupled transport processes resulting from salt precipitation in porous media.
- Open Access
Local Thermal Non-Equilibrium Models in Porous Media: A Comparative Study of Conduction Effects
Instantaneous heat transfer between different phases is a common assumption for modeling heat transfer in porous media, known as Local Thermal Equilibrium (LTE). This assumption may not hold in certain technical and environmental applications, especially in systems with large temperature gradients, large differences in thermal properties, or high velocities. Local Thermal Non-Equilibrium (LTNE) models aim to describe heat transfer processes when the LTE assumption may fail. In this work, we compare three continuum-scale models from the pore to the representative elementary volume (REV) scale. Specifically, dual-network and REV-scale models are evaluated against a pore-resolved model, which we perceive as a reference in the absence of experimental results. Different effective models are used to obtain upscaled properties on the REV scale and to compare resulting temperature profiles. The systems investigated are fully saturated, consisting of one fluid and one solid phase. This study focuses on purely conductive systems without significant differences in thermal properties. Results show that LTE holds then for low interfacial resistances. However, for large interfacial resistances, solid and fluid temperatures differ. The REV-scale model with effective parameters obtained by homogenization leads to similar results as the pore-resolved model, whereas the dual-network model shows greater deviation due to its fixed spatial resolution. Among the evaluated effective parameter formulations for the REV-scale model, only the homogenization-based approach captures the LTNE behavior, as it incorporates the interfacial heat transfer coefficient. Convection is relevant for most practical applications, and its impact will be addressed in a follow-up article.
Open AccessLocal Thermal Non-Equilibrium Models in Porous Media: A Comparative Study of Conduction Effects
Instantaneous heat transfer between different phases is a common assumption for modeling heat transfer in porous media, known as Local Thermal Equilibrium (LTE). This assumption may not hold in certain technical and environmental applications, especially in systems with large temperature gradients, large differences in thermal properties, or high velocities. Local Thermal Non-Equilibrium (LTNE) models aim to describe heat transfer processes when the LTE assumption may fail. In this work, we compare three continuum-scale models from the pore to the representative elementary volume (REV) scale. Specifically, dual-network and REV-scale models are evaluated against a pore-resolved model, which we perceive as a reference in the absence of experimental results. Different effective models are used to obtain upscaled properties on the REV scale and to compare resulting temperature profiles. The systems investigated are fully saturated, consisting of one fluid and one solid phase. This study focuses on purely conductive systems without significant differences in thermal properties. Results show that LTE holds then for low interfacial resistances. However, for large interfacial resistances, solid and fluid temperatures differ. The REV-scale model with effective parameters obtained by homogenization leads to similar results as the pore-resolved model, whereas the dual-network model shows greater deviation due to its fixed spatial resolution. Among the evaluated effective parameter formulations for the REV-scale model, only the homogenization-based approach captures the LTNE behavior, as it incorporates the interfacial heat transfer coefficient. Convection is relevant for most practical applications, and its impact will be addressed in a follow-up article.