Rawnaq Adnan Mahmod
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Rawnaq Adnan Mahmod has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Amjad Jaleel Humaidi
College of Artificial Intelligence Engineering, University of Technology-Iraq, Baghdad 10066, Iraq
2 shared publications - Huthaifa Al-Khazraji
Control and Systems Engineering Department, University of Technology-Iraq, Baghdad, Iraq
2 shared publications Mohanad Nawfal
University of Technology-Iraq
2 shared publications- Ahmed Mudheher Hasan
College of Artificial Intelligence Engineering, University of Technology-Iraq, Baghdad 10066, Iraq
1 shared publication Ammar A. Yahya
University of Technology - Iraq
1 shared publication- Ammar K. Al Mhdawi
School of Engineering and Sustainable Development, Electrical, Electronics and Mechatronics Group, De Montfort University, LE1 9BH Leicester, United Kingdom
1 shared publication
Latest Publications
- 23 July 2026
- Published by Springer Nature in International Journal of Dynamics and Control
- Vol. 14 (8) , 297
Particle swarm optimization based H∞ loop shaping robust control for anesthesia systems
- 23 July 2026
- Published by Springer Nature in International Journal of Dynamics and Control
- Vol. 14 (8) , 297
Particle swarm optimization based H∞ loop shaping robust control for anesthesia systems
- 13 October 2025
- Published by IOP Publishing in Engineering Research Express
- Vol. 7 (4) , 045213
Inertial sensor measurement calibration using artificial intelligence techniques: a comparative study
Over the past decade, the Global Positioning System (GPS) has been extensively employed in land vehicle navigation systems. Inertial Navigation Systems (INSs) are utilized in scenarios where GPS fails to deliver consistent and reliable navigation solutions. It is well-known that the low-cost INS sensors can exhibit significant errors. To mitigate these errors, the measurements of position and velocity sensors from GPS are integrated and fused. In this study, an intelligent technique has been proposed to optimize the benefits of GPS and INS while minimizing their drawbacks. This study employed an artificial intelligence model to predict the instantaneous INS error based on instantaneous de-noised measurements and readings. Different artificial neural network (ANN) models have been tested, examined and compared. The results revealed that a considerable improvement has been reached in terms of ability to predict INS error during different GPS outages. However, a promising result have been found using RNN model. As compared to other ANN models, the RNN model gives better performance in terms of standard deviations of position and velocity errors. The standard deviations of prediction position errors resulting from RNN are equal to 0.0864, 0.0726, and 0.1297 min the sense of x, y and z channels, respectively, while the standard deviations of predicted velocity errors are 0.0025, 0.0029, and 0.0049 m s −1 on the x, y, and z axis, respectively.
- 13 October 2025
- Published by IOP Publishing in Engineering Research Express
- Vol. 7 (4) , 045213
Inertial sensor measurement calibration using artificial intelligence techniques: a comparative study
Over the past decade, the Global Positioning System (GPS) has been extensively employed in land vehicle navigation systems. Inertial Navigation Systems (INSs) are utilized in scenarios where GPS fails to deliver consistent and reliable navigation solutions. It is well-known that the low-cost INS sensors can exhibit significant errors. To mitigate these errors, the measurements of position and velocity sensors from GPS are integrated and fused. In this study, an intelligent technique has been proposed to optimize the benefits of GPS and INS while minimizing their drawbacks. This study employed an artificial intelligence model to predict the instantaneous INS error based on instantaneous de-noised measurements and readings. Different artificial neural network (ANN) models have been tested, examined and compared. The results revealed that a considerable improvement has been reached in terms of ability to predict INS error during different GPS outages. However, a promising result have been found using RNN model. As compared to other ANN models, the RNN model gives better performance in terms of standard deviations of position and velocity errors. The standard deviations of prediction position errors resulting from RNN are equal to 0.0864, 0.0726, and 0.1297 min the sense of x, y and z channels, respectively, while the standard deviations of predicted velocity errors are 0.0025, 0.0029, and 0.0049 m s −1 on the x, y, and z axis, respectively.
- Open Access
- 19 June 2025
- Published by ASCEE Publications in International Journal of Robotics and Control Systems
- Vol. 5 (3) , 1886-1899
High Gain Observer Based Backstepping Control Design for Nonlinear Single-Axis Driven Systems
In this paper, a backstepping (BS) control design approach is proposed for tracking angular position control problem of a single-input and single-output (SISO) nonlinear single-axis driven system. To implement proposed BS control, the states of the system should be available. To address this problem, a high gain observer (HGO) is introduced for estimating the states. The design parameters of the HGO based BS controller have been optimized using the circle search algorithm (CSA). Compare to other optimization algorithm, the CSA explores the search space in a circular trajectory which can enhance local exploitation. The CSA uses integral of absolute error (IAE) as the performance index for the tuning process. The effectiveness of the proposed controller is demonstrated through simulations. Firstly, for observer evaluation, simulation outcomes indicate that the HGO is capable to estimate the states of the system successfully. However, to evaluate the BS with other nonlinear controllers for tracking control problem, the synergetic (SG) control is proposed. The simulated data results based on IAE index revealed that the BS control has lower IAE value than the SG control where the value of the IAE of the system with the BS control is reduced by 19.4% in compares with the system with the SG control.
- 19 June 2025
- Published by ASCEE Publications in International Journal of Robotics and Control Systems
- Vol. 5 (3) , 1886-1899
Open AccessHigh Gain Observer Based Backstepping Control Design for Nonlinear Single-Axis Driven Systems
In this paper, a backstepping (BS) control design approach is proposed for tracking angular position control problem of a single-input and single-output (SISO) nonlinear single-axis driven system. To implement proposed BS control, the states of the system should be available. To address this problem, a high gain observer (HGO) is introduced for estimating the states. The design parameters of the HGO based BS controller have been optimized using the circle search algorithm (CSA). Compare to other optimization algorithm, the CSA explores the search space in a circular trajectory which can enhance local exploitation. The CSA uses integral of absolute error (IAE) as the performance index for the tuning process. The effectiveness of the proposed controller is demonstrated through simulations. Firstly, for observer evaluation, simulation outcomes indicate that the HGO is capable to estimate the states of the system successfully. However, to evaluate the BS with other nonlinear controllers for tracking control problem, the synergetic (SG) control is proposed. The simulated data results based on IAE index revealed that the BS control has lower IAE value than the SG control where the value of the IAE of the system with the BS control is reduced by 19.4% in compares with the system with the SG control.
- Open Access
- 1 March 2025
- Published by Universitas Muhammadiyah Yogyakarta in Journal of Robotics and Control (JRC)
- Vol. 6 (2) , 1033-1040
Integration of Sparrow Search Optimization with Terminal Synergetic Control for Permanent Magnet Linear Synchronous Motors
This paper proposes a theoretical framework of the procedure to design an optimal robust terminal synergetic control (TSC) for the permanent magnet linear synchronous motors (PMLSMs). The general component and the mathematical equations of the PMLSM are first introduced. Based on the established model of the PMLSM, the control law of the TSC is developed. The tuning process of the TSC gains is enhanced by employing sparrow search optimization (SSO) based on the Integral Time of Absolute Errors (ITAE). The effectiveness of the proposed control algorithm has been verified by numerical simulations using MATLAB software for a step input. Additionally, the results have been compared with the classical synergetic control (CSC). The comparison shows that the TSC exhibits a good performance in normal operation and in a robustness test involving system parameters’ changes as compared to the CSC.
- 1 March 2025
- Published by Universitas Muhammadiyah Yogyakarta in Journal of Robotics and Control (JRC)
- Vol. 6 (2) , 1033-1040
Open AccessIntegration of Sparrow Search Optimization with Terminal Synergetic Control for Permanent Magnet Linear Synchronous Motors
This paper proposes a theoretical framework of the procedure to design an optimal robust terminal synergetic control (TSC) for the permanent magnet linear synchronous motors (PMLSMs). The general component and the mathematical equations of the PMLSM are first introduced. Based on the established model of the PMLSM, the control law of the TSC is developed. The tuning process of the TSC gains is enhanced by employing sparrow search optimization (SSO) based on the Integral Time of Absolute Errors (ITAE). The effectiveness of the proposed control algorithm has been verified by numerical simulations using MATLAB software for a step input. Additionally, the results have been compared with the classical synergetic control (CSC). The comparison shows that the TSC exhibits a good performance in normal operation and in a robustness test involving system parameters’ changes as compared to the CSC.