KLKefu Li

Kefu Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Kefu Li has a total of 42 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Post‐Stimulation Hydraulic Response and Productivity Constraints of a Low‐Productivity Carbonate Geothermal Well in the Small Intramontane Basin, Beijing Piedmont, North China

    by Chuanqing Zhu, Kefu Li, Wansen Yao, Wanqing Geng, Yonghui Huang, Shu Jiang, Nansheng Qiu

    The Houcheng Basin, a small intramontane basin in the Beijing piedmont, North China, hosts Mesoproterozoic Jixianian dolomite geothermal reservoirs. Unlike adjacent rift basins such as the Jizhong Depression, which develop high‐quality carbonate reservoirs under favorable preservation conditions, the Houcheng Basin represents a tectonically constrained setting where sustainable geothermal exploitation remains challenging. This study investigates Well 960 in the Houcheng Basin by integrating stimulation records, variable‐frequency pumping–recovery tests, a homogeneous axisymmetric radial‐flow finite‐element model, and core and thin‐section observations to evaluate post‐stimulation productivity limitations. Increasing pump frequency from 30 to 37 Hz increased steady discharge by only 24%, whereas steady drawdown increased by 179% and specific capacity decreased by 56%. The maximum tested discharge was 15.26 m 3 /h, still below the project‐level target of 40 m 3 /h. A homogeneous radial‐flow reference model constrained by the 30‐Hz stage reproduced the overall response at the lowest pumping intensity, but the observed end‐stage drawdowns at 33 and 37 Hz exceeded the upper bounds of the reference‐model ensemble by 29.82 and 51.65 m, respectively. Observed water‐level recovery after pumping was also faster than predicted by the reference model. These responses indicate increasing excess head loss at higher pumping intensities that cannot be adequately represented by a single, constant equivalent transmissivity. Core and thin‐section observations show that some fractures are partly filled with carbonate cements and solid bitumen, indicating that geometric fracture development does not necessarily correspond to hydraulic effectiveness. The Well 960 case indicates that post‐completion stimulation may not fully offset productivity risks associated with inadequate identification of hydraulically effective reservoir intervals. For comparable small intramontane basins in North China, geothermal development should place greater emphasis on pre‐drilling assessment of reservoir effectiveness and use post‐drilling dynamic hydraulic responses to refine estimates of development potential.

  • Open Access

    Temperature–pressure field of the Mahu Sag in Junggar Basin, Northwest China: Implication for the deep petroleum system

    by Jia-Bo Xu, Jian Chang, Chen-Xing Li, Ze Zhang, Nan-Sheng Qiu, Hua-Jun Guo, Xiang Shan, Bo Peng, Ke-Fu Li

  • Open Access

    COMPARATIVE GENETIC MECHANISMS OF GEOTHERMAL SYSTEMS IN SUMATRA AND WEST JAVA, INDONESIA

    by Hui Zhang, Xiang Mao, Kefu Li, Chuanqing Zhu, Xu Huang, Ze Zhang, Jiabo Xu, Qiwen Yao, Hongtao Wang

    Indonesia is located in the Sunda Volcanic Arc and hosts abundant geologically controlled geothermal resources. Geothermal systems under different tectonic settings in this region exhibit significant differences in spatial distribution, reservoir characteristics, and fluid phases. Clarifying the geodynamic mechanisms underlying the genetic differences of these systems has fundamental guiding significance for regional geothermal resource assessment. Taking the fault-controlled geothermal systems in Sumatra and the volcano-hosted geothermal systems in West Java as comparative targets, this paper synthesizes existing geological literature and measured borehole temperature data to delineate the control laws of deep geodynamic processes on key elements of shallow hydrothermal systems. The comprehensive analysis indicates that: (1) The oblique subduction and thicker continental crust background in Sumatra are accompanied by assimilation and mixing processes, which tend to form large silicic magma chambers; under the orthogonal subduction and thinner crust background in West Java, intermediate-mafic shallow stratovolcano complexes predominantly develop. (2) Sumatran geothermal systems are controlled by the strike-slip shear zone of the Great Sumatran Fault (GSF), with high-permeability zones concentrated within the principal faults and pull-apart basins; West Java geothermal systems are affected by the superimposition of local extension and magmatic thermal stress, developing diffuse secondary micro-fracture networks within the andesitic basement. (3) Sumatran pull-apart basins possess open fault recharge channels, maintaining a liquid-dominated hydrothermal convection circulation; the upper parts of some systems in West Java form low-permeability argillic caps due to hydrothermal rock alteration, and undergo boiling and phase separation driven by restricted recharge and basal heat flux, forming vapor-dominated geothermal systems. This review summarizes the controlling effects of different geodynamic backgrounds on the evolution of geothermal systems in Indonesia, providing a fundamental geological reference for the study of genetic mechanisms of geothermal fields in related active continental margins.

  • Open Access

    Prediction of Thermal Breakthrough and Parameter Optimization in Geothermal Reinjection Systems Based on Deep Neural Networks: A Case Study of the Qihe Geothermal Field

    by Li Du, Kefu Li, Fuchun Liu, Long Cui, Yanyu Jia, Chuanqing Zhu, Fuhao Zheng, Ze Zhang

    Predicting thermal breakthrough and optimizing injection-production parameters are essential for sustainable geothermal development. Traditional hydrothermal coupled simulations in porous media entail substantial computational costs, which limits their use in dense multi-parameter screening. This study develops a physics-constrained surrogate workflow for the Qihe geothermal doublet system by using COMSOL to generate hydrothermal simulation data and a deep neural network (DNN) to emulate the simulator response within a predefined operating domain. The DNN was trained on physics-driven synthetic outputs rather than independent field observations, and a 2.0 °C decrease in production temperature was used as the thermal breakthrough criterion. Under scenario-wise validation, the surrogate model achieved a test-set R2 of 0.9995 and an RMSE of 0.0351 °C, indicating accurate approximation of the deterministic simulator response within the bounded parameter space. The surrogate-based global scan identified a favorable operating region near a well spacing of 462 m, a reinjection temperature of 20 °C, and a reinjection rate of 150 m3/h. To evaluate whether this result was affected by sparse well-spacing sampling, additional COMSOL simulations were performed at 430, 440, 450, 460, 462, 470, 480, 490, and 500 m under the same reinjection temperature and rate. These simulator-based validation cases showed a continuous thermal response with increasing well spacing. The 2.0 °C thermal breakthrough time increased from 46 yr at 430 m to 61 yr at 500 m, while the 50-year cumulative heat extraction increased from 6594.2 to 6722.9 TJ. The 430 and 440 m cases experienced thermal breakthrough before the 50-year design life, whereas the 450 m case was close to the design boundary. The 460 and 462 m cases did not reach the 2.0 °C decline threshold within the 50-year design life and retained relatively high heat-extraction efficiency per unit well spacing. Therefore, the engineering recommendation is revised from a single precise optimum to a locally validated spacing interval of approximately 460–462 m under the present equivalent-porous-medium assumption. The proposed workflow does not replace hydrothermal simulation; instead, it provides a rapid screening tool that narrows the design space before targeted simulator verification and field calibration.

  • Open Access

    Temperature and Pressure Dependence of Thermal Conductivity in Deep Marine Carbonates: Correction Models and Geothermal Applications

    by Renhe Liu, Kefu Li, Xiaowan Tao, Chuanqing Zhu, Qiwen Yao, Jiabo Xu, Xianyao Sun, Taiyan Yu, Yanyu Jia

    The reconstruction of the ultradeep geothermal field is the foundation of deep oil and gas exploration, and the evolution of rock thermophysical properties under ultrahigh temperature and pressure environments directly affects the accuracy of geothermal prediction. Taking Well SDTK1 in the Tarim Basin as an example, this study employs a layered iteration algorithm based on geological parameters to conduct deep geothermal prediction and thermal conductivity model optimization under temperature-only, pressure-only, and coupled temperature–pressure conditions. Simulation results show that the dynamic correction effect of thermal conductivity exhibits significant depth-dependent differentiation. In Mesozoic–Cenozoic clastic rocks shallower than 6000 m, the prediction error generated by the constant thermal conductivity assumption is minor. However, upon entering the deep Paleozoic marine tight carbonate rocks, influenced by high temperatures, the uncorrected model leads to an underestimation of geothermal temperatures by up to 40–50 °C. Comparison among the correction models indicates that the compaction gain brought by formation pressure at a depth of 11000 m (a temperature decrease of 10.2 °C) is far insufficient to compensate for the thermal conduction attenuation caused by high temperatures (a temperature increase of 45.1 °C). The thermal resistance effect induced by high temperatures dominates the evolution of the deep geothermal field. Calibrated with measured data, the Chapman model, which possesses a larger temperature attenuation gradient, can better compensate for the thermal conduction attenuation of tight carbonate rocks at high temperatures, and its predicted geothermal temperature (206.7 °C) under the coupled correction model is closer to the actual value. This study demonstrates that in the evaluation of thermal history and hydrocarbon phase states in ultradeep basins, it is necessary to introduce a dynamic thermal conductivity correction model to effectively reduce prediction deviations of deep geothermal temperatures.

  • Open Access

    Tracing Experiments and Flow Characteristic Analyses in Carbonate Geothermal Reservoirs: A Case Study of the Juancheng Geothermal Field, North China

    by Yanyu Jia, Kefu Li, Li Du, Chuanqing Zhu, Fei Gao, Long Cui, Yaorong Shen, Haowei Fu

    Carbonate geothermal reservoirs, characterized by widespread distribution, a high discharge capacity, and favorable reinjection conditions, have become a key target for geothermal resource development. However, the karst geothermal reservoir system in the Juancheng geothermal field exhibits significant heterogeneity, leading to substantial disparities in productivity among multiple geothermal wells and severely restricting efficient regional exploitation. This study systematically investigates the hydraulic characteristics and development potential of the karst geothermal reservoir in the Juancheng geothermal field using sodium fluorescein tracing experiment technology. The results reveal that the reservoir system contains multiple flow channels with distinct permeability differences. The dominant flow pathways, controlled by fault structures, exhibit an apparent velocity of up to 10.98 m/h, significantly higher than other regions in the study area. In contrast, low-permeability zones, influenced by the burial depth of the Ordovician strata, show poor connectivity due to limited karst development, with the lowest apparent velocity of only 1.03 m/h. By integrating pumping test data and tracer response characteristics, the dominant flow direction (northeast) demonstrates a stronger recharge capacity and water abundance, offering a higher development value. Conversely, the southeast low-permeability zone has weaker water production and constrained recharge conditions, resulting in a relatively limited development potential. Additionally, it is recommended that the direction of future geothermal well placement in the Juancheng geothermal field should avoid being parallel to the fault strike to prolong the thermal breakthrough arrival time. In regions with deeper Ordovician strata burial, denser well network deployment is suggested to enhance the reservoir utilization efficiency.