Erjin Xu
Erjin Xu has a total of 20 co-authors. Here are the top co-authors by number of shared publications:
- Dongxue Wang
Nanxun Innovation Institute, Zhejiang University of Water Resources and Electric Power, Hangzhou 310018, China
2 shared publications - Zipeng Qin
Nanxun Innovation Institute, Zhejiang University of Water Resources and Electric Power, Hangzhou 310018, China
2 shared publications - Guoxun Chen
Wenzhou Water Conservancy Construction Management Center, Wenzhou 325608, China
1 shared publication - Hanwei Huang
Cangnan County Water Resources Bureau of Wenzhou City, Wenzhou 325899, China
1 shared publication - Huang Huang
Cangnan County Water Resources Bureau of Wenzhou City, Wenzhou 325899, China
1 shared publication - Jiayi Pan
Nanxun Innovation Institute, Zhejiang University of Water Resources and Electric Power, Hangzhou 310018, China
1 shared publication
Latest Publications
- Open Access
- 5 November 2025
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 13 (11) , 2105
Investigation of Water-Stability Behaviors in Coastal Mud Multiply Modified by Cement and Coarse-Particle Spoil
This study investigates the water-stability performance and stabilization mechanism of a hybrid-modified dredged muck sampled from the protection channel of the southern seawall, Cangnan County, China, and explores the feasibility of reusing the modified soil as backfill or non-structural fill behind the dike body. The muck was amended with two industrial by-products: (i) coarse-grained spoil excavated from an adjacent power-plant project, serving as a particle-size modifier, and (ii) ordinary Portland cement, acting as the chemical stabilizer. Unconfined compressive strength (UCS) tests were conducted on specimens cured for 7 d and 28 d under both saturated and unsaturated conditions, complemented by scanning electron microscopy (SEM) to elucidate microstructural evolution. An optimal mix proportion that satisfies the prescribed water-stability criterion while maintaining cost-effectiveness was thereby identified. Experimental results demonstrate that cement content, coarse-spoil fraction and curing age govern the water-stability behavior, with cement dosage exerting the most pronounced influence. A 28 d cured blend containing only 5% cement yielded a low water-stability coefficient (31.8%) and negligible post-immersion strength. Conversely, a ternary mixture comprising 40% muck, 60% coarse spoil and 15% cement achieved the highest water stability, recording UCS values of 1582 kPa (saturated) and 2025 kPa (unsaturated), corresponding to 78.1%. These findings provide a theoretical basis and practical guidance for the valorization of waste soils in coastal engineering and for the design/construction of seawalls. These findings not only provide a theoretical basis and practical guidance for the valorization of waste soils in coastal engineering and for the design/construction of seawalls, but also substantially expand the available material source, drive down construction costs, and markedly mitigate the environmental impacts associated with the off-site disposal of excavated waste.
- 5 November 2025
- Published by MDPI AG in Journal of Marine Science and Engineering
- Vol. 13 (11) , 2105
Open AccessInvestigation of Water-Stability Behaviors in Coastal Mud Multiply Modified by Cement and Coarse-Particle Spoil
This study investigates the water-stability performance and stabilization mechanism of a hybrid-modified dredged muck sampled from the protection channel of the southern seawall, Cangnan County, China, and explores the feasibility of reusing the modified soil as backfill or non-structural fill behind the dike body. The muck was amended with two industrial by-products: (i) coarse-grained spoil excavated from an adjacent power-plant project, serving as a particle-size modifier, and (ii) ordinary Portland cement, acting as the chemical stabilizer. Unconfined compressive strength (UCS) tests were conducted on specimens cured for 7 d and 28 d under both saturated and unsaturated conditions, complemented by scanning electron microscopy (SEM) to elucidate microstructural evolution. An optimal mix proportion that satisfies the prescribed water-stability criterion while maintaining cost-effectiveness was thereby identified. Experimental results demonstrate that cement content, coarse-spoil fraction and curing age govern the water-stability behavior, with cement dosage exerting the most pronounced influence. A 28 d cured blend containing only 5% cement yielded a low water-stability coefficient (31.8%) and negligible post-immersion strength. Conversely, a ternary mixture comprising 40% muck, 60% coarse spoil and 15% cement achieved the highest water stability, recording UCS values of 1582 kPa (saturated) and 2025 kPa (unsaturated), corresponding to 78.1%. These findings provide a theoretical basis and practical guidance for the valorization of waste soils in coastal engineering and for the design/construction of seawalls. These findings not only provide a theoretical basis and practical guidance for the valorization of waste soils in coastal engineering and for the design/construction of seawalls, but also substantially expand the available material source, drive down construction costs, and markedly mitigate the environmental impacts associated with the off-site disposal of excavated waste.
- Open Access
Experimental Investigation on Physical and Mechanical Behaviors of Paraffin Microcapsule Phase-Change Energy-Storage Concrete
Phase-change materials (PCMs) are gradually being applied in the field of building energy conservation due to their ability to absorb and release heat through phase changes within a specific temperature range. This study prepared a paraffin-microencapsulated phase-change aggregate (PCA) and used the equal volume sand replacement method to replace standard sand with PCA under a fixed water–cement ratio and curing conditions. Five sets of concrete specimens with varying PCA content were designed and tested for their apparent densities, compressive strengths, water absorptions, thermal conductivities, and microstructures. The experimental results show that the apparent density, compressive strength, ultrasonic velocity, and thermal conductivity of phase-change energy-storage concrete (PCC) gradually decrease with the increasing PCA content. Its apparent density, compressive strength, ultrasonic velocity, and thermal conductivity all reach their minimum values when the PCA content reaches 40%; minimum values are 2.07 g/cm3, 42.461 MPa (56 days), 8.93 km/s, and 1.43 W/(m·K), respectively. The water-absorption rate of PCC specimens exhibits non monotonic response characteristics with the variation of PCA dosage. This study can provide a theoretical basis for the preparation of PCCs by the PCA method.
Open AccessExperimental Investigation on Physical and Mechanical Behaviors of Paraffin Microcapsule Phase-Change Energy-Storage Concrete
Phase-change materials (PCMs) are gradually being applied in the field of building energy conservation due to their ability to absorb and release heat through phase changes within a specific temperature range. This study prepared a paraffin-microencapsulated phase-change aggregate (PCA) and used the equal volume sand replacement method to replace standard sand with PCA under a fixed water–cement ratio and curing conditions. Five sets of concrete specimens with varying PCA content were designed and tested for their apparent densities, compressive strengths, water absorptions, thermal conductivities, and microstructures. The experimental results show that the apparent density, compressive strength, ultrasonic velocity, and thermal conductivity of phase-change energy-storage concrete (PCC) gradually decrease with the increasing PCA content. Its apparent density, compressive strength, ultrasonic velocity, and thermal conductivity all reach their minimum values when the PCA content reaches 40%; minimum values are 2.07 g/cm3, 42.461 MPa (56 days), 8.93 km/s, and 1.43 W/(m·K), respectively. The water-absorption rate of PCC specimens exhibits non monotonic response characteristics with the variation of PCA dosage. This study can provide a theoretical basis for the preparation of PCCs by the PCA method.