Kazuhide Nakayama
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Kazuhide Nakayama has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Mitsuyasu Iwanami
Professor, Department of Civil and Environmental Engineering, School of Environment and Society, Tokyo Institute of Technology, Tokyo, Japan
4 shared publications - Nobuhiro Chijiwa
Tokyo Institute of Technology
2 shared publications C. Yoshii
Politecnico di Milano, Milan, Italy
1 shared publication- Fabio Biondini
Department of Civil and Environmental Engineering, Politecnico di Milano
1 shared publication Hiroaki Sogawa
東京工業大学 環境・社会理工学院 土木・環境工学系 土木工学コース (現 国土交通省)
1 shared publication- Shuji Nagaoka
PhD Student, Department of Civil and Environmental Engineering, School of Environment and Society, Tokyo Institute of Technology, Tokyo, Japan: )
1 shared publication
Latest Publications
- Open Access
- 20 June 2025
- Published by Elsevier in Construction and Building Materials
- Vol. 489
MICP using calcium-rich waste solution from acetic acid treatment as a calcium source to improve the properties of recycled coarse aggregate
- 20 June 2025
- Published by Elsevier in Construction and Building Materials
- Vol. 489
Open AccessMICP using calcium-rich waste solution from acetic acid treatment as a calcium source to improve the properties of recycled coarse aggregate
- 1 May 2025
- Published by Emerald Publishing in Proceedings of the Institution of Civil Engineers - Construction Materials
- Vol. 178 (2-3) , 94-105
Analysis of impedance data of silane-treated concrete obtained by four-probe method
Electrochemical impedance spectroscopy (EIS) using the four-probe method was investigated as a non-destructive testing technique for quantitatively evaluating the protective effect of silane-treated concrete. Silane-treated concrete exhibits distinct electrical characteristics between the surface silane-modified layer and the internal unmodified layer, and the impact of these characteristics on four-probe measurements had previously been unclear. To address this, four-probe EIS measurements were conducted on silane-treated concrete, followed by finite-element (FE) analysis to simulate the results and parametric studies to clarify the effects of silane penetration depth and the distribution of electrical properties. The actual silane-treated specimens exhibited an oval capacitive loop, attributed to the non-uniform thickness of the silane-treated layer. Furthermore, it was found that when the electrode spacing in four-probe EIS was reduced beyond a certain threshold, the measured electrical resistance significantly increased compared with larger electrode spacing. FE analysis suggested that this was due to the smaller electrode spacing causing the current to concentrate in the surface silane-modified layer, which has a higher resistivity.
- 1 May 2025
- Published by Emerald Publishing in Proceedings of the Institution of Civil Engineers - Construction Materials
- Vol. 178 (2-3) , 94-105
Analysis of impedance data of silane-treated concrete obtained by four-probe method
Electrochemical impedance spectroscopy (EIS) using the four-probe method was investigated as a non-destructive testing technique for quantitatively evaluating the protective effect of silane-treated concrete. Silane-treated concrete exhibits distinct electrical characteristics between the surface silane-modified layer and the internal unmodified layer, and the impact of these characteristics on four-probe measurements had previously been unclear. To address this, four-probe EIS measurements were conducted on silane-treated concrete, followed by finite-element (FE) analysis to simulate the results and parametric studies to clarify the effects of silane penetration depth and the distribution of electrical properties. The actual silane-treated specimens exhibited an oval capacitive loop, attributed to the non-uniform thickness of the silane-treated layer. Furthermore, it was found that when the electrode spacing in four-probe EIS was reduced beyond a certain threshold, the measured electrical resistance significantly increased compared with larger electrode spacing. FE analysis suggested that this was due to the smaller electrode spacing causing the current to concentrate in the surface silane-modified layer, which has a higher resistivity.
- Open Access
- 28 June 2023
- Published by Taylor & Francis
- p. 3680-3687
Simulation of chloride ingress into aging surface-coated concrete
This paper presents a calibration of prediction model for chloride ingress into surface-treated reinforced concrete (RC) structures. Since the research on long-term durability of the coating materials is still limited, the coating degradation model about chloride resistivity is investigated and established from experimental results with accelerated deterioration tests and chloride migration tests (CMT). On the other hand, the results of AgNO3 spray tests for surface-coated concrete specimens exposed to CMT show that chloride ions would penetrate mainly from the defective areas such as cracks and delamination in surfaces. Therefore, two different deterioration models are proposed for the coating system: averaged time-variant diffusivity and increase of local defects in coated surface. The deterioration models are implemented into diffusion analysis based on cellular automata and applied to a coated RC cross-section to investigate the residual lifetime associated with corrosion initiation of steel reinforcement.
- 28 June 2023
- Published by Taylor & Francis
- p. 3680-3687
Open AccessSimulation of chloride ingress into aging surface-coated concrete
This paper presents a calibration of prediction model for chloride ingress into surface-treated reinforced concrete (RC) structures. Since the research on long-term durability of the coating materials is still limited, the coating degradation model about chloride resistivity is investigated and established from experimental results with accelerated deterioration tests and chloride migration tests (CMT). On the other hand, the results of AgNO3 spray tests for surface-coated concrete specimens exposed to CMT show that chloride ions would penetrate mainly from the defective areas such as cracks and delamination in surfaces. Therefore, two different deterioration models are proposed for the coating system: averaged time-variant diffusivity and increase of local defects in coated surface. The deterioration models are implemented into diffusion analysis based on cellular automata and applied to a coated RC cross-section to investigate the residual lifetime associated with corrosion initiation of steel reinforcement.
- 1 January 2021
- Published by Japan Society of Civil Engineers in Journal of Japan Society of Civil Engineers, Ser. F4 (Construction and Management)
- Vol. 77 (1) , 172-190
道路の維持管理業務に着目した包括的民間委託導入に向けた土木行政における地方自治体職員の意思決定行動の分析
地方自治体が効率的な道路の維持管理を行う上で,包括的民間委託の導入が有効であるとされている.しかし,費用削減効果が得られる可能性が十分あるにもかかわらず,行政職員の意思決定が消極的になる場合がある.本研究では,不確実性下における意思決定理論であるプロスペクト理論に着目し,行政職員の行動特性を加味した包括的民間委託導入に対する効用計算モデルを構築した上で,行動経済学に基づき行政職員の行動特性を特定し意思決定行動の分析を行った.その結果,導入の検討を前提としない状況から導入の検討を前提とするように行政職員の行動変容を促すことが,行政職員に包括的民間委託の導入メリットを感じやすくさせるのに有効であることを示し,そのための具体的な方法としてナッジを提案した.
- 1 January 2021
- Published by Japan Society of Civil Engineers in Journal of Japan Society of Civil Engineers, Ser. F4 (Construction and Management)
- Vol. 77 (1) , 172-190
道路の維持管理業務に着目した包括的民間委託導入に向けた土木行政における地方自治体職員の意思決定行動の分析
地方自治体が効率的な道路の維持管理を行う上で,包括的民間委託の導入が有効であるとされている.しかし,費用削減効果が得られる可能性が十分あるにもかかわらず,行政職員の意思決定が消極的になる場合がある.本研究では,不確実性下における意思決定理論であるプロスペクト理論に着目し,行政職員の行動特性を加味した包括的民間委託導入に対する効用計算モデルを構築した上で,行動経済学に基づき行政職員の行動特性を特定し意思決定行動の分析を行った.その結果,導入の検討を前提としない状況から導入の検討を前提とするように行政職員の行動変容を促すことが,行政職員に包括的民間委託の導入メリットを感じやすくさせるのに有効であることを示し,そのための具体的な方法としてナッジを提案した.