Abuzar Fuad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Abuzar Fuad has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Dafalla Wadi
Department of Hydrogeology and Engineering Geology, College of Petroleum Geology and Minerals, University of Bahri, Khartoum 11111, Sudan
4 shared publications - Wenbing Wu
Faculty of Engineering, China University of Geosciences, Wuhan 430074, China
2 shared publications Husam Eldin Ahmed
Sea Ports Corporation, Engineering Tests Lab, Port Sudan, Sudan
1 shared publication- Husam Eldin Ahmed
Sea Ports Corporation, Engineering Tests Lab, Port Sudan, Sudan
1 shared publication - Ibrahim Malik
Department of Geology, Faculty of Petroleum and Minerals, Al-Neelain University, Khartoum, Sudan
1 shared publication Khalid Mustafa
1 shared publication
Latest Publications
- Open Access
- 17 December 2025
- Published by Elsevier in Scientific African
- Vol. 31
Integrating geospatial and geophysical approaches to identify aquifer recharge zones in the Um-Rakuba basin, eastern Sudan
- 17 December 2025
- Published by Elsevier in Scientific African
- Vol. 31
Open AccessIntegrating geospatial and geophysical approaches to identify aquifer recharge zones in the Um-Rakuba basin, eastern Sudan
- Open Access
- 15 June 2025
- Published by Digitodontics International Academy in University of Zawia Journal of Engineering Sciences and Technology
- Vol. 3 (1) , 118-135
Assessment of soil liquefaction potential using the standard penetration test at Port Sudan
Liquefaction is one of the most critical ground deformations in saturated or partially saturated silty and sandy soils. This deformation may cause severe destruction, such as settlement and building tilting. A standard penetration test (SPT) is commonly used to estimate liquefaction potential. This study integrates SPT, unit weight, and fine content data measurements from 24 boreholes in Port Sudan to evaluate and identify the liquefaction potential and factor of safety (F.S.) in earthquake scenarios. The liquefaction parameters were derived according to the simplified procedure in this scope. The result showed that the subsurface soil up to 15 meters is saturated with grain sizes varying from medium to fine sand, silt, and clay. Based on calculated parameters and fine content, the area falls within the high risk of liquefaction by a 7.5 (Mw) earthquake. The F.S. is mainly less than one in the upper 15 m. The liquefaction potential index is assessed using a peak horizontal ground acceleration of 0.15 g for an earthquake scenario of magnitude 7.5. The proposed approach proved to be a rapid and reliable method for investigating the liquefaction of sandy soil under earthquakes.
- 15 June 2025
- Published by Digitodontics International Academy in University of Zawia Journal of Engineering Sciences and Technology
- Vol. 3 (1) , 118-135
Open AccessAssessment of soil liquefaction potential using the standard penetration test at Port Sudan
Liquefaction is one of the most critical ground deformations in saturated or partially saturated silty and sandy soils. This deformation may cause severe destruction, such as settlement and building tilting. A standard penetration test (SPT) is commonly used to estimate liquefaction potential. This study integrates SPT, unit weight, and fine content data measurements from 24 boreholes in Port Sudan to evaluate and identify the liquefaction potential and factor of safety (F.S.) in earthquake scenarios. The liquefaction parameters were derived according to the simplified procedure in this scope. The result showed that the subsurface soil up to 15 meters is saturated with grain sizes varying from medium to fine sand, silt, and clay. Based on calculated parameters and fine content, the area falls within the high risk of liquefaction by a 7.5 (Mw) earthquake. The F.S. is mainly less than one in the upper 15 m. The liquefaction potential index is assessed using a peak horizontal ground acceleration of 0.15 g for an earthquake scenario of magnitude 7.5. The proposed approach proved to be a rapid and reliable method for investigating the liquefaction of sandy soil under earthquakes.
- Open Access
- 18 May 2025
- Published by Medical Research Center in AlQalam Journal of Medical and Applied Sciences
- p. 896-906
Prediction of Cone Penetration Test Data from Standard Penetration Test Attributes using Support Vector Regression Neural Networks
Although the cone penetration test (CPT) is essential for geotechnical design, it is often not economically feasible and time-consuming to perform the tests at all sites. This work used data from Port Sudan City to create a model to predict CPT values from Standard Penetration Test (SPT) attributes using a Support Vector Regression (SVR) algorithm. This approach converted the SPT into attribute combinations through a stepwise regression analysis. Subsequently, the attributes were converted to CPT by training the SVR neural network with the available CPT data. Cross-validation was performed to assess the credibility of the SPT parameters in the CPT transformation. In this procedure, a quarter of the data set is omitted from the training set each time, and the transformation is recalculated. Next, the accuracy of the transformation in estimating CPT from the deleted data is evaluated; this procedure is applied to all data in the training set. The results show that comparing the actual and predicted CPT gives a good agreement, as indicated by high correlation coefficient values for the training and test data sets. This approach can be used for automated estimation of CPT from SPT parameters and can serve as an extension of conventional techniques.
- 18 May 2025
- Published by Medical Research Center in AlQalam Journal of Medical and Applied Sciences
- p. 896-906
Open AccessPrediction of Cone Penetration Test Data from Standard Penetration Test Attributes using Support Vector Regression Neural Networks
Although the cone penetration test (CPT) is essential for geotechnical design, it is often not economically feasible and time-consuming to perform the tests at all sites. This work used data from Port Sudan City to create a model to predict CPT values from Standard Penetration Test (SPT) attributes using a Support Vector Regression (SVR) algorithm. This approach converted the SPT into attribute combinations through a stepwise regression analysis. Subsequently, the attributes were converted to CPT by training the SVR neural network with the available CPT data. Cross-validation was performed to assess the credibility of the SPT parameters in the CPT transformation. In this procedure, a quarter of the data set is omitted from the training set each time, and the transformation is recalculated. Next, the accuracy of the transformation in estimating CPT from the deleted data is evaluated; this procedure is applied to all data in the training set. The results show that comparing the actual and predicted CPT gives a good agreement, as indicated by high correlation coefficient values for the training and test data sets. This approach can be used for automated estimation of CPT from SPT parameters and can serve as an extension of conventional techniques.
- 15 March 2019
- Published by Springer Nature
- p. 333-336
Evaluation of the Potential for Artificial Groundwater Recharge of Crystalline Rocks Aquifer, Nuba Mountains (Sudan)
- 15 March 2019
- Published by Springer Nature
- p. 333-336
Evaluation of the Potential for Artificial Groundwater Recharge of Crystalline Rocks Aquifer, Nuba Mountains (Sudan)