LJLi-Ying Jiang

Li-Ying Jiang

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Li-Ying Jiang has a total of 16 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Microcavity-based parallel measurements of optical power and wavelength

    by Yan Wang, Yu-Hao Hu, Jin-Lei Wu, Jian Tang, Ya-Feng Jiao, Ya-Chuan Liang, Hai-Yan Wang, Li-Ying Jiang, Le-Man Kuang, Ke-Yu Xia, et al.

    Accurate determination of light power and wavelength is fundamental to nearly all optical and laser applications. However, simultaneous and precise measurements of these two parameters remain a critical challenge due to intrinsic cross-sensitivity in conventional devices. Here, we propose and demonstrate a dual-parameter decoupling strategy based on photothermal whispering gallery mode (WGM) microcavities, enabling parallel measurements of both optical power and wavelength without cross-sensitivity. Optical absorption of the pump light by the composite microcavity produces increased temperatures that are proportional to the pump power and wavelength of the light, resulting in a wavelength shift in the WGM resonance of the microcavity. We demonstrate a record-high photothermal tuning sensitivity of ∼−4 nm/mW and an ultralow detection limit of thermal power down to 4 μW, both of which surpass all previous schemes by more than an order of magnitude. With a linear response to the pump wavelength, the designed microcavity allows for near-infrared wavelength measurement over a broad bandwidth from 780 to 1064 nm. Importantly, by introducing the decoupling strategy that employs spectral changes of two microcavities with asymmetric responses, we demonstrate parallel measurements of both optical power and wavelength with high accuracy. As the first proof-of-principle demonstration of a single optical power–wavelength measurer using optical microcavities, our work could advance various applications relying on miniaturized and precise optical metrology devices.


  • Open Access

    Label-free fluorescence aptasensor based on AuNPs and CQDs for the detection of ATP

    by Linjiao Ren, Peng Xu, Pei Zhang, Zirui Qin, Yintang Zhang, Liying Jiang

    A label-free fluorescence aptasensor was studied for adenosine triphosphate (ATP) detection that combines low biosensor toxicity with a simplified preparation process. In this study, the aptamer of the gold [email protected]@carbon quantum dot nanostructure could specifically identify ATP, resulting in the change of the fluorescence signal. In order to analyze the performance of the sensor, the effects of the carbon quantum dot (CQD) concentration and centrifugal rate on the stability of the probe were investigated. The results show that the sensor was superior under the 220 µl CQD volume and 2000 rpm centrifugal rate. Furthermore, the linear relationship between the change of the fluorescence signal and ATP concentration is Y = 359.747 + 0.226X within the volume range of 20 µM–280 µM. The correlation coefficient is 0.98, and the detection limit is 20 µM. No obvious fluorescence change was observed in solutions containing other common ions. On the basis of no pollution and simplicity, this sensor demonstrates great potential as a low-cost diagnostic tool for the detection of various targets, particularly for use in the fields of food safety and biomedical diagnostics.