José F. Adell
Research Subjects
José F. Adell has a total of 54 co-authors. Here are the top co-authors by number of shared publications:
D.E. Diaz-Droguett
2 shared publications- Donovan E. Diaz-Droguett
Pontificia Universidad Católica de Chile
2 shared publications - Ulrich Georg Volkmann
Facultad de Física, Pontificia Universidad Católica de Chile, Santiago, Chile
2 shared publications - A. Vergara-Pacheco
Centro de Nanotecnología Aplicada, Facultad de Ciencias, Ingeniería y Tecnología, Universidad Mayor, Camino La Pirámide 5750, 8580745 Huechuraba, Santiago RM Chile
1 shared publication A.L. Cabrera
1 shared publication- Alvaro Mella1 shared publication
Latest Publications
- Open Access
- 4 April 2026
- Published by Elsevier in SSRN Electronic Journal
High-Sensitivity SERS Platforms Based on E-beam Evaporated Gold Nanostructures: A Robust Physical Route for Ultralow Detection
Physically deposited plasmonic nanostructures offer an attractive route toward reproducible and scalable Surface-enhanced Raman spectroscopy (SERS) substrates, yet their analytical performance must be quantitatively linked to morphology and plasmonic coupling. Here, nanostructured Au substrates are fabricated by single-step electron-beam (e-beam) evaporation process and evaluated for ultrasensitive detection of Rhodamine B (RhB). Atomic force microscopy, scanning electron microscopy, and UV-VIS spectroscopy reveal a thickness-dependent evolution from isolated nanostructures to a network near the percoaltion threshold where electromagnetic hot spots dominate. An optimal nominal Au thickness of 7-8 nm is identified. Raman mapping over 15 locations yields a relative standard deviation (RSD) of 3.5\%, confirming excellent spatial uniformity. Substrate reusability is assessed through repeated adsorption and washing cycles in ethanol, where the recovered RhB signal remains at approximately 90\% of the initial intensity, with a cycle-to-cycle RSD of 8.5\%, while post-wash residual signals remain consistently low. Under the optimized conditions, RhB is detected down to a theoretical limit of detection of $8.5 \times 10^{-11}$ M and a representative average enhancement factor of $(1.01 \pm 0.67)\times10^{6}$ is obtained in the low-coverage regime. These results show that the SERS response is governed by interparticle coupling and collective plasmonic effects rather than isolated nanoparticle resonances, and demonstrate that e-beam evaporated Au nanostructure networks provide a robust and competitive SERS platform with a fabrication route that is rapid, reproducible, and compatible with large-area sensor integration.- 4 April 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessHigh-Sensitivity SERS Platforms Based on E-beam Evaporated Gold Nanostructures: A Robust Physical Route for Ultralow Detection
Physically deposited plasmonic nanostructures offer an attractive route toward reproducible and scalable Surface-enhanced Raman spectroscopy (SERS) substrates, yet their analytical performance must be quantitatively linked to morphology and plasmonic coupling. Here, nanostructured Au substrates are fabricated by single-step electron-beam (e-beam) evaporation process and evaluated for ultrasensitive detection of Rhodamine B (RhB). Atomic force microscopy, scanning electron microscopy, and UV-VIS spectroscopy reveal a thickness-dependent evolution from isolated nanostructures to a network near the percoaltion threshold where electromagnetic hot spots dominate. An optimal nominal Au thickness of 7-8 nm is identified. Raman mapping over 15 locations yields a relative standard deviation (RSD) of 3.5\%, confirming excellent spatial uniformity. Substrate reusability is assessed through repeated adsorption and washing cycles in ethanol, where the recovered RhB signal remains at approximately 90\% of the initial intensity, with a cycle-to-cycle RSD of 8.5\%, while post-wash residual signals remain consistently low. Under the optimized conditions, RhB is detected down to a theoretical limit of detection of $8.5 \times 10^{-11}$ M and a representative average enhancement factor of $(1.01 \pm 0.67)\times10^{6}$ is obtained in the low-coverage regime. These results show that the SERS response is governed by interparticle coupling and collective plasmonic effects rather than isolated nanoparticle resonances, and demonstrate that e-beam evaporated Au nanostructure networks provide a robust and competitive SERS platform with a fabrication route that is rapid, reproducible, and compatible with large-area sensor integration. - Open Access
- 10 February 2026
- Published by Elsevier in SSRN Electronic Journal
Microstructural studies and photoelectrochemical characterization of Laser-Engineered Pyrolytic N@Carbon-TiO2 Nanocomposite Microelectrode for Ultraviolet Intensity-Dependent Photocharging Microsupercapacitor
Herein, we report a series of carbonized titanium oxide composite (CTPs) electrode materials, synthesized via pyrolysis of polyaniline titanium isopropoxide precursors and engineered for high-performance, photocharging microsupercapacitor (MSC) device. Microstructural and chemical state analyses revealed the formation of a nanostructured nitrogen-doped graphitic carbon matrix embedded with semicrystalline anatase TiO2, exhibiting synergistic structural interactions and defect-induced photoactivity. Among the series, the optimum CTP sample demonstrated the most favorable optoelectronic and electrochemical characteristics, with a moderate optical bandgap (~3.55 eV), strong UV absorption and light-matter interactions, and high specific capacitance (456 F g-1 at 1 mA cm-2). A laser-induced interdigitated MSC prototype device based on optimum CTP was fabricated and evaluated under both dark and UV-illuminated conditions. Cyclic voltammetry and galvanostatic charge-discharge analyses revealed enhanced areal capacitance from 3.81 mF cm-2 (dark) to 5.92 mF cm-2 (12.5 mW cm-2 UV), alongside improved energy density (0.72 μWh cm-2), and long discharge durations. Electrochemical impedance spectroscopy confirmed reduced series resistance and steeper Warburg slopes under illumination. Mott–Schottky analysis further evidenced increased donor density and a negative shift in flat-band potential with increasing UV intensity. The results unveiled the CTP microsupercapacitor’s viability as a light-tunable, photo-rechargeable energy storage platform for self-powered microelectronics devices.
- 10 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessMicrostructural studies and photoelectrochemical characterization of Laser-Engineered Pyrolytic N@Carbon-TiO2 Nanocomposite Microelectrode for Ultraviolet Intensity-Dependent Photocharging Microsupercapacitor
Herein, we report a series of carbonized titanium oxide composite (CTPs) electrode materials, synthesized via pyrolysis of polyaniline titanium isopropoxide precursors and engineered for high-performance, photocharging microsupercapacitor (MSC) device. Microstructural and chemical state analyses revealed the formation of a nanostructured nitrogen-doped graphitic carbon matrix embedded with semicrystalline anatase TiO2, exhibiting synergistic structural interactions and defect-induced photoactivity. Among the series, the optimum CTP sample demonstrated the most favorable optoelectronic and electrochemical characteristics, with a moderate optical bandgap (~3.55 eV), strong UV absorption and light-matter interactions, and high specific capacitance (456 F g-1 at 1 mA cm-2). A laser-induced interdigitated MSC prototype device based on optimum CTP was fabricated and evaluated under both dark and UV-illuminated conditions. Cyclic voltammetry and galvanostatic charge-discharge analyses revealed enhanced areal capacitance from 3.81 mF cm-2 (dark) to 5.92 mF cm-2 (12.5 mW cm-2 UV), alongside improved energy density (0.72 μWh cm-2), and long discharge durations. Electrochemical impedance spectroscopy confirmed reduced series resistance and steeper Warburg slopes under illumination. Mott–Schottky analysis further evidenced increased donor density and a negative shift in flat-band potential with increasing UV intensity. The results unveiled the CTP microsupercapacitor’s viability as a light-tunable, photo-rechargeable energy storage platform for self-powered microelectronics devices.
- 15 October 2025
- Published by Elsevier in Surfaces and Interfaces
- Vol. 76
Hierarchical surface texturing increases the contact-killing effect of marine bacteria Pseudomonas sp. on 316 L Stainless steel
- 15 October 2025
- Published by Elsevier in Surfaces and Interfaces
- Vol. 76
Hierarchical surface texturing increases the contact-killing effect of marine bacteria Pseudomonas sp. on 316 L Stainless steel
- 6 September 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 172
In situ electrochemical synthesis of rhenium oxide-reduced graphene oxide hybrid electrodes for enhanced water splitting
- 6 September 2025
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 172
In situ electrochemical synthesis of rhenium oxide-reduced graphene oxide hybrid electrodes for enhanced water splitting
- 20 June 2025
- Published by Elsevier in Applied Surface Science
- Vol. 709
Tailoring of titanium dioxide thin film in dual radiofrequency plasma enhanced pulsed laser deposition
- 20 June 2025
- Published by Elsevier in Applied Surface Science
- Vol. 709
Tailoring of titanium dioxide thin film in dual radiofrequency plasma enhanced pulsed laser deposition