Anas Krime
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Anas Krime has a total of 31 co-authors. Here are the top co-authors by number of shared publications:
- Elisabete Palma Carreiro
Associate Laboratory for Green Chemistry—LAQV-REQUIMTE, IIFA, University of Evora, 7000-671 Evora, Portugal
3 shared publications - El Fadili Hamza
Geology & Sustainable Mining Institute (GSMI), Mohammed VI Polytechnic University (UM6P), Ben Guerir, Morocco
2 shared publications - Mouhaydine Tlemçani
Instrumentation and Control Laboratory-LAICA, Center for Sci-Tech Research in Earth system and Energy-CREATE, University of Evora, 7000-671 Evora, Portugal
2 shared publications - Nordine Nouayti
Applied Sciences Laboratory, Water and Environment Management Team, National School of Applied Sciences, Abdelmalek Essaadi University, Al Hoceima 32002, Morocco
2 shared publications - Rachid Zarzouki
Laboratory of Applied Sciences, Research Team of Water and Environment Management (G2E), ENSA Al Hoceima, Abdelmalek Essaâdi University, Tetouan, Morocco
2 shared publications - Soufiane Hasni
Biology Department, Faculty of Sciences and Technology of Tangier, Abdelmalek Essaâdi University, Tetouan, Morocco
2 shared publications
Latest Publications
- 1 July 2026
- Published by Springer Nature in Mediterranean Geoscience Reviews
- Vol. 8 (3) , 1-22
Multimethod assessment of groundwater quality and associated health risks in the semi-arid middle Moulouya agricultural basin (Morocco)
- 1 July 2026
- Published by Springer Nature in Mediterranean Geoscience Reviews
- Vol. 8 (3) , 1-22
Multimethod assessment of groundwater quality and associated health risks in the semi-arid middle Moulouya agricultural basin (Morocco)
- Open Access
Kinetic Analysis of Raw and Decarbonated Moroccan Oil Shale Using Models Fitting and Isoconversional Methods
Given the depletion of conventional oil and gas resources, oil shale represents a promising alternative source of hydrocarbons that can be recovered through pyrolysis. This study examines the thermal decomposition of raw oil shale from the Tarfaya deposit and its decarbonized concentrate, studied by thermogravimetric analysis at different heating rates (5, 10, 20 and 40 °C/min). Pretreatment with acetic acid enabled the selective removal of calcite, confirmed by elemental, XRF, and XRD analyses, which revealed a relative enrichment in silica and dolomite in the oil shale concentrate. Pyrolysis of the raw shale occurs primarily between 300 and 500 °C, with a conversion rate of approximately 30%. In contrast, for the oil shale concentrate, the pyrolysis process begins at a relatively low temperature, within a wider temperature range (260–520 °C). Kinetic analysis based on Flynn–Wall–Ozawa (FWO) and Kissinger–Akahira–Sunose (KAS) methods shows that at a conversion rate of 60%, the activation energy achieves 14.09 kJ/mol and 10.78 kJ/mol, respectively. The results indicate that the selective removal of calcite by acetic acid treatment facilitates kerogen pyrolysis by reducing mineral–organic interactions. Indeed, calcite dilutes the reactive organic fraction and can act as a physical barrier limiting heat and mass transfer within the oil shale. Its removal improves, on the one hand, the accessibility of kerogen to thermal cracking and promotes its decomposition, and on the other hand, reduces the amount of residue after pyrolysis. In addition, the kinetic analysis based on Criado master curves reveals changes in the reaction mechanism after decarbonation treatment depending on the heating rate (β). A shift from a two-dimensional Avrami–Erofeev model (A2) to a three-dimensional model (A3) was observed at a low heating rate (β = 5 °C/min), suggesting a change in nucleation and growth dynamics during kerogen decomposition. At high heating rates (10, 20 and 40 °C/min), the thermal decomposition of kerogen combines several reaction mechanisms depending on the temperature range considered.
Open AccessKinetic Analysis of Raw and Decarbonated Moroccan Oil Shale Using Models Fitting and Isoconversional Methods
Given the depletion of conventional oil and gas resources, oil shale represents a promising alternative source of hydrocarbons that can be recovered through pyrolysis. This study examines the thermal decomposition of raw oil shale from the Tarfaya deposit and its decarbonized concentrate, studied by thermogravimetric analysis at different heating rates (5, 10, 20 and 40 °C/min). Pretreatment with acetic acid enabled the selective removal of calcite, confirmed by elemental, XRF, and XRD analyses, which revealed a relative enrichment in silica and dolomite in the oil shale concentrate. Pyrolysis of the raw shale occurs primarily between 300 and 500 °C, with a conversion rate of approximately 30%. In contrast, for the oil shale concentrate, the pyrolysis process begins at a relatively low temperature, within a wider temperature range (260–520 °C). Kinetic analysis based on Flynn–Wall–Ozawa (FWO) and Kissinger–Akahira–Sunose (KAS) methods shows that at a conversion rate of 60%, the activation energy achieves 14.09 kJ/mol and 10.78 kJ/mol, respectively. The results indicate that the selective removal of calcite by acetic acid treatment facilitates kerogen pyrolysis by reducing mineral–organic interactions. Indeed, calcite dilutes the reactive organic fraction and can act as a physical barrier limiting heat and mass transfer within the oil shale. Its removal improves, on the one hand, the accessibility of kerogen to thermal cracking and promotes its decomposition, and on the other hand, reduces the amount of residue after pyrolysis. In addition, the kinetic analysis based on Criado master curves reveals changes in the reaction mechanism after decarbonation treatment depending on the heating rate (β). A shift from a two-dimensional Avrami–Erofeev model (A2) to a three-dimensional model (A3) was observed at a low heating rate (β = 5 °C/min), suggesting a change in nucleation and growth dynamics during kerogen decomposition. At high heating rates (10, 20 and 40 °C/min), the thermal decomposition of kerogen combines several reaction mechanisms depending on the temperature range considered.
- Open Access
Spatial Distribution, Health Risks and Heavy Metal Pollution Assessment of Surface Water Under Multiple Anthropogenic Stressors: Case Study in Middle Moulouya Watershed, Morocco
The worldwide issue of surface water contamination by heavy metals is a matter of great concern, as it has the potential to affect human health. This study intended to compute heavy metal contamination and human health risks in surface water using the following pollution indices: heavy metal pollution index (HPI), contamination index (CI), metal index (MI), ecological risk index (ERI), human health risk and statistical analysis. For this purpose, eleven water samples were gathered and analyzed by ICP-AES for trace metals such as Pb, As, Zn, Cd, Cu, and Ni. The results showed that heavy metal concentrations varied significantly throughout the study area, with Pb, As, and Cd levels exceeding the WHO limits for drinking purposes. Pollution indices indicated low to high water contamination, with HPI results ranging from 16.41 to 862.18 and from 12.76 to 774.03, above the critical value of 100, requiring serious interventions to reduce heavy metal pollution. MI results range from 0.90 to 20.92 and from 0.70 to 18.41 and CI values range from 0.34 to 20.38 and from 0.15 to 17.86 in the dry and wet periods, respectively, with different contamination levels observed throughout the study area; ERI showed low to considerable ecological risk. Nonetheless, the non-carcinogenic risk, THI < 1, indicates low health risks, while the carcinogenic risk for As and Cd was significantly higher than the negligible threshold of 10−6, suggesting tolerable health risks. However, managing the contaminated area and minimizing the metal concentrations and predominant routes through which metals impact human health should be priorities for long-term development and to establish a favorable environment.
Open AccessSpatial Distribution, Health Risks and Heavy Metal Pollution Assessment of Surface Water Under Multiple Anthropogenic Stressors: Case Study in Middle Moulouya Watershed, Morocco
The worldwide issue of surface water contamination by heavy metals is a matter of great concern, as it has the potential to affect human health. This study intended to compute heavy metal contamination and human health risks in surface water using the following pollution indices: heavy metal pollution index (HPI), contamination index (CI), metal index (MI), ecological risk index (ERI), human health risk and statistical analysis. For this purpose, eleven water samples were gathered and analyzed by ICP-AES for trace metals such as Pb, As, Zn, Cd, Cu, and Ni. The results showed that heavy metal concentrations varied significantly throughout the study area, with Pb, As, and Cd levels exceeding the WHO limits for drinking purposes. Pollution indices indicated low to high water contamination, with HPI results ranging from 16.41 to 862.18 and from 12.76 to 774.03, above the critical value of 100, requiring serious interventions to reduce heavy metal pollution. MI results range from 0.90 to 20.92 and from 0.70 to 18.41 and CI values range from 0.34 to 20.38 and from 0.15 to 17.86 in the dry and wet periods, respectively, with different contamination levels observed throughout the study area; ERI showed low to considerable ecological risk. Nonetheless, the non-carcinogenic risk, THI < 1, indicates low health risks, while the carcinogenic risk for As and Cd was significantly higher than the negligible threshold of 10−6, suggesting tolerable health risks. However, managing the contaminated area and minimizing the metal concentrations and predominant routes through which metals impact human health should be priorities for long-term development and to establish a favorable environment.
- Open Access
Turning Waste into Wealth: Sustainable Amorphous Silica from Moroccan Oil Shale Ash
Moroccan oil shale ash (MOSA) represents an underutilized industrial by-product, particularly in the Rif region, where its high mineral content has often led to its neglect in value-added applications. This study highlights the successful conversion of MOSA into amorphous mesoporous silica (AS-Si) using a sol–gel process assisted by polyethylene glycol (PEG-6000) as a soft template. The resulting AS-Si material was extensively characterized to confirm its potential for environmental remediation. FTIR analysis revealed characteristic vibrational bands corresponding to Si–OH and Si–O–Si bonds, while XRD confirmed its amorphous nature with a broad diffraction peak at 2θ ≈ 22.5°. SEM imaging revealed a highly porous, sponge-like morphology composed of aggregated nanoscale particles, consistent with the nitrogen adsorption–desorption isotherm. The material exhibited a specific surface area of 68 m2/g, a maximum in the pore size distribution at a pore diameter of 2.4 nm, and a cumulative pore volume of 0.11 cm3/g for pores up to 78 nm. DLS analysis indicated an average hydrodynamic diameter of 779 nm with moderate polydispersity (PDI = 0.48), while a zeta potential of –34.10 mV confirmed good colloidal stability. Furthermore, thermogravimetric analysis (TGA) and DSC suggested the thermal stability of our amorphous silica. The adsorption performance of AS-Si was evaluated using methylene blue (MB) and ciprofloxacin (Cipro) as model pollutants. Kinetic data were best fitted by the pseudo-second-order model, while isotherm studies favored the Langmuir model, suggesting monolayer adsorption. AS-Si could be used four times for the removal of MB and Cipro. These results collectively demonstrate that AS-Si is a promising, low-cost, and sustainable adsorbent derived from Moroccan oil shale ash for the effective removal of organic contaminants from aqueous media.
Open AccessTurning Waste into Wealth: Sustainable Amorphous Silica from Moroccan Oil Shale Ash
Moroccan oil shale ash (MOSA) represents an underutilized industrial by-product, particularly in the Rif region, where its high mineral content has often led to its neglect in value-added applications. This study highlights the successful conversion of MOSA into amorphous mesoporous silica (AS-Si) using a sol–gel process assisted by polyethylene glycol (PEG-6000) as a soft template. The resulting AS-Si material was extensively characterized to confirm its potential for environmental remediation. FTIR analysis revealed characteristic vibrational bands corresponding to Si–OH and Si–O–Si bonds, while XRD confirmed its amorphous nature with a broad diffraction peak at 2θ ≈ 22.5°. SEM imaging revealed a highly porous, sponge-like morphology composed of aggregated nanoscale particles, consistent with the nitrogen adsorption–desorption isotherm. The material exhibited a specific surface area of 68 m2/g, a maximum in the pore size distribution at a pore diameter of 2.4 nm, and a cumulative pore volume of 0.11 cm3/g for pores up to 78 nm. DLS analysis indicated an average hydrodynamic diameter of 779 nm with moderate polydispersity (PDI = 0.48), while a zeta potential of –34.10 mV confirmed good colloidal stability. Furthermore, thermogravimetric analysis (TGA) and DSC suggested the thermal stability of our amorphous silica. The adsorption performance of AS-Si was evaluated using methylene blue (MB) and ciprofloxacin (Cipro) as model pollutants. Kinetic data were best fitted by the pseudo-second-order model, while isotherm studies favored the Langmuir model, suggesting monolayer adsorption. AS-Si could be used four times for the removal of MB and Cipro. These results collectively demonstrate that AS-Si is a promising, low-cost, and sustainable adsorbent derived from Moroccan oil shale ash for the effective removal of organic contaminants from aqueous media.
- Open Access
- 23 June 2025
- Published by Elsevier in Materials Research Bulletin
- Vol. 192
Extracting High Purity Nano-silica from Oil Shale: Valorising a Neglected Natural Resource
- 23 June 2025
- Published by Elsevier in Materials Research Bulletin
- Vol. 192
Open AccessExtracting High Purity Nano-silica from Oil Shale: Valorising a Neglected Natural Resource
- Open Access
- 21 June 2025
- Published by Elsevier in Next Materials
- Vol. 8
Low-Cost Titania-Hydroxyapatite (TiHAp) nanocomposites were synthesized for removal of Methylene blue under Solar and UV irradiation
- 21 June 2025
- Published by Elsevier in Next Materials
- Vol. 8
Open AccessLow-Cost Titania-Hydroxyapatite (TiHAp) nanocomposites were synthesized for removal of Methylene blue under Solar and UV irradiation