Renata Charlene Barbosa Xavier
Research Subjects
Renata Charlene Barbosa Xavier has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
B.C. Silva
1 shared publication- Cleumar da Silva Moreira
Instituto Federal de Educação Ciência e Tecnologia da Paraíba
1 shared publication D.M. Camarano
1 shared publicationJessica Neiva Alpino
Department of Electrical Engineering, Federal Institute of Paraíba, PB
1 shared publication- Paulo Renato Perdigão Paiva
Centro Federal de Educação Tecnológica de Minas Gerais, Brazil; Instituto Nacional de Ciência e Tecnologia em Recursos Minerais, Água e Biodiversidade, Brazil
1 shared publication - Rossana Moreno Santa Cruz
Instituto Federal da Paraba (IFPB), Joo Pessoa, Brazil
1 shared publication
Latest Publications
- 24 June 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (23) , 40556-40564
Obtaining and characterization of semiconductors ceramics based on barium titanate with graphene insertion
- 24 June 2025
- Published by Elsevier in Ceramics International
- Vol. 51 (23) , 40556-40564
Obtaining and characterization of semiconductors ceramics based on barium titanate with graphene insertion
- 19 October 2022
- Published by SWGE Sistemas Ltda in Proceedings Xxii Congresso Brasileiro de Automática
- Vol. 3 (1)
An Optical Fiber-based SPR Sensor for Hepatocellular Carcinoma Detection
An optical fiber-based surface plasmon resonance sensor for hepatocellular carcinoma diagnosis is presented here. Conventional, tip-based, and D-shaped configurations are used to construct the sensor. The sensing region length, the bimetallic layer, full width at half maximum (FWHM), figure of merit (FOM), sensitivity, and signal-to-noise ratio (SNR) have been used to analyze the sensor performance. The sensor setup uses three layers: a ZBLAN fluoride optical fiber core (optical substrate), a 40 nm-gold or 40 nm-silver films (plasmonic metal), and healthy and pathological samples (analyte). Moreover, a bimetallic layer has been also investigated, where the thicknesses ranged from 10 nm to 40 nm. Also, the sensing region varied from 5 mm to 60 mm. The results obtained for the sensitivity of the simulated sensors were: 3, 903.4 nm/RIU for gold, 3, 821.5 nm/RIU for silver, and 3, 415.1 nm/RIU for silver-gold layer.
- 19 October 2022
- Published by SWGE Sistemas Ltda in Proceedings Xxii Congresso Brasileiro de Automática
- Vol. 3 (1)
An Optical Fiber-based SPR Sensor for Hepatocellular Carcinoma Detection
An optical fiber-based surface plasmon resonance sensor for hepatocellular carcinoma diagnosis is presented here. Conventional, tip-based, and D-shaped configurations are used to construct the sensor. The sensing region length, the bimetallic layer, full width at half maximum (FWHM), figure of merit (FOM), sensitivity, and signal-to-noise ratio (SNR) have been used to analyze the sensor performance. The sensor setup uses three layers: a ZBLAN fluoride optical fiber core (optical substrate), a 40 nm-gold or 40 nm-silver films (plasmonic metal), and healthy and pathological samples (analyte). Moreover, a bimetallic layer has been also investigated, where the thicknesses ranged from 10 nm to 40 nm. Also, the sensing region varied from 5 mm to 60 mm. The results obtained for the sensitivity of the simulated sensors were: 3, 903.4 nm/RIU for gold, 3, 821.5 nm/RIU for silver, and 3, 415.1 nm/RIU for silver-gold layer.