Sarah Ortbal
Research Subjects
Sarah Ortbal has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Leigh G. Terry
University of Alabama
3 shared publications - Mahlet Melaku Kebede
University of Alabama
3 shared publications - Abdullah Al Masud
Department of Civil, Construction, and Environmental Engineering, University of Alabama, Tuscaloosa, USA
2 shared publications Aaron Rak
University of Alabama
1 shared publicationMedha Kasula
Department of Chemical and Biological Engineering
1 shared publication- Mesfin Mergia Mekonnen
The University of Alabama
1 shared publication
Latest Publications
- Open Access
- 29 August 2026
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 6 (9) , 5918-5931
Statewide Assessment of TFA, PFAS, and AOF in Alabama Surface Waters: Influence of Precipitation and Wastewater Effluent
Per- and polyfluoroalkyl substances (PFAS), a diverse class of synthetic organic chemicals, are widely detected in wastewater treatment plant (WWTP) effluents and receiving surface waters. This study evaluated 40 PFAS, including trifluoroacetic acid (TFA), and adsorbable organic fluorine (AOF) in surface waters upstream and downstream of WWTPs, as well as in lakes across Alabama, United States. No significant differences were observed between upstream and downstream samples, indicating limited influence of PFAS in WWTP effluent on receiving waters relative to overall streamflow. Samples collected following precipitation ≥2.5 mm exhibited significantly lower PFOA, PFOS, and Σ39 PFAS concentrations due to contaminant dilution. In contrast, samples collected following precipitation ≥2.5 mm exhibited significantly higher TFA and AOF concentrations, highlighting precipitation-driven inputs as a source pathway. Spearman correlation was conducted to relate PFAS concentrations with anthropogenic data. TFA was frequently detected at high concentrations (mean: 773.0 ng/L). The majority of organofluorine in surface waters (96.4%) was not captured by PFAS measured using EPA Method 1633. These findings demonstrate the widespread occurrence of PFAS, including TFA, and unidentified organofluorine in Alabama surface waters and underscore the importance of integrating targeted and bulk organofluorine measurements to better characterize contaminant burdens and source pathways.
- 29 August 2026
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 6 (9) , 5918-5931
Open AccessStatewide Assessment of TFA, PFAS, and AOF in Alabama Surface Waters: Influence of Precipitation and Wastewater Effluent
Per- and polyfluoroalkyl substances (PFAS), a diverse class of synthetic organic chemicals, are widely detected in wastewater treatment plant (WWTP) effluents and receiving surface waters. This study evaluated 40 PFAS, including trifluoroacetic acid (TFA), and adsorbable organic fluorine (AOF) in surface waters upstream and downstream of WWTPs, as well as in lakes across Alabama, United States. No significant differences were observed between upstream and downstream samples, indicating limited influence of PFAS in WWTP effluent on receiving waters relative to overall streamflow. Samples collected following precipitation ≥2.5 mm exhibited significantly lower PFOA, PFOS, and Σ39 PFAS concentrations due to contaminant dilution. In contrast, samples collected following precipitation ≥2.5 mm exhibited significantly higher TFA and AOF concentrations, highlighting precipitation-driven inputs as a source pathway. Spearman correlation was conducted to relate PFAS concentrations with anthropogenic data. TFA was frequently detected at high concentrations (mean: 773.0 ng/L). The majority of organofluorine in surface waters (96.4%) was not captured by PFAS measured using EPA Method 1633. These findings demonstrate the widespread occurrence of PFAS, including TFA, and unidentified organofluorine in Alabama surface waters and underscore the importance of integrating targeted and bulk organofluorine measurements to better characterize contaminant burdens and source pathways.
- Open Access
- 3 November 2025
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 5 (11) , 6554-6566
Adsorptive Removal of PFAS from Aqueous Solutions Using GAC, PAC and Ball-Milled Colloidal Activated Carbon: Characterizing Efficiency, Kinetics, and Mechanisms
Per-and polyfluoroalkyl substances (PFAS) present significant challenges for remediation due to their persistence in nature. Activated carbon is a widely used adsorbent for removing PFAS. In this study, three forms of activated carbon, granular activated carbon (GAC), powdered activated carbon (PAC), and ball-milled colloidal activated carbon (CACBM), are compared for their effectiveness in removing short and long-chain PFAS. Physical modification through ball-milling process enhanced the adsorptive properties of activated carbon, resulting in smaller particle size (d 50 = 0.318 μm), increased surface area (968.59 m2 g–1), and improved suspension stability compared to conventional GAC and PAC. Kinetic experiments showed that CACBM demonstrated superior removal efficiencies of long-chain PFAS (up to 89% for perfluorooctanesulfonic acid (PFOS) and 73% for perfluorooctanoic acid (PFOA)), and moderate removal of short-chain PFAS (55% for perfluorobutanesulfonic acid (PFBS) and 30% for perfluorobutanoic acid (PFBA)). The pseudo-first-order model adequately described adsorption trends; however, the pseudo-second-order model provided a better fit, with intraparticle diffusion identified as the rate-limiting step. Isotherm studies indicated that PFAS adsorption aligned well with the Freundlich model. Competitive adsorption experiments revealed a hierarchical pattern. Overall, the study demonstrates CACBM as a promising adsorbent for remediation of PFAS-contaminated water systems.
- 3 November 2025
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 5 (11) , 6554-6566
Open AccessAdsorptive Removal of PFAS from Aqueous Solutions Using GAC, PAC and Ball-Milled Colloidal Activated Carbon: Characterizing Efficiency, Kinetics, and Mechanisms
Per-and polyfluoroalkyl substances (PFAS) present significant challenges for remediation due to their persistence in nature. Activated carbon is a widely used adsorbent for removing PFAS. In this study, three forms of activated carbon, granular activated carbon (GAC), powdered activated carbon (PAC), and ball-milled colloidal activated carbon (CACBM), are compared for their effectiveness in removing short and long-chain PFAS. Physical modification through ball-milling process enhanced the adsorptive properties of activated carbon, resulting in smaller particle size (d 50 = 0.318 μm), increased surface area (968.59 m2 g–1), and improved suspension stability compared to conventional GAC and PAC. Kinetic experiments showed that CACBM demonstrated superior removal efficiencies of long-chain PFAS (up to 89% for perfluorooctanesulfonic acid (PFOS) and 73% for perfluorooctanoic acid (PFOA)), and moderate removal of short-chain PFAS (55% for perfluorobutanesulfonic acid (PFBS) and 30% for perfluorobutanoic acid (PFBA)). The pseudo-first-order model adequately described adsorption trends; however, the pseudo-second-order model provided a better fit, with intraparticle diffusion identified as the rate-limiting step. Isotherm studies indicated that PFAS adsorption aligned well with the Freundlich model. Competitive adsorption experiments revealed a hierarchical pattern. Overall, the study demonstrates CACBM as a promising adsorbent for remediation of PFAS-contaminated water systems.
- 1 July 2025
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 5 (7) , 3628-3642
Evaluating Biofiltration Pretreatment and NOM-PFAS Dynamics in PFAS Removal by Nanofiltration Membranes
- 1 July 2025
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 5 (7) , 3628-3642
Evaluating Biofiltration Pretreatment and NOM-PFAS Dynamics in PFAS Removal by Nanofiltration Membranes