Percy Escalante

Waste printed circuit boards (WPCBs) are one of the fastest-growing waste streams and pose a significant environmental challenge while also representing a valuable secondary resource due to their rich metal content, particularly copper (Cu). Since effective recovery of metals requires mechanical pre-treatment and advanced characterization, WPCB boards were subjected to size reduction and then characterized through X-ray fluorescence (XRF), inductively coupled plasma optical emission spectroscopy (ICP-OES), scanning electron microscopy (SEM-EDS), and mineral liberation analysis (MLA). Results indicated that copper is predominantly found in coarser particle sizes due to its ductility, while glass fibers and ceramics dominate finer fractions. Liberation studies revealed that Cu is essentially free in fine particles (300 μm) were treated on a shaking table, achieving a Cu recovery of 95%, while fine particles (<300 μm) were processed using a multi-gravity separator (MGS), with recoveries of 94% for 100 × 300 μm and 81.5% for <100 μm size fractions. This study presents a gravity-based separation strategy that combines shaking tables and MGS to optimize Cu recovery from automotive WPCBs. To the authors’ knowledge, the MGS application for WPCBs has received little attention, despite its strong potential for separating this type of waste. The proposed methodology enhances the concentration and purity of the metallic fraction (in this case, Cu), especially in fine particles, which are challenging to work with, while reducing environmental impacts through minimal chemical use, thereby contributing to sustainable e-waste recycling.

Greece has mineral resources in which strategic elements such as nickel (Ni) and cobalt (Co) are present. In this study, characterizations of the metal concentrations of three laterite deposits, as well as minerals from a kiln originating from a mineral processing plant, were carried out. The aim of this research was to integrate technological characterization data on the quantities of cobalt (Co) and nickel (Ni) present in the lateritic profiles of three mineral deposits from Greece and in kiln dust. The study was conducted at the Mineral Processing Laboratory of UPC/Bases Manresa. Aliquots were constituted for particle-size distribution tests by wet sieving followed by laser granulometry. Scanning electron microscopy (SEM) was used to determine the mineralogical compositions. Sink–float tests were conducted to estimate the particle liberation. Mineral liberation analysis (MLA) was performed to understand the liberation and the association of minerals in the samples.