XLXinyu Li

Xinyu Li

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xinyu Li has a total of 30 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Integrated optical engine module based on a TFLN multifunctional chip for interferometric fiber-optic gyroscopes

    by Xinyu Li, Wentao Li, Anxu Huang, Qiling Zahng, Qingyuan Li, Entong Liu, Xiulei Zhang, Di Feng, Hongchen Jiao, Zhen Zhou, et al.

    This study demonstrated a photonic-chip-based integrated optical engine module for interferometric fiber-optic gyroscopes. The module was built around an x-cut thin-film lithium niobate multifunction integrated-optic chip, which enables on-chip optical power splitting and phase modulation. A broadband light source and photodetector were further integrated through co-packaging. With a compact packaged size of only 15 mm × 10 mm, the module realizes TFLN-based modular integration of a gyroscope optical front end. The constructed gyroscope demonstrated system-level angular velocity measurement capability, further verifying the feasibility of using integrated optical modules in inertial measurement systems.

  • High-symmetry low-loss hundred-nanosecond-level delay waveguide coil

    by Hong-Chen Jiao, Yang Lu, Xinyu Li, Wenxuan Pei, Wentao Li, Anxu Huang, Yongguang Huang, Qian Hong, Xiaoyuan Ren, Di Feng, et al.

    In this study, an on-chip waveguide coil (WGC) with low loss and high symmetry was proposed and developed. Fabricated on a silica-based material platform, this WGC realizes a double-layer high-symmetry structure via the vertical alignment and stacking of two chiral-symmetric Archimedean spiral waveguides. It exhibits a total length of 25.21 m with a transmission loss as low as 0.29 dB/m, and an on-chip delay of 125.98 ns has been derived. Based on this, an optical Sagnac interferometer (OSI) test system was established, which achieved a detection capability for non-reciprocal phase differences on the order of 5.1×10 −7 rad . Through comparative analysis of the bias drift of OSIs under a wide temperature range of −30°C to +60°C, it is verified that the symmetry of the WGC is improved by nearly one order of magnitude. This study provides an effective solution for enhancing the environmental adaptability of WGCs, which offer great potential as a high-performance optical delay device across Sagnac interferometry-based applications and other related optical fields.


  • Open Access

    Quasi-Isotropic Modulator Architecture based on Thin-Film Lithium Niobate

    by Xinyu Li, Hongchen Jiao, Wentao Li, Anxu Huang, Qiling Zhang, Qingyuan Li, Entong Liu, Di Feng, Xiaowei Guan, Zhen Zhou, et al.

    In this study, a quasi-isotropic modulation device operating in the C-band is fabricated and verified to address polarization-dependent mode constraints and the imbalance of electro-optic modulation efficiency in a thin-film lithium-niobate photonic platform. By integrating an adiabatic port with the functions of mode shaping and polarization rotation in the chip port, the TE0 mode can be modulated, and the TM0 mode can be converted to the TE1 mode, and then modulated and restored to TM0 for output. The results show that the conversion efficiency from TM0 to TE1 in the C-band is greater than 88%, and the difference in the modulation efficiency between the two orthogonal input polarizations is within 10%. By maintaining the same input and output polarizations, the proposed device achieves a more balanced modulation response under different polarization states, providing a reference for the optical link between polarization-multiplexing and multimode-compatible systems.

  • Research on intrinsic nonreciprocal errors in integrated optical gyroscopes based on thin-film lithium niobate chips

    by Xinyu Li, Hongchen Jiao, Wenxuan Pei, Yang Lu, Wentao Li, Anxu Huang, Qiling Zhang, Zhen Zhou, Di Feng, Lishuang Feng


  • Interferometric fiber optic gyroscope based on co-packaged optics

    by Xinyu Li, Wenxuan Pei, Yang Lu, Wentao Li, Anxu Huang, Zhifang Xu, Yuzhou Wang, Zhen Zhou, Di Feng, Xiulei Zhang, et al.


  • Multifunction Thin-Film Lithium Niobate Chip for an Interference Optical Gyroscope

    by Xinyu Li, Wenxuan Pei, Yang Lu, Wentao Li, Anxu Huang, Di Feng, Hongchen Jiao, Zhen Zhou, Hui Li, Lishuang Feng

    A thin-film lithium niobate (TFLN) chip for an interferometric optical gyroscope (IOG), which integrates various passive and active functional devices such as a coupler, polarization beam splitter, and phase modulator on the chip, is proposed in this work. The measured modulation efficiency of the chip is as high as 1.8 V·cm, the modulation nonlinear coefficient is less than 1‰, and the residual intensity modulation coefficient is approximately 2.2‰, which are all excellent in the same material and similar functional devices. Welded into the IOG system, the bias instability of the system is measured to be 0.125°/h and angular random walk is 0.0048°/√h. It is verified that the multifunction TFLN chip has the potential to replace traditional bulk devices. The test process of the chip performance is described in this work, the current state is analyzed, and the future development direction is proposed.


  • An Integrated Optic Gyroscope Based on a 12.5-m Silica Waveguide Coil

    by Yang Lu, Xinyu Li, Wenxuan Pei, Wentao Li, Anxu Huang, Di Feng, Hongchen Jiao, Zhen Zhou, Lishuang Feng

    This study presents the development of an integrated optic gyroscope (IOG) utilizing a long waveguide coil. The coil is fabricated on a quartz-based silica platform and follows an Archimedean spiral layout to ensure optimal extension. A symmetrical upper and lower cladding structure is employed to minimize optical loss. Based on this design, a waveguide coil approximately 12.5 m in length was fabricated, exhibiting a transmission loss as low as 0.54 dB/m. An IOG test system incorporating the 12.5-m waveguide coil was established, achieving a bias instability of 6.52°/h. To the best of our knowledge, this represents one of the best performances reported for optic gyroscopes based on waveguide coils. The integration of on-chip optical waveguides, in place of traditional optic fiber coils, marks a significant step toward the full integration of optic gyroscope systems.


  • Open Access

    Optimized Design and Simulation of a Compact TFLN-Based Integrated Device for Simultaneous Polarizing and Equal-Power Beam Splitting

    by Wenxuan Pei, Zhen Zhou, Xinyu Li, Yang Lu, Wentao Li, Anxu Huang, Di Feng, Hongchen Jiao, Lishuang Feng

    We present a compact thin-film lithium niobate integrated device simultaneously achieving high polarization extinction ratio and equal-power beam splitting, using two optimized oppositely-tapered graded-slope mode converters monolithically integrated with a multimode interference coupler. The converter’s geometric profile is designed through a developed analytical method that evaluates local mode conversion efficiency, enabling flexible geometry customization for diverse applications. Based on this analytical method, the performance simulations and optimization are presented. The proposed integrated device’s high extinction ratio, broad bandwidth, and fabrication tolerance show particular promise for precision optical sensing applications including fiber-optic gyroscopes.


  • Thin-film lithium niobate multi-channel multifunctional photonic integrated chip for interferometric optical gyroscope

    by Xinyu Li, Wenxuan Pei, Yang Lu, Wentao Li, Anxu Huang, Hong-Chen Jiao, Di Feng, Zhen Zhou, Li Shuang Feng

    In this study, based on a thin-film lithium niobate (TFLN) platform, a multifunctional multi-channel photonic integrated chip operating in the C-band was successfully developed. The chip size is only 1.5 cm × 0.47 cm, which integrates 23 functional devices such as a multimode interference coupler, grating coupler, mode spot converter, phase modulator, and photodetector integrated using vertical coupling. The loss in each channel of the chip is less than 17.5 dB, the polarization extinction ratio is higher than 29 dB, and the modulation efficiency of the three units is greater than 4.2 V·cm. This TFLN chip can be used to replace some fiber optic devices in multi-axis optical gyroscopes, significantly improving the compactness of photonic links and reducing cost. For application verification, the optical coupling and electrical packaging of the device were conducted, a precision test was conducted by connecting three-axis interferometric optical gyroscopes system (7200s data, 0.1 Hz sampling frequency, bias instability are 0.041°/h, 0.03°/h and 0.022°/h), and the Earth’s rotational speed was measured. This paper provides what we believe to be a new concept for the development of multifunctional photonic integrated chips for inertial sensing, demonstrating the potential of miniaturization and integration of core devices in precision measurement.