OTOlesya Tyumentseva

Olesya Tyumentseva

*This is an algorithmically generated author record based on publicly available information.

Olesya Tyumentseva has a total of 10 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Open-Air SHS Toward Boron Carbide Formation: A Comparative Study of B2O3-Al-C and B2O3-Mg-C Systems

    by Sanat Tolendiuly, Nursultan Rakhym, Kaster Kamunur, Sharafkhan Assylkhan, Aisulu Batkal, Dinara Muktaly, Olesya Tyumentseva

    A comparative compositional screening of combustion behavior and phase formation during self-propagating high-temperature synthesis in B2O3–Al–C and B2O3–Mg–C mixtures was performed under the same open-air laboratory conditions. Twelve strongly carbon-rich formulations were examined. These formulations were not intended to reproduce the target stoichiometric reactions and are interpreted as an empirical screening matrix rather than as optimized stoichiometric compositions. In the individual SHS runs, the Mg-containing formulations produced higher recorded maximum apparent local combustion front temperatures and estimated apparent average front propagation velocities than the Al-containing formulations. Because each formulation was tested only once, these observations do not establish reproducible differences between the two systems. Qualitative X-ray diffraction analysis identified Al2O3, Al20B4O36, Al4B2O9, and residual Al in the aluminothermic products. MgO, Mg2B2O5, and Mg3B2O6 were identified in the magnesiothermic products. Weak reflections attributable to B4C were observed in selected compositions, whereas oxides and metal borates were the principal crystalline phases identified in both systems. This result indicates that the carbide-forming pathway was competitively disadvantaged under the investigated open-air SHS conditions. Thermodynamic calculations for the idealized reactions showed that the relative standard driving force depended on temperature and the phase states of the reactants and products. The final phase assemblages indicate competition between carbide formation and the formation of stable oxide and borate phases. Atmospheric oxidation may also have contributed to the oxide-rich products. The results provide a descriptive comparison of the two investigated formulation sets and identify compositional patterns associated with limited B4C formation under open-air SHS conditions.

  • Open Access

    Microfluidic Pre-Concentration of Metals from Fine Flotation Tailings

    by Olesya Tyumentseva, Kaster Kamunur, Lyazzat Mussapyrova, Aisulu Batkal, Luisa Beisembayeva, Rashid Nadirov

    The large volumes of fine flotation tailings constitute a persistent challenge for the conventional treatment of minerals due to their wide particle size distribution and their low metal contents. In this work, the potential of passive inertial microfluidics for the selective redistribution of mineral particles from actual copper flotation tailings is studied. A suspension of tailings was treated in a rectangular microfluidic channel in a laminar regime, without an external magnetic field or sheath flux. The solid fractions obtained were characterized in terms of particle size distribution, phase composition and element content. The microfluidic treatment induced a systematic distribution of the particles between the output fractions. The central fraction was enriched with coarser particles, the median particle size increasing from about 15 µm in the feed to about 20 µm, and had high concentrations of Cu, Fe, Ag and Zn, with enrichment factors reaching 2.0 to 2.7 depending on the element. On the other hand, the lateral fraction was mainly composed of finer particles (D50 ≈ 13 µm) and depleted in metalliferous phases. The elemental mass balance confirmed that the observed enrichment results from selective redistribution rather than from a loss of material. These results indicate that the separation of the particles cannot be explained solely by size effects and are consistent with a preferential migration of the denser and metal-rich particles towards stable inertial focusing trajectories.


  • Open Access

    Selective Electrochemical Leaching of Copper from Fragmented Waste Printed Circuit Boards in an Alkaline Sulfate–Glycine Electrolyte

    by Olesya Tyumentseva, Kaster Kamunur, Lyazzat Mussapyrova, Aisulu Batkal, Rashid Nadirov

    Waste printed circuit boards (WPCBs) are a highly concentrated secondary source of copper. However, their complex and heterogeneous composition significantly complicates the selective extraction of metals. This study examined the feasibility of direct electrochemical leaching of copper from used PCB fragments in a sulfate–glycine alkaline electrolyte. The PCB fragments were used directly as a composite working electrode, without prior separation of the components or special surface preparation. It has been demonstrated that the electrochemical response of the composite PCB anode is similar to that of a pure copper electrode, which indicates the predominant role of the anodic dissolution of copper. A distinct potential window of 0.30 to 0.40 V relative to the Ag/AgCl electrode has been established, within which copper dissolves efficiently, while the dissolution of the associated metals (Sn, Pb, Ni, Fe) remains strongly inhibited. The maximum selectivity is reached at a potential of approximately 0.35 V. This is due to the formation of soluble and stable copper–glycine complexes, while the other metals remain in an alkaline medium in the form of poorly soluble phases. At more positive potentials (≥0.40–0.50 V), the co-dissolution of the associated metals begins, resulting in a sharp decrease in the selectivity of the process. Real-time potentiostatic experiments have shown that the selective leaching mode at 0.35 V is stable over long periods of operation and is characterized by continuous dissolution of copper with minimal release of other metals in solution.


  • Open Access

    Selective Recovery of Ce and La from Coal Ash Leachates by Stepwise pH-Controlled Precipitation

    by Kaster Kamunur, Olesya Tyumentseva, Lyazzat Mussapyrova, Aisulu Batkal, Ardak Karagulanova, Rashid Nadirov

    Coal ash represents an abundant secondary resource of rare earth elements (REEs), but their recovery is hindered by low concentrations in leachates and the presence of large amounts of competing matrix elements such as Fe, Al, Ca, and Mg. In this study, a stepwise pH-controlled precipitation approach was applied to real sulfuric acid coal ash leachates for selective recovery of Ce and La. The process combined impurity scrubbing, oxidative precipitation of Ce, and phosphate precipitation of La. Nearly complete recovery was achieved, with >95% of both Ce and La recovered and >99% phase purity. Selectivity analysis further demonstrated strong discrimination of REEs over matrix elements, with Ce showing >400 selectivity over Fe, Al, and Ca, and La showing ~170 over the same ions and ~17 over Ce. These results show the efficiency of the approach under realistic multi-element conditions.


  • Open Access

    Selective Recovery of Cobalt and Nickel from Spent Lithium-Ion Battery NMC Cathodes Using a Hydrophobic Deep Eutectic Solvent

    by Rashid Nadirov, Kaster Kamunur, Lyazzat Mussapyrova, Aisulu Batkal, Olesya Tyumentseva

    A hydrophobic deep eutectic solvent (HDES) composed of Aliquat 336, decanoic acid, and n-hexanol, diluted with kerosene, was investigated for the selective leaching of LiNi0.33Mn0.33Co0.33O2 (NMC-111) cathode materials. While conventional choline chloride-based DESs co-dissolve Li and transition metals almost completely, the present HDES–acid hybrid system deliberately sacrifices maximum recovery to achieve selectivity. In combination with a low concentration of H2SO4, the HDES enabled preferential dissolution of Co and Ni (~84% and ~80% after 6 h at 90 °C, respectively), while Li and Mn largely remained in the solid residue (>93%). Kinetic modeling indicated that the process is controlled by a surface chemical reaction with apparent activation energies of ~~49 kJ mol−1 (for Ni recovery) and ~51 kJ mol−1 (for Co recovery). The leaching residues were enriched in stable Li-Mn-O phases in a way that offers a basis for stepwise recovery. These findings show that hydrophobic eutectic media coupled with mild acid activation provide a sustainable pathway for the selective recycling of LIB cathodes.


  • Open Access

    Integrated Compositional Modeling and Machine Learning Analysis of REE-Bearing Coal Ash from a Weathered Dumpsite

    by Rashid Nadirov, Kaster Kamunur, Lyazzat Mussapyrova, Aisulu Batkal, Olesya Tyumentseva, Ardak Karagulanova

    Coal combustion residues are increasingly viewed as alternative sources of rare earth elements (REEs), but their heterogeneous composition and post-depositional alteration complicate resource evaluation. This study analyzes 50 coal ash (CA) samples collected from a weathered dumpsite near Almaty, Kazakhstan, originating from power generation using coal from the Ekibastuz Basin. A multi-method approach—comprising bulk chemical characterization, unsupervised clustering, X-ray diffraction (XRD), scanning electron microscopy (SEM), and supervised machine learning (ML)—was applied to identify consistent indicators of REE enrichment. While conventional regression models failed to predict individual REE concentrations accurately, ML algorithms consistently highlighted vanadium (V) as the most robust predictor of ΣREE across Random Forest, XGBoost, and LASSO. This suggests that V may act as a geochemical proxy for REE-bearing phases, potentially due to co-retention in amorphous or ferruginous matrices. Despite compositional similarity among many samples, XRD and SEM revealed marked variability in phase structure and crystallinity, underscoring the limitations of bulk oxide data alone. These findings demonstrate that REE behavior in ash cannot be predicted deterministically, but ML can be used to screen for informative compositional signals. The proposed workflow may support the preliminary classification and valorization of heterogeneous ash materials in secondary resource strategies.