Ning Lu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ning Lu has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Zhuoqun Wang
School of Physics, State Key Laboratory of Crystal Materials, Shandong University, Jinan, Shandong 250100, China
3 shared publications- Feng Chen
School of Physics, State Key Laboratory of Crystal Materials, Shandong University, Jinan, China
2 shared publications Yuechen Jia
School of Physics, State Key Laboratory of Crystal Materials, Shandong University, Jinan, Shandong 250100, China
2 shared publications- Yuechen Jia
School of Physics State Key Laboratory of Crystal Materials Shandong University Jinan China
2 shared publications Yufeng Zang
School of Microelectronics and Communication Engineering, Chongqing University, Chongqing 400044, China
2 shared publications- Guodong Wang
State Key Laboratory of Crystal Materials, Shandong University, Jinan, Shandong 250100, China
1 shared publication
Latest Publications
- 11 September 2026
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 14 (34) , 15808-15816
Ion-beam-induced interfacial blistering of chromium masks on lithium tantalate substrates: origins and suppression strategies
Ion-beam-induced blistering at Cr/LiTaO 3 interfaces originates from organic contaminants. Suppression is achieved by increasing Cr thickness or post-annealing, which blocks ion penetration or creates gas-venting channels, respectively.
- 11 September 2026
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry C
- Vol. 14 (34) , 15808-15816
Ion-beam-induced interfacial blistering of chromium masks on lithium tantalate substrates: origins and suppression strategies
Ion-beam-induced blistering at Cr/LiTaO 3 interfaces originates from organic contaminants. Suppression is achieved by increasing Cr thickness or post-annealing, which blocks ion penetration or creates gas-venting channels, respectively.
- 11 March 2026
- Published by Elsevier in Applied Surface Science
- Vol. 733
Mask material-driven enhancement of imaging contrast for lithium tantalate nanostructure during focused ion beam fabrication
- 11 March 2026
- Published by Elsevier in Applied Surface Science
- Vol. 733
Mask material-driven enhancement of imaging contrast for lithium tantalate nanostructure during focused ion beam fabrication
- 8 July 2025
- Published by AIP Publishing in Applied Physics Reviews
- Vol. 12 (3)
Lithium tantalate resonant metasurfaces for highly efficient ultraviolet harmonic generation
Lithium tantalate (LiTaO3, LT), structurally similar to lithium niobate, possesses a broad spectrum of optoelectronic properties that hold significant promise for integrated photonics applications. Due to its larger bandgap and higher optical damage threshold, LT can be employed for efficient nonlinear optical frequency conversion in the ultraviolet (UV) wavelength range. Here, we report on fabrication of monolithic, high-quality LT metasurfaces, composed of periodic arrays of LT truncated square pyramids, created by partially etching of a LT thin film layer using a focused ion beam milling process. These pyramidal structures introduce discrete translational symmetry, which allows for the folding of guided-mode dispersion into the first Brillouin zone, leading to the formation of guided mode resonances with Q-factors that can be easily controlled by the height of LT pyramids. The measurements show a Q-factor up to approximately 640 at 786 nm. By leveraging the strong field localization of these high-Q resonances, we demonstrate enhanced second-harmonic generation at 393 nm with an absolute conversion efficiency of 0.042%, establishing a new benchmark for the UV harmonic generation in dielectric metasurfaces. Moreover, our fabrication technique can be readily adapted to a wide range of other material platforms, opening new avenues for the development of high-quality UV metasurfaces and advanced nonlinear photonic meta-devices.
- 8 July 2025
- Published by AIP Publishing in Applied Physics Reviews
- Vol. 12 (3)
Lithium tantalate resonant metasurfaces for highly efficient ultraviolet harmonic generation
Lithium tantalate (LiTaO3, LT), structurally similar to lithium niobate, possesses a broad spectrum of optoelectronic properties that hold significant promise for integrated photonics applications. Due to its larger bandgap and higher optical damage threshold, LT can be employed for efficient nonlinear optical frequency conversion in the ultraviolet (UV) wavelength range. Here, we report on fabrication of monolithic, high-quality LT metasurfaces, composed of periodic arrays of LT truncated square pyramids, created by partially etching of a LT thin film layer using a focused ion beam milling process. These pyramidal structures introduce discrete translational symmetry, which allows for the folding of guided-mode dispersion into the first Brillouin zone, leading to the formation of guided mode resonances with Q-factors that can be easily controlled by the height of LT pyramids. The measurements show a Q-factor up to approximately 640 at 786 nm. By leveraging the strong field localization of these high-Q resonances, we demonstrate enhanced second-harmonic generation at 393 nm with an absolute conversion efficiency of 0.042%, establishing a new benchmark for the UV harmonic generation in dielectric metasurfaces. Moreover, our fabrication technique can be readily adapted to a wide range of other material platforms, opening new avenues for the development of high-quality UV metasurfaces and advanced nonlinear photonic meta-devices.
- 1 March 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (13)
Surface photosensitization enabled by embedded plasmonic nanoparticles in ferroelectric crystals for laser-induced periodic surface structures
Dielectric crystals, despite their rich optical properties and great potential in integrated optoelectronics, had generally fallen behind the competing photonic platforms, mainly due to the significant difficulties of material processing. By combining the unique capabilities of ion implantation in photosensitization and femtosecond laser direct writing (FsLDW) in nanostructuring, in this study, we propose an innovative methodology harnessing the high energy of focused femtosecond laser and the localized surface plasmon resonance (LSPR) of embedded metal nanoparticles (NPs). Such a combination leverages the ion-implantation-induced lattice damage as well as the LSPR-induced enhanced near-field enhancement and photothermal effects to relax the parameter threshold for laser-induced periodic surface structure formation in LiTaO3. To investigate the origin of such a “threshold lowering” phenomenon, ion-implantation-induced softened phonon modes and lattice distortion as well as FsLDW-induced self-assembly of NPs and ferroelectric domain inversion are both analyzed, and the synergistic action of these effects is found to be the key factor. Since both ion implantation and FsLDW feature a wide range material applicability and parameter flexibility, our work is an approach of surface multifunctionalization and nanostructuring of dielectric crystal families.
- 1 March 2025
- Published by AIP Publishing in Applied Physics Letters
- Vol. 126 (13)
Surface photosensitization enabled by embedded plasmonic nanoparticles in ferroelectric crystals for laser-induced periodic surface structures
Dielectric crystals, despite their rich optical properties and great potential in integrated optoelectronics, had generally fallen behind the competing photonic platforms, mainly due to the significant difficulties of material processing. By combining the unique capabilities of ion implantation in photosensitization and femtosecond laser direct writing (FsLDW) in nanostructuring, in this study, we propose an innovative methodology harnessing the high energy of focused femtosecond laser and the localized surface plasmon resonance (LSPR) of embedded metal nanoparticles (NPs). Such a combination leverages the ion-implantation-induced lattice damage as well as the LSPR-induced enhanced near-field enhancement and photothermal effects to relax the parameter threshold for laser-induced periodic surface structure formation in LiTaO3. To investigate the origin of such a “threshold lowering” phenomenon, ion-implantation-induced softened phonon modes and lattice distortion as well as FsLDW-induced self-assembly of NPs and ferroelectric domain inversion are both analyzed, and the synergistic action of these effects is found to be the key factor. Since both ion implantation and FsLDW feature a wide range material applicability and parameter flexibility, our work is an approach of surface multifunctionalization and nanostructuring of dielectric crystal families.